Ground installed definition

Ground installed means the installation of a commercial
Sample 1Sample 2Sample 3
Ground installed means the installation of a commercial solar energy system, with the primary purpose of solar energy
Sample 1
Ground installed means the installation of a commercial solar energy system, with the primary purpose of solar energy generation for wholesale or retail sale, on a parcel or tract of land.
Sample 1

Examples of Ground installed in a sentence

  • Removing 10 metres’ depth of contaminated stone and disposing of as in the paragraph above; replacement Fire Training Ground installed.

  • The bond may be established using a suitable Temporary Protective Ground installed directly between the conductor(s) or device(s) and the platform as soon as practicable after positioning, and should remain in place as long as work is being performed.

  • Ground installed equipment according to Section 27 05 26, GROUNDING AND BONDING FOR COMMUNICATIONS SYSTEMS.

  • Ground installed flagpoles 15’ or less in height with a flag no larger than 4’ x 6’.A maximum of 1 flag on the front side and 1 flag on the rear side of a Dwelling will be allowed.Flags that become faded, torn or otherwise deteriorated must be removed or replaced with a new flag.Only official flags of the United States of American and the State of North Carolina are approved for display at Padgett Place.

  • Consequently, there are loop holes in the legislation to allow for development on Natura 2000 sites.

  • Residents asked if it was possible to have some play equipment at the Recreation Ground installed for younger children.

  • Ground installed satellite antennas must be located on the property in a manner which complies with the building setbacks for houses and must be located on the property so the antenna is not visually offensive to adjoining property owners.

  • Hylozoic Ground, installed within the Canadian pavilion at the 2010 Venice Biennale for Architecture, was organized by a hyperbolic waffle structure that could be pulled and pushed into continuous doubly-curved shell surfaces.

Related to Ground installed

  • Standard Installation means the installation of drop cable to a customer’s premise where the distance from the point of entry into the building being served is less than 150 feet from the active cable television system plant.

  • Permitted Installation means the activities and the limits to those activities described in Table 1.1.1 of this Permit.

  • Type 3 Installation means any Technical Installation upon which none of the SW, or only a portion of the SW, deployed is licensed for Use with such TPD, and therefore a TPD is not deployed or running.

  • Type 2 Installation means any Technical Installation upon which all SW deployed is licensed for Use with, but is not running on, such TPD; and,

  • Type 1 Installation means any Technical Installation upon which all SW deployed is licensed for Use with, and is running on, such TPD;

  • Existing installation means an installation, construction of which began prior to the effective date of any regulation having application to it.

  • Utility Installations is used in this Lease to refer to all air lines, power panels, electrical distribution, security, fire protection systems, communications systems, lighting fixtures, heating, ventilating and air conditioning equipment, plumbing, and fencing in, on or about the Premises. The term "TRADE FIXTURES" shall mean Lessee's machinery and equipment which can be removed without doing material damage to the Premises. The term "ALTERATIONS" shall mean any modification of the improvements on the Premises which are provided by Lessor under the terms of this Lease, other than Utility Installations or Trade Fixtures. "LESSEE-OWNED ALTERATIONS AND/OR UTILITY INSTALLATIONS" are defined as Alterations and/or Utility Installations made by Lessee that are not yet owned by Lessor pursuant to Paragraph 7.4(a). Lessee shall not make nor cause to be made any Alterations or Utility Installations in, on, under or about the Premises without Lessor's prior written consent. Lessee may, however, make non-structural Utility Installations to the interior of the Premises (excluding the roof) without Lessor's consent but upon notice to Lessor, so long as they are not visible from the outside of the Premises, do not involve puncturing, relocating or removing the roof or any existing walls, or changing or interfering with the fire sprinkler or fire detection systems and the cumulative cost thereof during the term of this Lease as extended does not exceed $2,500.00.

  • New installation means an installation, construction of which began after the effective date of any regulation having application to it.

