Controller to Processor Standard Clauses definition

Controller to Processor Standard Clauses in relation to the Processing of Personal Data pursuant to this Agreement means the standard clauses for the transfer of Personal Data to Processors established in third countries approved by the European Commission from time to time, the approved version of which in force at present is that set out in the European Commission's Decision 2010/87/EU of 5 February 2010, available at: xxxx://xxx- xxx.xxxxxx.xx/xxxxx-xxxxxxx/xx/XXX/?xxx=XXXXX%0X00000X0000. Exhibit 2 to this Agreement shall apply as Appendix 1 of the Controller to Processor Standard Clauses.
Sample 1Sample 2
Controller to Processor Standard Clauses has the meaning specified in Clause 9.2;
Sample 1Sample 2
Controller to Processor Standard Clauses in relation to the processing of Personal Data pursuant to this DPA means the standard clauses for the transfer of Personal Data to processors established in third countries as updated, amended replaced or superseded from time to time by the European Commission, the approved version of which in force at present is that set out in the European Commission’s Decision 2010/87/EU of 5 February 2010, available at: xxxx://xxx-xxx.xxxxxx.xx/legal-content/en/TXT/?uri=CELEX%3A32010D0087.
Sample 1Sample 2

Examples of Controller to Processor Standard Clauses in a sentence

  • Notices may be sent by e-mail to the address listed in Section 1 of the Agreement (Customer Details and Controller to Processor Standard Clauses), registered mail, marked for the attention of authorized representative of the Customer and, in the case of Corsearch, for the attention of the CCO or the Chief Legal Officer of Corsearch, Inc., or to such other address as such Party may specify to the other Party in writing from time to time.

  • No materials will be stored on site where they may present a hazard to property, personnel or affect the normal operating function of the building.

  • If OEM is in the European Economic Area (“EEA”) and transfers personal data to Supplier in a country that has not been deemed to provide an adequate level of protection, then such transfers shall be governed by the Controller to Processor Standard Clauses, which are incorporated herein by reference.

  • Annex B to this Agreement shall apply as Appendix 2 of the Controller to Processor Standard Clauses.

  • For purposes of the Controller to Processor Standard Clauses, (i) Client, the party transferring from the EEA, UK or Switzerland, willbe referred to as the “Data Exporter” and (ii) Humanscale will be referred to as the “Data Importer.” Annex A to this Agreement shall apply as Appendix 1 of the Controller to Processor Standard Clauses.

  • When a Photographer located in a Member State of the EEA or Switzerland transfers or discloses Personal Data to SmugMug, such transfers will be governed by the Controller to Processor Standard Clauses.

  • For purposes of the Controller to Processor Standard Clauses, (i) the Photographer located in the EEA or Switzerland will be referred to as the “Data Exporter” and (ii) SmugMug will be referred to as the “Data Importer.” Annex 1 to this Agreement shall apply as Appendix 1 of the Controller to Processor Standard Clauses.

  • When a User located in a Member State of the EEA or Switzerland transfers or discloses Personal Data to Xxxxxxxxxxxxxxxxxx.xxx, such transfers will be governed by the Controller to Processor Standard Clauses.

  • For purposes of the Controller to Processor Standard Clauses, (i) the User located in the EEA or Switzerland will be referred to as the “Data Exporter” and (ii) Xxxxxxxxxxxxxxxxxx.xxx will be referred to as the “Data Importer.” Annex 1 to this Agreement shall apply as Appendix 1 of the Controller to Processor Standard Clauses.

  • For transfers of Personal Information from the European Economic Area, Switzerland, or the United Kingdom to MaxMind as a processor, the parties hereby enter into the Controller to Processor Standard Clauses set out at: xxxxx://xxx.xxxxxxx.xxx/scc-processor-to- controller.pdf.


More Definitions of Controller to Processor Standard Clauses

Controller to Processor Standard Clauses means the standard clauses for the transfer of personal data to processors established in third countries approved by the European Commission from time to time, the approved version of which in force at present is that set out in the European Commission's Decision 2010/87/EU of 5 February 2010.
Sample 1

Related to Controller to Processor Standard Clauses

  • air traffic control service means a service provided for the purpose of:

  • National Ambient Air Quality Standards or “NAAQS” means national ambient air quality standards that are promulgated pursuant to Section 109 of the Act, 42 U.S.C. § 7409.

  • Web Site Accessibility Standards/Specifications means standards contained in Title 1 Texas Administrative Code Chapter 206.

  • Safety Management System has the meaning given to it in the ISM Code.

