New Hampshire Specific Data Security Requirements Sample Clauses

New Hampshire Specific Data Security Requirements. The Provider agrees to the following privacy and security standards from “the Minimum Standards for Privacy and Security of Student and Employee Data” from the New Hampshire Department of Education. Specifically, the Provider agrees to:
Sample 1Sample 2Sample 3See All (362)
AutoNDA by SimpleDocs
New Hampshire Specific Data Security Requirements. The Provider agrees to continue to adopt technologies, safeguards and practices in alignment with the NIST Cybersecurity Framework (NIST SP 800-53 rev 4 or newer, Low Impact Baseline or higher). The Provider’s NIST “Current Profile” is available upon request.
Sample 1
New Hampshire Specific Data Security Requirements. The Provider agrees to the privacy and security standards from “the Minimum Standards for Privacy and Security of Student and Employee Data” from the New Hampshire Department of Education as set forth in the “iCivics compliance notes” column of the table set forth on Exhibit “F.” The LEA hereby acknowledges and agrees that the Provider’s performance of the measures in the “iCivics compliance notes” column of the table set forth on Exhibit “F” constitutes full performance of the Provider’s obligations under this Article V, Section 1(k) and Exhibit “F.”
Sample 1
New Hampshire Specific Data Security Requirements. The Provider agrees to the following privacy and security standards from “the Minimum Standards for Privacy and Security of Student and Employee Data” from the New Hampshire Department of Education. Specifically, the Provider agrees to adhere to (1) through (6), (9), (19)-(20) and to comply with (7)-(8) and (10)-(18) and (21)-(23) if the Provider is hosting the LEA through an ASP agreement. The Provider agrees to notify the LEA in writing before executing this DPA on whether it is hosting the LEA:
Sample 1
New Hampshire Specific Data Security Requirements. The Provider agrees to the Education. Specifically, the Provider agrees to:
Sample 1

Related to New Hampshire Specific Data Security Requirements

  • Data Security Requirements Without limiting Contractor’s obligation of confidentiality as further described in this Contract, Contractor must establish, maintain, and enforce a data privacy program and an information and cyber security program, including safety, physical, and technical security and resiliency policies and procedures, that comply with the requirements set forth in this Contract and, to the extent such programs are consistent with and not less protective than the requirements set forth in this Contract and are at least equal to applicable best industry practices and standards (NIST 800-53). Contractor also shall provide technical and organizational safeguards against accidental, unlawful, or unauthorized access or use, destruction, loss, alteration, disclosure, transfer, commingling, or processing of such information that ensure a level of security appropriate to the risks presented by the processing of County Data, Contractor personnel and/or subcontractor personnel and affiliates approved by County to perform work under this Contract may use or disclose County personal and confidential information only as permitted in this Contract. Any other use or disclosure requires express approval in writing by the County of Orange. No Contractor personnel and/or subcontractor personnel or affiliate shall duplicate, disseminate, market, sell, or disclose County personal and confidential information except as allowed in this Contract. Contractor personnel and/or subcontractor personnel or affiliate who access, disclose, market, sell, or use County personal and confidential information in a manner or for a purpose not authorized by this Contract may be subject to civil and criminal sanctions contained in applicable federal and state statutes. Contractor shall take all reasonable measures to secure and defend all locations, equipment, systems, and other materials and facilities employed in connection with the Services against hackers and others who may seek, without authorization, to disrupt, damage, modify, access, or otherwise use Contractor systems or the information found therein; and prevent County data from being commingled with or contaminated by the data of other customers or their users of the Services and unauthorized access to any of County data. Contractor shall also continuously monitor its systems for potential areas where security could be breached. In no case shall the safeguards of Contractor’s data privacy and information and cyber security program be less stringent than the safeguards used by County. Without limiting any other audit rights of County, County shall have the right to review Contractor’s data privacy and information and cyber security program prior to commencement of Services and from time to time during the term of this Contract. All data belongs to the County and shall be destroyed or returned at the end of the contract via digital wiping, degaussing, or physical shredding as directed by County.

  • Federal Medicaid System Security Requirements Compliance Party shall provide a security plan, risk assessment, and security controls review document within three months of the start date of this Agreement (and update it annually thereafter) in order to support audit compliance with 45 CFR 95.621 subpart F, ADP System Security Requirements and Review Process.

  • CHILD AND DEPENDENT ADULT/ELDER ABUSE REPORTING CONTRACTOR shall establish a procedure acceptable to ADMINISTRATOR to ensure that all employees, agents, subcontractors, and all other individuals performing services under this Agreement report child abuse or neglect to one of the agencies specified in Penal Code Section 11165.9 and dependent adult or elder abuse as defined in Section 15610.07 of the WIC to one of the agencies specified in WIC Section 15630. CONTRACTOR shall require such employees, agents, subcontractors, and all other individuals performing services under this Agreement to sign a statement acknowledging the child abuse reporting requirements set forth in Sections 11166 and 11166.05 of the Penal Code and the dependent adult and elder abuse reporting requirements, as set forth in Section 15630 of the WIC, and shall comply with the provisions of these code sections, as they now exist or as they may hereafter be amended.