  • Utility Installation means carpeting, window and wall coverings, power panels, electrical distribution systems, lighting fixtures, air conditioning, plumbing, and telephone and telecommunication wiring and equipment. At the expiration of the term, Lessor may require the removal of any or all of said alterations, improvements, additions or Utility Installations, and the restoration of the Premises and the Office Building Project to their prior condition, at Lessee's expense. Should Lessor permit Lessee to make its own alterations, improvements, additions or Utility Installations, Lessee shall use only such contractor as has been expressly approved by Lessor, and Lessor may require Lessee to provide Lessor, at Lessee's sole cost and expense, a lien and completion bond in an amount equal to one and one-half times the estimated cost of such improvements, to insure Lessor against any liability for mechanic's and materialmen's liens and to insure completion of the work. Should Lessee make any alterations, improvements, additions or Utility Installations without the prior approval of Lessor, or use a contractor not expressly approved by Lessor, Lessor may, at any time during the term of this Lease, require that Lessee remove any part or all of the same.

  • Customer Premises Equipment or "CPE" means equipment employed on the premises of a Person other than a Carrier to originate, route or terminate Telecommunications (e.g., a telephone, PBX, modem pool, etc.).

  • electrical installation means an electrical installation as defined in the Regulations;

  • meter installation means the meter and, if so equipped, the instrument transformers, wiring, test links, fuses, lamps, loss of potential alarms, meters, data recorders, telecommunication equipment and spin-off data facilities installed to measure power past a meter point, provide remote access to the metered data and monitor the condition of the installed equipment;

  • Building, structure, facility, or installation means all of the pollutant-emitting activities which belong to the same industrial grouping, are located on one or more contiguous or adjacent properties, and are under the control of the same person (or persons under common control) except the activities of any vessel. Pollutant-emitting activities shall be considered as part of the same industrial grouping if they belong to the same major group (i.e., which have the same two-digit code) as described in the Standard Industrial Classification Manual, 1972, as amended by the 1977 Supplement (U.S. Government Printing Office stock numbers 4101-0066 and 003-005-00176-0, respectively).

  • water installation means the pipes and water fittings which are situated on any premises and ownership thereof vests in the owner thereof and used or intended to be used in connection with the use of water on such premises, and includes a pipe and water fitting situated outside the boundary of the premises, which either connects to the connection pipe relating to such premises or is otherwise laid with the permission of the municipality;

  • Installation Work means the construction and installation of the System and the Start-up, testing and acceptance (but not the operation and maintenance) thereof; all performed by or for the Power Producer at the Premises.

  • Installation Date means the date specified in the Statement of Work by which the Contractor must have the ordered Equipment ready (certified) for use by the State.

  • Trade Fixtures means Lessee’s machinery and equipment that can be removed without doing material damage to the Premises. The term “Alterations” shall mean any modification of the improvements, other than Utility Installations or Trade Fixtures, whether by addition or deletion. “Lessee Owned Alterations and/or Utility Installations” are defined as Alterations and/or Utility Installations made by Lessee that are not yet owned by Lessor pursuant to Paragraph 7.4(a).

  • Installation Works means, as the context so requires,

  • Leasehold Improvements means all buildings, structures, improvements and fixtures located on any Leased Real Property which are owned by Company or any Company Subsidiary, regardless of whether title to such buildings, structures, improvements or fixtures are subject to reversion to the landlord or other third party upon the expiration or termination of the lease for such Leased Real Property.

  • Landlord Personal Property Collateral Access Agreement means a Landlord Waiver and Consent Agreement substantially in the form of Exhibit K with such amendments or modifications as may be approved by the Collateral Agent.

  • Installed means attached or connected such that an item requires tools for removal.

  • Alterations means all changes, additions, improvements or repairs to, all alterations, reconstructions, renewals, replacements or removals of and all substitutions or replacements for any of the Improvements or Equipment, both interior and exterior, structural and non-structural, and ordinary and extraordinary.

  • Military installation means: a base, camp, post, station, yard, center, homeport facility for any ship, or other activity under the jurisdiction of the Department of Defense, including any leased facility, which is located within any of the several States, the District of Columbia, the Commonwealth of Puerto Rico, the U.S. Virgin Islands, Guam, American Samoa, the Northern Marianas Islands and any other U.S. Territory. Such term does not include any facility used primarily for civil works, rivers and harbors projects, or flood control projects.

  • Specialty Alterations means Alterations consisting of kitchens, executive bathrooms, raised computer floors, computer installations, vaults, libraries, internal staircases, dumbwaiters, pneumatic tubes, vertical and horizontal transportation systems, and other Alterations of a similar character.

  • Installation Site means the site at which the Product is originally installed.

  • Modular building manufacturer means a person or corporation who owns or operates a