Physical alteration definition

Physical alteration means the dredging, filling, draining, or permanent inundating of a wetland. Restoring a degraded wetland by reestablishing its hydrology is not a physical alteration.
Sample 1Sample 2Sample 3
Physical alteration except as used in Part VII.M, means the dredging, filling, draining, or permanent inundating of a Wetland. Restoring a degraded Wetland by reestablishing its hydrology is not a Physical Alteration.
Sample 1Sample 2Sample 3
Physical alteration. Physical alteration refers to direct physical alterations of streams, wetlands, riparian areas and other aquatic resources. Physical alterations, both permitted and not, are extensive and typically poorly documented. Land use activities associated with agricultural practices, irrigation diversions, and transportation and other infrastructure have directly impacted the physical habitat and processes supporting streams and wetlands throughout the Service Area o Rip-rap and other streambank stabilization structures are listed as conservation concerns in the Powder River Ecotype (FWP, 2005), as well as along the Yellowstone River associated with railways. ▪ Xxxxxx (2008) found that stream bank armoring was likely degrading the quality of pallid xxxxxxxx habitat (Xxxxxx et al, 2008) ▪ BNSF Railway Company routinely impacts the Yellowstone River and its tributaries through physical impacts to the streams and rivers, primarily through installation of riprap and replacement of ballast to protect and maintain rail infrastructure. • Modifications and degradation of stream channels as a result of construction or land management are listed as conservation concerns in the Powder River Ecotype (FWP, 2005).
Sample 1

Examples of Physical alteration in a sentence

  • Physical alteration of carburetor components and/or parts and/or any alterations, machining and/or reshaping will not be permitted.

  • Physical alteration, expansion or extension of structures, expansion or increase of outdoor space, and expansion or increase of patron space are unlawful if they result in any increase in the total amount of volume, square footage, outdoor space square footage, or patron space square footage devoted to a nonconforming use.

  • Physical alteration of the network could create risk and ControlScan is not responsible for restricting access to the on premise physical environment.

  • Physical alteration of a stream, including but not limited to channelization, that interferes with the movement of fish shall be prohibited.

  • Physical alteration to the landscape of the uplands, waters, and submerged lands.

  • Physical alteration for developments in the coastal zone also result in increased production of sewage (including wastewater) and other pollutants that are ofenvironmental concerns, especially as a national monitoring program on nutrient and sediment movement along the rivers and in coastal areas are not in place.

  • To provide graduates with deep knowledge and specialization in information security.

  • For English translations of the MT, I will primarily cite the NRSV along with my own translations.

  • Physical alteration or modification of such existing extensions are also authorized without a permit, except that an increase in the length to the existing sewer extension of 1,000 feet or more shall be subject to a sewer extension permit application to the Department pursuant to 314 CMR 7.09.

  • Physical alteration of shore areas through channelization or construction of shore structure: May change volume and rate of flow or increase scouring, sedimentation.

Related to Physical alteration

  • Structural alteration means an Alteration that (i) will result in a change in the footprint of the Improvements, (ii) involves the addition of one or more floors to the Improvements, (iii) affects the structural elements or any exterior walls of the Improvements, (iv) decreases the rentable square footage of the Leased Premises other than to a de minimis extent or (v) adversely affects the proper functioning and/or capacity of the building systems in the Improvements.

  • Substantial alteration means an alteration that has a major impact on the architectural features, characteristics, appearance, or integrity of a structure or lot. The term does not include routine maintenance that is reasonably necessary to maintain a dealership facility in attractive condition and does not include any changes to items protected by federal intellectual property rights.

  • Structural Alterations means any Alterations involving the structural, mechanical, electrical, plumbing, fire/life safety or heating, ventilating and air conditioning systems of the Building.

  • Major Alteration means change other than repair or replacement of building materials or equipment with materials and equipment of a similar type.

  • Material Alteration shall have the meaning set forth in Section 4.1.11.

  • Specialty Alterations means Alterations consisting of kitchens, executive bathrooms, raised computer floors, computer installations, vaults, libraries, internal staircases, dumbwaiters, pneumatic tubes, vertical and horizontal transportation systems, and other Alterations of a similar character.

  • Installation Work means the construction and installation of the System and the Start-up, testing and acceptance (but not the operation and maintenance) thereof; all performed by or for the Power Producer at the Premises.

  • Alterations means all changes, additions, improvements or repairs to, all alterations, reconstructions, renewals, replacements or removals of and all substitutions or replacements for any of the Improvements or Equipment, both interior and exterior, structural and non-structural, and ordinary and extraordinary.

  • Installation Works means, as the context so requires,

  • Tenant Improvements Defined in Exhibit B, if any.

  • Utility Installation means carpeting, window and wall coverings, power panels, electrical distribution systems, lighting fixtures, air conditioning, plumbing, and telephone and telecommunication wiring and equipment. At the expiration of the term, Lessor may require the removal of any or all of said alterations, improvements, additions or Utility Installations, and the restoration of the Premises and the Office Building Project to their prior condition, at Lessee's expense. Should Lessor permit Lessee to make its own alterations, improvements, additions or Utility Installations, Lessee shall use only such contractor as has been expressly approved by Lessor, and Lessor may require Lessee to provide Lessor, at Lessee's sole cost and expense, a lien and completion bond in an amount equal to one and one-half times the estimated cost of such improvements, to insure Lessor against any liability for mechanic's and materialmen's liens and to insure completion of the work. Should Lessee make any alterations, improvements, additions or Utility Installations without the prior approval of Lessor, or use a contractor not expressly approved by Lessor, Lessor may, at any time during the term of this Lease, require that Lessee remove any part or all of the same.

  • Tenant Improvement Work means the construction of the Tenant Improvements, together with any related work (including demolition) that is necessary to construct the Tenant Improvements.

  • Premises Building Partial Damage shall herein mean damage or destruction to the building of which the Premises are a part to the extent that the cost of repair is less than 50% of the then replacement cost of such building as a whole.

  • Erection, construction, remodeling, repairing means all types of work done on a particular building or work at the site thereof in the construction or development of the project, including without limitation, erecting, construction, remodeling, repairing, altering, painting, and decorating, the transporting of materials and supplies to or from the building or work done by the employees of the Contractor, Subcontractor, or Agent thereof, and the manufacturing or furnishing of

  • Building, structure, facility, or installation means all of the pollutant-emitting activities which belong to the same industrial grouping, are located on one or more contiguous or adjacent properties, and are under the control of the same person (or persons under common control) except the activities of any vessel. Pollutant-emitting activities shall be considered as part of the same industrial grouping if they belong to the same major group (i.e., which have the same two-digit code) as described in the Standard Industrial Classification Manual, 1972, as amended by the 1977 Supplement (U.S. Government Printing Office stock numbers 4101-0066 and 003-005-00176-0, respectively).

  • Substantial improvement means any combination of repairs, reconstruction, rehabilitation, addition, or other improvement of a structure, taking place during any one-year period for which the cost equals or exceeds 50 percent of the market value of the structure before the “start of construction” of the improvement. This term includes structures which have incurred “substantial damage”, regardless of the actual repair work performed. The term does not, however, include either:

  • Installation Site means the site at which the Product is originally installed.

  • meter installation means the meter and, if so equipped, the instrument transformers, wiring, test links, fuses, lamps, loss of potential alarms, meters, data recorders, telecommunication equipment and spin-off data facilities installed to measure power past a meter point, provide remote access to the metered data and monitor the condition of the installed equipment;

  • Interior means the spaces, parts, components or elements of an individual dwelling unit.

  • water installation means the pipes and water fittings which are situated on any premises and ownership thereof vests in the owner thereof and used or intended to be used in connection with the use of water on such premises, and includes a pipe and water fitting situated outside the boundary of the premises, which either connects to the connection pipe relating to such premises or is otherwise laid with the permission of the municipality;

  • Utility Installations is used in this Lease to refer to all air lines, power panels, electrical distribution, security, fire protection systems, communications systems, lighting fixtures, heating, ventilating and air conditioning equipment, plumbing, and fencing in, on or about the Premises. The term "TRADE FIXTURES" shall mean Lessee's machinery and equipment which can be removed without doing material damage to the Premises. The term "ALTERATIONS" shall mean any modification of the improvements on the Premises which are provided by Lessor under the terms of this Lease, other than Utility Installations or Trade Fixtures. "LESSEE-OWNED ALTERATIONS AND/OR UTILITY INSTALLATIONS" are defined as Alterations and/or Utility Installations made by Lessee that are not yet owned by Lessor pursuant to Paragraph 7.4(a). Lessee shall not make nor cause to be made any Alterations or Utility Installations in, on, under or about the Premises without Lessor's prior written consent. Lessee may, however, make non-structural Utility Installations to the interior of the Premises (excluding the roof) without Lessor's consent but upon notice to Lessor, so long as they are not visible from the outside of the Premises, do not involve puncturing, relocating or removing the roof or any existing walls, or changing or interfering with the fire sprinkler or fire detection systems and the cumulative cost thereof during the term of this Lease as extended does not exceed $2,500.00.

  • Tenant Work All work installed or furnished to the Premises by Tenant in connection with Tenant’s initial occupancy pursuant to Rider 2 and the Workletter.

  • Home improvement means the remodeling, altering,

  • Tenant Improvement Allowance in the maximum amount of $200.00 per rentable square foot in the Premises, which is included in the Base Rent set forth in the Lease; and

  • Capital Improvement or "Capital Improvement Project" means the acquisition, construction, reconstruction, improvement, planning and equipping of roads and bridges, wastewater treatment facilities, water supply systems, solid waste disposal facilities, and storm water and sanitary collection, storage and treatment facilities of Local Subdivisions, including real property, interests in real property, and facilities and equipment of Local Subdivisions related or incidental thereto.

  • demolition work means a method to dismantle, wreck, break, pull down or knock down of a structure or part thereof by way of manual labour, machinery, or the use of explosives;