Maximum torque definition

Maximum torque means the highest value of the net torque measured at full engine load.
Maximum torque speed" means the engine speed at which the maximum torque is obtained from the engine, as specified by the manufacturer;
Maximum torque means the maximum torque value measured under full engine load;

Examples of Maximum torque in a sentence

  • When high speed operation exceeds the nominal speed of the motor, the following points should be checked:– Maximum torque of the motor– Bearing construction– Lubrication– Balancing– Critical speeds– Shaft seals – Ventilation– Fan noiseGuideline values of maximum speeds for M3AA motors within the General purpose motor range are described in figure 1 below.

  • Torque Laminating Max : Maximum torque of motor while laminating.

  • Conformity of the ECU torque-signal The "Maximum torque" method specified in Appendix 4 to Annex 8 shall be understood as demonstrating that a point between the reference maximum torque curves obtained at a certain engine speed when testing with the 2 applicable reference fuels has been reached during vehicle testing.

  • When high speed operation exceeds the nominal speed of the motor, the following points should be checked:– Maximum torque of the motor– Bearing construction– Lubrication– Balancing– Critical speeds– Shaft seals– Ventilation– Fan noise Guideline values of maximum speeds for M3AA motors within the General purpose motor range are described in figure 1 below.

  • M12 ▼B ▼M12 ▼B 4.4. Clutch(es) 4.4.1. Maximum torque conversion: .

  • Maximum torque value over the full range of travel shall not be more than 30% of the lowest torque value.

  • The successor list changes only when Canal nodes join or leave the DHT ring.

  • Maximum torque conversion:............................................................................

  • Maximum torque speed ...............................................................................................

  • Other operating curves such as inverse, very inverse shall be selectableAdjustable setting range of 50-200 % and 20-80% of rated current for over current and earth fault relays respectively.The directional relays shall have a Maximum torque angle of 45° current leading for directional over current unit & 30 lag for directional earth fault.

Related to Maximum torque

  • Maximum mass means the maximum mass stated by the vehicle manufacturer to be technically permissible (this mass may be higher than the "permissible maximum mass" laid down by the national administration).

  • Maximum Daily Limit means the maximum allowable "Daily Concentration" (defined above) when expressed as a concentration (e.g. mg/l), otherwise, it means the maximum allowable "Daily Quantity" as defined above, unless it is expressed as a flow quantity. If expressed as a flow quantity it means "Maximum Daily Flow" as defined in Section 22a-430-3(a) of the RCSA.

  • Maximum Daily Quantity means the daily volume of Gas or Liquids, expressed in 103m3, identified in a Shipper's Interruptible Transportation Service Agreement that Transporter agrees to receive from Shipper under Toll Schedule Interruptible Full Path Service, Toll Schedule Interruptible Receipt Service or Toll Schedule Interruptible Delivery Service, as applicable.

  • Maximum design heat input means the ability of a unit to combust a stated maximum amount of fuel per hour on a steady state basis, as determined by the physical design and physical characteristics of the unit.

  • Maximum Term Loan Amount means Forty Million and No/100 Dollars ($40,000,000).

  • Maximum Face Amount means, with respect to any outstanding Letter of Credit, the face amount of such Letter of Credit including all automatic increases provided for in such Letter of Credit, whether or not any such automatic increase has become effective.

  • Maximum Limit means that number of issued Shares representing 10% of the total number of issued Shares as at the date of the passing of this Resolution (excluding any Shares which are held as treasury shares as at that date); and

  • Daily Maximum Limit means the maximum allowable discharge of a pollutant during a calendar day. Expressed as units of mass, the daily discharge is cumulative mass discharged over the course of the day. Expressed as a concentration, it is the arithmetic average of all measurements taken that day.

  • Total maximum daily load or "TMDL" means the sum of the individual wasteload allocations for point sources, load allocations (LAs) for nonpoint sources, natural background loading and a margin of safety. TMDLs can be expressed in terms of either mass per time, toxicity, or other appropriate measure. The TMDL process provides for point versus nonpoint source trade-offs.

  • Maximum allowable cost list means a list of drugs for

  • Exceedance means a condition that is detected by monitoring that provides data in terms of an emission limitation or standard and that indicates that emissions (or opacity) are greater than the applicable emission limitation or standard (or less than the applicable standard in the case of a percent reduction requirement) consistent with any averaging period specified for averaging the results of the monitoring.

  • Bag limit means the maximum number of game animals, game

  • Sewage sludge fee weight means the weight of sewage sludge, in dry U.S. tons, excluding admixtures such as liming materials or bulking agents. Annual sewage sludge fees, as per section 3745.11(Y) of the Ohio Revised Code, are based on the reported sludge fee weight for the most recent calendar year.

  • Maximum Program Amount means Common Shares with an aggregate Sales Price of the lesser of (a) the number or dollar amount of Common Shares registered under the effective Registration Statement (defined below) pursuant to which the offering is being made, (b) the number of authorized but unissued Common Shares (less Common Shares issuable upon exercise, conversion or exchange of any outstanding securities of the Company or otherwise reserved from the Company’s authorized capital stock), (c) the number or dollar amount of Common Shares permitted to be sold under Form S-3 (including General Instruction I.B.6 thereof, if applicable), or (d) the number or dollar amount of Common Shares for which the Company has filed a Prospectus (defined below).