  • EDD Independent Subrecipient Reporting Requirements Effective January 1, 2001, the County of Orange is required to file in accordance with subdivision (a) of Section 6041A of the Internal Revenue Code for services received from a “service provider” to whom the County pays $600 or more or with whom the County enters into a contract for $600 or more within a single calendar year. The purpose of this reporting requirement is to increase child support collection by helping to locate parents who are delinquent in their child support obligations. The term “service provider” is defined in California Unemployment Insurance Code Section 1088.8, Subparagraph B.2 as “an individual who is not an employee of the service recipient for California purposes and who received compensation or executes a contract for services performed for that service recipient within or without the State.” The term is further defined by the California Employment Development Department to refer specifically to independent Subrecipients. An independent Subrecipient is defined as “an individual who is not an employee of the ... government entity for California purposes and who receives compensation or executes a contract for services performed for that ... government entity either in or outside of California.” The reporting requirement does not apply to corporations, general partnerships, limited liability partnerships, and limited liability companies. Additional information on this reporting requirement can be found at the California Employment Development Department web site located at xxxx://xxx.xxx.xx.xxx/Employer_Services.htm

  • ECR Number Environmental Commitment Record Requirements Description of ADOT Responsibilities TMP-3 The following measures will be implemented for the Selected Alternative: • All equipment exhaust systems will be in good working order. Properly designed engine enclosures and intake silencers will be used. • Equipment will be maintained on a regular basis. New equipment will be subject to new product emission standards. • Stationary equipment will be located as far away from sensitive receivers as possible. • Construction-related noise generators will be shielded from noise receivers (e.g., use temporary enclosures to shield generators or crushers, take advantage of site conditions to provide topographic separation). • Construction alerts will be distributed to keep the public informed of construction activities, and a toll-free number for construction-related complaints will be provided. • During the design phase, hours of operation will be evaluated to minimize disruptions during construction. ADOT to oversee for compliance TMP-4 Congestion from construction-related traffic will create temporary impacts in the project vicinity. The magnitude of these impacts will vary depending on the location of the sources of the fill material and of the disposition sites for surplus material, the land uses along the routes, the duration of hauling operations, staging locations, and the construction phasing. To identify acceptable routes and times of operation, ADOT, or its representative, will prepare an agreement with local agencies regarding hauling of construction materials on public streets. ADOT to oversee for compliance TP Attachment 000-0 Xxxxx Xxxxxxxx Xxxxxxx Project Record of Decision (ROD) Developer’s Environmental Commitment Requirements The following table includes the Project-specific environmental commitments as written in the ROD, with minor modifications for clarification purposes. As it relates to these Technical Provisions, references to freeway, project, South Mountain Freeway, proposed action, proposed freeway, and Selected Alternative mean the Project, and references to contractor mean Developer. Developer shall comply with and perform all of the contractor and ADOT requirements, including the ADOT obligations, commitments, and responsibilities, identified in the following table, except to the extent of those requirements that are specifically identified in the third column, entitled “Description of ADOT Responsibilities,” which are not delegated to Developer.

  • CERTIFICATION PROHIBITING DISCRIMINATION AGAINST FIREARM AND AMMUNITION INDUSTRIES (Texas law as of September 1, 2021) By submitting a proposal to this Solicitation, you certify that you agree, when it is applicable, to the following required by Texas law as of September 1, 2021: If (a) company is not a sole proprietorship; (b) company has at least ten (10) full-time employees; (c) this contract has a value of at least $100,000 that is paid wholly or partly from public funds; (d) the contract is not excepted under Tex. Gov’t Code § 2274.003 of SB 19 (87th leg.); and (e) governmental entity has determined that company is not a sole-source provider or governmental entity has not received any bids from a company that is able to provide this written verification, the following certification shall apply; otherwise, this certification is not required. Pursuant to Tex. Gov’t Code Ch. 2274 of SB 19 (87th session), the company hereby certifies and verifies that the company, or association, corporation, partnership, joint venture, limited partnership, limited liability partnership, or limited liability company, including a wholly owned subsidiary, majority-owned subsidiary parent company, or affiliate of these entities or associations, that exists to make a profit, does not have a practice, policy, guidance, or directive that discriminates against a firearm entity or firearm trade association and will not discriminate during the term of this contract against a firearm entity or firearm trade association. For purposes of this contract, “discriminate against a firearm entity or firearm trade association” shall mean, with respect to the entity or association, to: “(1) refuse to engage in the trade of any goods or services with the entity or association based solely on its status as a firearm entity or firearm trade association; (2) refrain from continuing an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association; or (3) terminate an existing business relationship with the entity or association based solely on its status as a firearm entity or firearm trade association. See Tex. Gov’t Code § 2274.001(3) of SB 19. “Discrimination against a firearm entity or firearm trade association” does not include: “(1) the established policies of a merchant, retail seller, or platform that restrict or prohibit the listing or selling of ammunition, firearms, or firearm accessories; and (2) a company’s refusal to engage in the trade of any goods or services, decision to refrain from continuing an existing business relationship, or decision to terminate an existing business relationship to comply with federal, state, or local law, policy, or regulations or a directive by a regulatory agency, or for any traditional business reason that is specific to the customer or potential customer and not based solely on an entity’s or association’s status as a firearm entity or firearm trade association.” See Tex. Gov’t Code § 2274.001(3) of SB 19.

Time is Money Join Law Insider Premium to draft better contracts faster.