  • Electronic and Information Resources Accessibility Standards means the accessibility standards for electronic and information resources contained in 1 Texas Administrative Code Chapter 213.

  • VNXX Traffic is all traffic originated by a Party’s End User Customer and dialed with a local dialing pattern that is not terminated to the other Party’s End User Customer physically located within the same CenturyLink Local Calling Area (as approved by the state Commission) as the originating caller, regardless of the NPA-NXX dialed. VNXX does not include originating 8XX traffic.

  • National Road Traffic Act means the National Road Traffic Act, 1996 (Act 93 of 1996);

  • Traffic control signal means a device, whether manually, electrically, or mechanically operated, by which traffic is alternately directed to stop and permitted to proceed.

  • Web Site Accessibility Standards/Specifications means standards contained in Title 1 Texas Administrative Code Chapter 206.

  • Accessibility Standards means accessibility standards and specifications for Texas agency and institution of higher education websites and EIR set forth in 1 TAC Chapter 206 and/or Chapter 213.

  • emissions of substances not controlled by emission limits means emissions of substances to air, water or land from the activities, either from the emission points specified in schedule 3 or from other localised or diffuse sources, which are not controlled by an emission limit.

  • Regulations of the U.S. Department of Transportation means the regulations in 49 CFR Parts 100-189.

  • Gestational carrier means an adult woman who enters into an agreement to have an embryo implanted in her and bear the resulting child for intended parents, where the embryo is conceived by using the egg and sperm of the intended parents.

  • InterMTA Traffic means traffic to or from WSP’s network that, at the beginning of the call, originates in one MTA and terminates in another MTA.

  • Electronic Subcontracting Reporting System (eSRS) means the Governmentwide, electronic, web-based system for small business subcontracting program reporting. The eSRS is located at http://www.esrs.gov.

  • InterLATA Traffic describes Telecommunications between a point located in a Local Access and Transport Area ("LATA") and a point located outside such area.

  • Disturbance Control Standard or “DCS” shall mean the reliability standard that sets the time limit following a disturbance within which a balancing authority must return its Area Control Error to within a specified range.

  • Ambient air quality standard means an established concentration, exposure time, and frequency of occurrence of air contaminant(s) in the ambient air which shall not be exceeded.

  • Caribbean Basin country construction material means a construction material that—

  • New Jersey Stormwater Best Management Practices (BMP) Manual or “BMP Manual” means the manual maintained by the Department providing, in part, design specifications, removal rates, calculation methods, and soil testing procedures approved by the Department as being capable of contributing to the achievement of the stormwater management standards specified in this chapter. The BMP Manual is periodically amended by the Department as necessary to provide design specifications on additional best management practices and new information on already included practices reflecting the best available current information regarding the particular practice and the Department’s determination as to the ability of that best management practice to contribute to compliance with the standards contained in this chapter. Alternative stormwater management measures, removal rates, or calculation methods may be utilized, subject to any limitations specified in this chapter, provided the design engineer demonstrates to the municipality, in accordance with Section IV.F. of this ordinance and N.J.A.C. 7:8-5.2(g), that the proposed measure and its design will contribute to achievement of the design and performance standards established by this chapter.

  • Federal contract information means information, not intended for public release, that is provided by or generated for the Government under a contract to develop or deliver a product or service to the Government, but not including information provided by the Government to the public (such as on public Web sites) or simple transactional information, such as necessary to process payments.

  • Interconnection Regulations means the Telecommunication (Broadcasting and Cable) Services Interconnection (Addressable Systems) Regulations, 2017 (as amended).

  • CIP (Destinations means Carriage and Insurance Paid up to named port of destination. Additionally the Insurance (local transportation and storage) would be extended and borne by the Supplier from ware house to the consignee site for a period including 3 months beyond date of delivery.

  • Standard Methods for the Examination of Water and Wastewater means the most recent edition of Standard Methods for the Examination of Water and Wastewater published jointly by the American Public Health Association, the American Waterworks Association and the Water Environment Federation;

  • Interconnection Construction Service Agreement means the agreement entered into by an Interconnection Customer, Interconnected Transmission Owner and the Transmission Provider pursuant to Tariff, Part VI, Subpart B and in the form set forth in Tariff, Attachment P, relating to construction of Attachment Facilities, Network Upgrades, and/or Local Upgrades and coordination of the construction and interconnection of an associated Customer Facility. A separate Interconnection Construction Service Agreement will be executed with each Transmission Owner that is responsible for construction of any Attachment Facilities, Network Upgrades, or Local Upgrades associated with interconnection of a Customer Facility. Interconnection Customer:

  • Clean air standards, as used in this clause, means: