Opening pressure definition

Opening pressure means the pressure referred to in a list of substances at which the high velocity vent valves open. For pressure tanks the opening pressure of the safety valve shall be established in accordance with the requirements of the competent authority or a recognized classification society;
Sample 1Sample 2
Opening pressure kPa3 or characteristic diagram:2, 3
Sample 1
Opening pressure kPa3 or characteristic diagram2, 3: 3.1.2.4. Governor 3.1.2.4.1. Make(s):............................................................................................................... 3.1.2.4.2. Type(s):................................................................................................................ 3.1.2.4.3. Speed at which cut-off starts under full load:............................................. min-1 3.1.2.4.4. Maximum no-load speed:............................................................................ min-1 3.1.2.4.5. Idling speed: ................................................................................................ min-1 3.1.3. Cold start system
Sample 1

Examples of Opening pressure in a sentence

  • Opening pressure shall be 0.5 psig; full opening pressure shall be 2.5 psig.

  • Opening pressure: Exterior doors 8.5 lb., interior doors 5 lb., labeled fire doors 15 lb.

  • Injector(s)3.1.2.3.1. Make(s): ................................................................................................................3.1.2.3.2. Type(s): .................................................................................................................3.1.2.3.3. "Opening pressure": kPa 3/or characteristic diagram 2/ 3/: .............................................................................

  • Opening pressure If the gas flow is steady as 1.0 L/min when the exhaust valve is in any direction, the opening pressure should not exceed 1 kPa.

  • Opening pressure of the high-velocity pressure relief devices/ /safety valves:1, 2 30 kPa 8.

  • Opening pressure: Exterior doors 8.5 lb., interior doors 5 lb., labeled fire doors 15 lb, per CBC 1133B.2.5.

  • Opening pressure: Exterior doors 5 lb., interior doors 5 lb., fire doors 15 lb.

  • Opening pressure of high-velocity vent valves/safety valves ………..

  • Injector(s)3.2.6.2.1. Make(s): ................................................................................................................3.2.6.2.2. Type(s): .................................................................................................................3.2.6.2.3. Opening pressure or characteristic diagram 3/: ....................................................3.2.6.2.4. Certification number:............................................................................................

  • All painting material shall bring to the site of work in the original sealed containers.

Related to Opening pressure

  • Operating pressure means the pressure at which the parts of an irrigation system are designed by the manufacturer to operate.

  • Working pressure means the settled pressure of a compressed gas at a reference temperature of 15 °C in a full pressure receptacle;

  • Reid vapor pressure means the vapor pressure of crude oil or other volatile petroleum products at 100 degrees Fahrenheit as determined by the latest edition of ASTM D6377 (RVPE): Standard Test Method for Determination of Vapor Pressure of Crude Oil.

  • Backpressure means a pressure (caused by a pump, elevated tank or piping, boiler, or other means) on the consumer's side of the service connection that is greater than the pressure provided by the public water system and which may cause backflow.

  • Pressure means the total load or force per unit area acting on a surface.

  • True vapor pressure means the equilibrium partial pressure exerted by a petroleum liquid as determined in accordance with methods described in American Petroleum Institute (API) Bulletin 2517, Evaporation Loss from External Floating Roof Tanks, 1980. The API procedure may not be applicable to some high viscosity or high pour crudes. Available estimates of true vapor pressure may be used in special cases such as these.

  • Grab sample means an individual sample collected in less than 15 minutes in conjunction with an instantaneous flow measurement.

  • Engine degreaser means a cleaning product designed to remove grease, grime, oil and other contaminants from the external surfaces of engines and other mechanical parts.

  • Receipt Point means the receipt/inception point(s) where Crude Oil is received into the Gathering System, as such points are specified in Section II of this tariff.

  • Design pressure means the hydrostatic pressure for which each structure or appliance assumed watertight in the intact and damage stability calculations is designed to withstand.

  • Loading Port means the port of Port Hedland or if iron ore is not shipped, or is not shipped from that port, then such port (which may include the port of Port Hedland) as the Minister may determine for the purpose of this definition;

  • Loading Zone means a parking stall which is set aside for use by commercial vehicles if there is a sign referable to that stall marked ‘Loading Zone’;

  • Intake means “Sanctioned Intake”.

  • Outdoor cultivation means the cultivation of mature cannabis without the use of artificial lighting or light deprivation in the canopy area at any point in time. Artificial lighting is permissible only to maintain immature plants outside the canopy area.

  • INTER-CONNECTION POINT/ DELIVERY/ METERING POINT means a single point at 220kV or above, where the power from the Project(s) is injected into the identified ISTS Substation (including the dedicated transmission line connecting the Projects with the substation system) as specified in the RfS document. Metering shall be done at this interconnection point where the power is injected into. For interconnection with grid and metering, the WPDs shall abide by the relevant CERC/ SERC Regulations, Grid Code and Central Electricity Authority (Installation and Operation of Meters) Regulations, 2006 as amended and revised from time to time.

  • Sewage sludge weight means the weight of sewage sludge, in dry U.S. tons, including admixtures such as liming materials or bulking agents. Monitoring frequencies for sewage sludge parameters are based on the reported sludge weight generated in a calendar year (use the most recent calendar year data when the NPDES permit is up for renewal).

  • Diatomaceous earth filtration means a process resulting in substantial particulate removal in which a precoat cake of diatomaceous earth filter media is deposited on a support membrane (septum), and while the water is filtered by passing through the cake on the septum, additional filter media known as body feed is continuously added to the feed water to maintain the permeability of the filter cake.

  • Slug loading means any pollutant, including oxygen demanding pollutants, released in a discharge at a flow rate and/or pollutant concentration as to cause interference in the POTW.

  • Built-Up Area and/or “Covered Area” in relation to a Flat shall mean the floor area of that Flat including the area of balconies and terraces, if any attached thereto, and also the thickness of the walls (external or internal) and the columns and pillars therein Provided That if any wall, column or pillar be common between two Flats, then one-half of the area under such wall column or pillar shall be included in the built-up area of each such Flat.

  • CO2 means carbon dioxide.

  • Monitoring well means a water well intended for the purpose of determining groundwater quality or quantity.

  • Cultivation site means a location where cannabis is planted, grown, harvested, dried, cured, graded, or trimmed, or a location where any combination of those activities occurs.