DOOR FRAMES definition

DOOR FRAMES. Shall be ACI or equal, 3 3/4" or 4 7/8" throat, brushed, standard aluminum, snap-on trim. HARDWARE:
Sample 1Sample 2Sample 3
DOOR FRAMES. With snap trim, 3'0" x 8'7", Western Integrated, three-piece dark bronze anodized aluminum. C. Finish Hardware: See hardware specs, attached.
Sample 1Sample 2
DOOR FRAMES. Hollow metal frames are to match 1 1/2 hour and 3/4 hour rated frames and to be painted in accordance with paint section as noted herein.
Sample 1Sample 2

Examples of DOOR FRAMES in a sentence

  • Door frames of 3 mm (b) Door shutters (c) On width and height of 3mm .

  • All Doors fixed to external wallsare of Teak wood Door frames and Teak wood Shutters.

  • Unobstructed 300mm min space on door pull side between door leading edge and wall (not to powered doors).• Door frames to contrast with surrounding wall surfaces.

  • All Doors fixed to external walls are of Teak wood Door frames and Teak wood Shutters.

  • Door frames will be knockdown or welded type, single rabbet, minimum 16-gauge prime coated steel top painted with DTM ALKYD, width to suit wall thickness.

  • Door frames without sills shall be fitted with temporary stretchers.Horns of frames and other parts that go into or butt against the masonry, shall be protected against moisture and decay with two coats of coal tar or other approved material.All surfaces of the door, window and ventilators frames and shutters which are required to be painted ultimately shall be covered evenly by brush painting with a priming coat of a white lead based primer as specified in IS: 103.

  • Door frames must be securely fixed to the building fabric in accordance with the manufacturer’s instructions and specifications.

  • Door frames of 3 mm (b) Door shutters (c) On width and height of 3mm.

  • All Doors fixed to external walls, Safe Room and Locker Rooms are of Teak wood Door frames and Teak wood Shutters.

  • Door frames shall be structural steel channels rigidly connected to hoistway with head members reinforced and welded at corners.


More Definitions of DOOR FRAMES

DOOR FRAMES. All Xxx Xxxx frames except toilets, Toilets P.V.C Doors Window : Alluminium glazed window Window grill : 5 mm Grill Lift : with 4 (four) passengers capacity. Electrical : Concealed wiring and fitting and fixtures Dining : 2 Fan points, 2 Light points, 1 No 5 Amp. Plug point Each Bed Room : 1 Fan point, 1 No. 5 Amp. Plug point, 1 Tube Light point and 1 night lamp point and one A.C point in one bedroom out of the three bed room Kitchen : 1 exhaust point and 1 light point Balcony : 1 light point Sanitary and Plumbing : Each flat would be provided with only one white basin of matching size. Inside the concealed pipe line with heavy Density P.V.C. Pipe. Outside light Density P.V.C. Pipe. Basin/Pan : White good quality Brand.
Sample 1
DOOR FRAMES. Size to accommodate 1 —” thick door. Raco frame or equal, clear anodized aluminum. Miter corners. Window Frames and full front butt joined glazing, Raco frame to match door frame. Miter corners. Color to be clear anodized or as approved by Owner.
Sample 1
DOOR FRAMES. Painted hollow metal. .5 Door Hardware: As required by Code.
Sample 1

Related to DOOR FRAMES

  • Lobby means a covered space in which all the adjoining rooms open;

  • Open type traction battery means a type of battery requiring filling with liquid and generating hydrogen gas that is released to the atmosphere.

  • Load Shedding means the systematic reduction of system demand by temporarily decreasing load in response to transmission system or area capacity shortages, system instability, or voltage control considerations under Tariff, Part II or Part III.

  • Lockdown means the period between 23H59 on 26 March 2020, until 23H59 on 30 April 2020;

  • Parapet means a low wall or railing built along the edge of a roof or a floor;

  • Cabinet x-ray system means an x-ray system with the x-ray tube installed in an enclosure independent of existing architectural structures except the floor on which it may be placed. The cabinet x-ray system is intended to contain at least that portion of a material being irradiated, provide radiation attenuation, and exclude personnel from its interior during generation of radiation. Included are all x-ray systems designed primarily for the inspection of carry-on baggage at airline, railroad, and bus terminals, and in similar facilities. An x-ray tube used within a shielded part of a building, or x-ray equipment that may temporarily or occasionally incorporate portable shielding, is not considered a cabinet x-ray system.

  • Layout means a conceptual drawing sufficient to provide for the specified stormwater management facilities required at the time of approval.

  • Passenger area means the area designed to seat the driver and passengers while a motor vehicle is in operation and any area that is readily accessible to the driver or a passenger while in his or her seating position, including but not limited to any type of glove or storage compartment accessible to passengers or driver.

  • Configuration means State-specific changes made to the Software without Source Code or structural data model changes occurring.

  • Passenger Services means the Franchisee's railway passenger services as specified in any Timetable and/or Plan of the Day including those railway passenger services which the Franchisee may delegate or subcontract or otherwise secure through any other person from time to time in accordance with the Franchise Agreement;

  • Garage shall have the meaning ascribed to it in Recital H;

  • Pavement means any type of improved surface that is within the public right-of-way and that is paved or otherwise constructed with bituminous, concrete, aggregate, or gravel.

  • PAD means a Preauthorized Debit.

  • Users mean individuals who are authorized by Customer to use the Subscription Service, subject to the terms of this Agreement, and have been supplied user identifications and passwords by Customer. Users may include, for example, Customer’s and its Affiliates’ employees, consultants, clients, external users, contractors, agents and authorized third parties.

  • Duct is a single enclosed path to house facilities to provide Telecommunications Services.

  • Rack means a mechanism for delivering motor vehicle fuel or diesel from a refinery or terminal into a truck, trailer, railroad car, or other means of non-bulk transfer.

  • Passenger car means every motor vehicle other than a motorcycle designed and used primarily for

  • Enclosure means the part enclosing the internal units and providing protection against any direct contact.

  • Classroom hour means 50 minutes of instruction out of

  • Passenger means any person, except members of the crew, carried or to be carried in an aircraft with the consent of the carrier pursuant to a valid contract of carriage.

  • Driver means a person who drives or is in actual physical control of a vehicle.

  • Drivers means any person who is driving or in control of your motor vehicle with your express consent.

  • Kiosk means a department in a RIME Store.

  • Riser means a watertight vertical cylinder and lid allowing access to an OWTS component for inspection, cleaning, maintenance, or sampling.

  • Kitchen means a food preparation area that includes a sink, refrigerator and a microwave oven or stove.

  • Cabin means a non-residential enclosure constructed of non-load bearing partitions;