Fuel Flow Rate definition

Fuel Flow Rate means flow rate of the fuel, expressed in cubic metres per second at standard temperature and pressure, or kilograms per second.
Sample 1Sample 2Sample 3
Fuel Flow Rate means flow rate of the cleaned Syngas, expressed in cubic metres per second at standard
Sample 1

Examples of Fuel Flow Rate in a sentence

  • Minimum Fuel Flow Rate Default (DefaultPurposeCode "DM")Default minimum fuel flow rate (refer to the Part 75 Emissions Monitoring Policy Manual).

  • The fuel flow for airplanes powered by a turbine engine(s) under part 23 should meet the requirements discussed under Fuel Flow Rate for Pressure Regulated Systems below.

  • Fuel Flow Rate for Unregulated Fuel Injection Pump Systems Some fuel injection systems utilize an integral speed-sensing pump, approved as part of the engine type design, that delivers fuel at an unregulated pressure proportional to engine speed.

  • Engine Post-Inspection Test Run Fuel System 1 Replace fuel filter(s) 2 Drain valves, carburettor bowl3 Electronic fuel boost pump and fittings4 Fuel lines, taps and connectors 5 Fire sleeves6 Fuel Flow Rate 8.6 Pre-Maintenance Inspections:• As all possible circumstances cannot be listed here, the following is provided as guidance only.

  • Fuel Flow Rate for Pressure Regulated Systems Conduct these fuel-flow rate tests by placing the airplane in the same attitude as outlined in the procedure for gravity-feed fuel system tests.

  • For instance, changes in engine speed would produce oscillation in the intake and exhaust manifold pressures, thus affecting experiments repeatability.Engine Fuel and Fuel Flow Rate The fuel chosen for the Gasoline GM HCCI engine experiments was Iso-octane.

  • The cuts with (∗) are correlated with transverse impact parameter d0 cut.

  • Report one of the following codes to indicate the source of the value for gas flow rate: 0 Hourly Measurement1 Substitute Data Using Lookback Procedures2 Default Minimum Fuel Flow Rate3 Maximum Potential Fuel Flow Rate (simplified missing data procedure for peaking units, only)4 Emergency Fuel (maximum unit fuel flow rate) Do not leave this field blank.Load Range or Operational Bin Number (32).

  • Figure 5.10 - EMS Modeling: ICE Fuel Flow Rate and Virtual Fuel Flow Rate Finally, having obtained the values of the equivalent fuel consumption associated with each possible combination of power-split, the optimization algorithm will choose the minimum value from these, which will define the optimal power-split.

  • Table 3.4 - Fuel Flow Rate comparison for different operating points at part load with respect to the Reference Engine3.4 Results Figure 3.10 - Part Load Engine Concepts Results - 13 Steady-State Analysis From Figure 3.10, which shows the comparison between the Engine C and the Reference Engine, it is possible to appreciate the effect of the Millerization of the cycle and the integration of the e-supercharger on fuel consumption.

Related to Fuel Flow Rate

  • Peak flow rate means the maximum instantaneous flow from a given storm condition at a particular location.

  • Flow rate means the rate at which water flows through pipes, valves and emission devices, measured in gallons per minute, gallons per hour, or cubic feet per second.

  • Heat Rate means the quantity of BTU’s consumed to produce a kilowatt-hour of energy, calculated as follows:

  • PJM Region Installed Reserve Margin means the percent installed reserve margin for the PJM Region required pursuant to RAA, Schedule 4.1, as approved by the PJM Board. PJM Region Peak Load Forecast:

  • Maximum Concentration Level Assessment means the Maximum Concentration Level Assessment for the purposes of a Basic Comprehensive Certificate of Approval, described in the Basic Comprehensive User Guide, prepared by a Toxicologist using currently available toxicological information, that demonstrates that the concentration at any Point of Impingement for a Compound of Concern that does not have a Ministry Point of Impingement Limit is not likely to cause an adverse effect as defined by the EPA. The concentration at Point of Impingement for a Compound of Concern must be calculated in accordance with O. Reg. 419/05.

  • Grade point average or "GPA" means the grade point average earned by an eligible student and reported by the high school or participating institution in which the student was enrolled based on a scale of 4.0 or its equivalent if the high school or participating institution that the student attends does not use the 4.0 grade scale;

  • Average Daily Availability means, as of any date of determination, the average daily Availability for the immediately preceding Fiscal Quarter.

  • Ultra Low Sulfur Diesel Fuel means diesel fuel that has a sulfur content of no more than fifteen parts per

  • Baseline concentration means that ambient concentration level that exists in the baseline area at the time of the applicable minor source baseline date. A baseline concentration is deter- mined for each pollutant for which a minor source baseline date is estab- lished and shall include:

  • Cash Flow Ratio means, as at any date, the ratio of (a) the sum of the aggregate outstanding principal amount of all Indebtedness of the Company and the Restricted Subsidiaries determined on a consolidated basis, but excluding all Interest Swap Obligations entered into by the Company or any Restricted Subsidiary and one of the Banks outstanding on such date, plus (but without duplication of Indebtedness supported by letters of credit) the aggregate undrawn face amount of all letters of credit outstanding on such date to (b) Annualized Operating Cash Flow determined as at the last day of the most recent month for which financial information is available.

  • Utilization Fee Rate means the percentage set forth in Schedule 1 hereto beside the then applicable Level.

  • Leverage Factor means the leverage factor in respect of a Series of ETP Securities as specified in the relevant Final Terms.

  • Borrowing Base Utilization Percentage means, as of any day, the fraction expressed as a percentage, the numerator of which is the sum of the Revolving Credit Exposures of the Lenders on such day, and the denominator of which is the Borrowing Base in effect on such day.

  • Collateral Coverage Ratio means (i) the aggregate value of any relevant collateral security, including the pro rata value of any shared collateral, divided by (ii) the outstanding aggregate principal amount of the relevant debt.

  • Stress Factor means 2.25.

  • Deactivation Avoidable Cost Rate means the formula rate established pursuant to Tariff, Part V, section 115 of this Tariff. Deactivation Date:

  • Weighted Average Net Mortgage Interest Rate As to any Distribution Date, a rate per annum equal to the average, expressed as a percentage of the Net Mortgage Interest Rates of all Mortgage Loans that were Outstanding Mortgage Loans as of the Due Date in the month preceding the month of such Distribution Date, weighted on the basis of the respective Scheduled Principal Balances of such Mortgage Loans.

  • Required Reserve Factor Floor means, for any Calculation Period, the sum (expressed as a percentage) of (a) 12.5% plus (b) the product of the Adjusted Dilution Ratio and the Dilution Horizon Ratio, in each case, as of the most recent Cut-Off Date.

  • Weighted Average Adjusted Net Mortgage Rate For any Distribution Date and Loan Group, the average of the Adjusted Net Mortgage Rate of each Mortgage Loan in that Loan Group, weighted on the basis of its Stated Principal Balance as of the Due Date in the prior month (after giving effect to Principal Prepayments in the Prepayment Period related to such prior Due Date).

  • Excess Rate With respect to each ARD Loan, the excess of (i) the applicable Revised Rate over (ii) the applicable Mortgage Rate, each as set forth in the Mortgage Loan Schedule.

  • Blended Rate means, with respect to any Taxable Year, the sum of the effective rates of tax imposed on the aggregate net income of the Corporate Taxpayer in each state or local jurisdiction in which the Corporate Taxpayer files Tax Returns for such Taxable Year, with the maximum effective rate in any state or local jurisdiction being equal to the product of: (i) the apportionment factor on the income or franchise Tax Return filed by the Corporate Taxpayer in such jurisdiction for such Taxable Year, and (ii) the maximum applicable corporate tax rate in effect in such jurisdiction in such Taxable Year. As an illustration of the calculation of Blended Rate for a Taxable Year, if the Corporate Taxpayer solely files Tax Returns in State 1 and State 2 in a Taxable Year, the maximum applicable corporate tax rates in effect in such states in such Taxable Year are 6% and 5%, respectively and the apportionment factors for such states in such Taxable Year are 60% and 40%, respectively, then the Blended Rate for such Taxable Year is equal to 5.6% (i.e., 6% times 60% plus 5% times 40%).

  • Non-Availability Charges has the meaning set forth in the CAISO Tariff.

  • Rate Floor The minimum per annum Mortgage Interest Rate permitted under the related Mortgage Note. Rating Agency: Initially, each of S&P and Xxxxx’x and thereafter, each nationally recognized statistical rating organization that has rated the Certificates at the request of the Company, or their respective successors in interest. Ratings: As of any date of determination, the ratings, if any, of the Certificates as assigned by the applicable Rating Agencies.