Layer 1 definition

Layer 1 means mature trees at least 12.5 centimetres in diameter at breast height;
Layer 1 means the first layer of the seven-layer OSI model of computer networking;
Layer 1 means mature trees greater than 12.5 centimeters in diameter at breast height;

Examples of Layer 1 in a sentence

  • Layer 1 test equipment 6.1.9. Network Optimization Support for Core Routing & SwitchingThis section provides requirements for a product based engineering service to be supported.

  • If a UE fails to access the channel(s) prior to an intended UL transmission to a gNB, Layer 1 notifies higher layers about the channel access failure.

  • The requested service shall allow the following Network Protocols: • All TCP/IP protocols • All Layer 1 and Layer 2 protocols, minimum Layer 3 protocols (EIGRP, IGMP, IPSec, OSPF, & RIP).

  • Layer #1 is amortized over the remainder of the 25-year closed period that was originally established in 2014.

  • If a UE fails to access the channel(s) prior to an UL transmission intended to a gNB, Layer 1 notifies higher layers about the channel access failure.

  • Layer 1 may notify higher layers to suspend the corresponding power ramping counter when PRACH transmission in any of PRACH occasions are dropped or with reduced transmit power.

  • In addition, in 38.213, we have the following description: Prior to initiation of the physical random access procedure, Layer 1 receives from higher layers a set of SS/PBCH block indexes and provides to higher layers a corresponding set of RSRP measurements.

  • Layer 1 notifies higher layers to suspend the corresponding power ramping counter when PRACH transmission in at least one PRACH occasion is dropped.

  • Therefore, we cansuppose that neither Frenkel and Schottky defects are likely toAl(a) O( ) O( E = 23.3 eV) (19)occur in YAG.

  • Layer 1 may notify higher layers to suspend the corresponding power ramping counter when PRACH transmission on part of PRACH occasions are dropped or when PRACH transmission in any of PRACH occasions is with reduced transmit power.


More Definitions of Layer 1

Layer 1 means mature trees greater than 12.5 centimetres in diameter at breast height;

Related to Layer 1

  • Loop Concentrator/Multiplexer or "LCM" is the Network Element that does one or more of the following: aggregates lower bit rate or bandwidth signals to higher bit rate or bandwidth signals (multiplexing); disaggregates higher bit rate or bandwidth signals to lower bit rate or bandwidth signals (demultiplexing); aggregates a specified number of signals or channels to fewer channels (concentrating); performs signal conversion, including encoding of signals (e.g., analog to digital and digital to analog signal conversion); or in some instances performs electrical to optical (E/O) conversion. LCM includes DLC, and D4 channel banks and may be located in Remote Terminals or Central Offices.

  • Module means specific portion of the Application Software designated as such in the Documentation made available to the Customer under the Notification Form.

  • Plasma arc incinerator means any enclosed device using a high intensity electrical discharge or arc as a source of heat followed by an afterburner using controlled flame combustion and which is not listed as an industrial furnace.

  • Dataset means the data specified in Appendix 1 (Environmental Information) to Schedule 11.2 (Management Information) as the same may be amended from time to time by the Secretary of State (acting reasonably);

  • Process weight means the total weight of all materials introduced into any source operation. Solid fuels charged will be considered as part of the process weight, but liquid and gaseous fuels and combustion air will not.

  • Open type traction battery means a type of battery requiring filling with liquid and generating hydrogen gas that is released to the atmosphere.

  • Instantaneous flow measurement means the flow measured during the minimum time required for the flow-measuring device or method to produce a result in that instance. To the extent practical, instantaneous flow measurements coincide with the collection of any grab samples required for the same sampling period so that together the samples and flow are representative of the discharge during that sampling period.

  • Substrate means the surface onto which a coating is applied or into which a coating is impregnated.

  • Excess Concentration means the sum of the following amounts, without duplication:

  • Packet Switch is a router designed to read the destination address in an incoming cell or packet, consult a routing table and route the packet toward its destination. Packetizing is done in originating CPE and reassembly is done in terminating CPE. Multiple packet formats or protocols exist (e.g., x.25, x.75, frame relay, ATM, and IP).

  • SPID is the number that identifies a service provider to the relevant NPAC. The SPID may be a state-specific number. "Serving Wire Center" denotes the CenturyLink building from which dial tone for local Exchange Service would normally be provided to a particular End User Customer premises. "Signaling System 7" or "SS7" is an out-of-band signaling protocol consisting of four basic sub- protocols:

  • User ID means the unique identifier that is assigned by the Company to each Authorized User and to each automated trading system employed by a Participant or Authorized Trader and, in the case of such an automated trading system, linked to the User ID that is assigned to a single Authorized User.

  • Diameter at breast height (dbh) means the diameter of a tree at 4 1/2 feet above the ground measured from the uphill side.

  • Backpressure means a pressure (caused by a pump, elevated tank or piping, boiler, or other means) on the consumer's side of the service connection that is greater than the pressure provided by the public water system and which may cause backflow.

  • Stack means any point in a source designed to emit solids, liquids, or gases into the air, including a pipe or duct but not including flares.

  • Source-image receptor distance means the distance from the source to the center of the input surface of the image receptor.

  • Chip means an integrated circuit embedded in the Card.

  • Switched Access Detail Usage Data means a category 1101xx record as defined in the EMI iconectiv Practice BR 010-200-010.

  • multiple sclerosis means an inflammatory, nervous system disease in which the myelin sheaths around the axons of nerve cells of the brain and spinal cord are damaged, leading to demyelination and affecting the ability of nerve cells in the brain and spinal cord to communicate with each other;

  • COVID-19 symptoms means fever of 100.4 degrees Fahrenheit or higher, chills, cough, shortness of breath or difficulty breathing, fatigue, muscle or body aches, headache, new loss of taste or smell, sore throat, congestion or runny nose, nausea or vomiting, or diarrhea, unless a licensed health care professional determines the person’s symptoms were caused by a known condition other than COVID-19.

  • Background concentration means such concentration of that substance as is present in:

  • Dialing Parity means as defined in the Act. As used in this Agreement, Dialing Parity refers to both Local Dialing Parity and Toll Dialing Parity.

  • Access Tandem Switch is a Switch used to connect End Office Switches to interexchange Carrier Switches. Qwest's Access Tandem Switches are also used to connect and switch traffic between and among Central Office Switches within the same LATA and may be used for the exchange of local traffic.

  • Combined sewer overflow means the discharge of untreated or

  • MVA means Megavolt Ampere.

  • Pneumatic tire means every tire in which compressed air is designed to support the load.