Clearance inspection definition

Clearance inspection means a visual assessment and lead testing, as applicable, done at the conclusion of a renovation, repair, and painting (RRP), lead hazard control (LHC), or lead hazard reduction (LHR) project to determine compliance with this Part.
Clearance inspection means a visual assessment and collection and analysis of environmental samples following lead hazard reduction activities to determine that the lead hazard reduction activities are complete and no lead exposure hazards remain in the dwelling, dwelling unit, or child care facility.
Clearance inspection means an on-site limited investigation, as described in Chapter 15: Clearance, sections II-VI, “Guidelines for the Evaluation and Control of Lead-Based Paint Hazards in Housing,” U.S. Department of Housing and Urban Development, June 1995.

Examples of Clearance inspection in a sentence

  • Once the Lead Abatement work begins only MDH Licensed workers may enter the house until an Interim Clearance inspection has been made by Ramsey County.

  • Request Visual Clearance inspection from the Department of Neighborhood and Economic Operations.

  • A Clearance inspection must be conducted after work is completed on any homes, or part of a home, that has tested positive for lead.

  • Clearance inspection report Lead Awareness Training: You must provide 8 hours of lead awareness training, complying with the provisions in 8 CA Code of Regs § 1532.1. Lead and 8 CA Code of Regs § 5194.

  • Clearance inspection for non-friable asbestos removal work must be conducted by a Competent Person which may include a LAA.

  • The Asbestos Abatement Contractor shall be responsible for achieving acceptable visual and final air clearance testing for ALL abatement areas as follows: Clearance inspection: Cardno ATC’s Project Monitor shall inspect the work area and surrounding areas for clearance using visual and physical methods, prior to clearing the project for air monitoring clearance procedures.

  • The Asbestos Abatement Contractor shall be responsible for achieving acceptable visual and final air clearance testing for ALL abatement areas as follows: • Clearance inspection: ATC’s Project Monitor shall inspect the work area and surrounding areas for clearance using visual and physical methods, prior to clearing the project for air monitoring clearance procedures.

  • A requirement that the employer identify the usual weekly hours of work for employees in the affected unit and the specific percentage by which their hours will be reduced during all weeks covered by the plan.

  • The Contractor is responsible for scheduling the Clearance inspection.

  • Monday, December 13, 2021Category Number: Item Number: Item Title:INVOCATION Item Summary:INVOCATION Monday, December 13, 2021Category Number: Item Number: Item Title:PLEDGE OF ALLEGIANCE Item Summary:PLEDGE OF ALLEGIANCE Category Number: Item Number: 1.


More Definitions of Clearance inspection

Clearance inspection means an on-site limited investigation, as described in Chapter 15: Clearance, sections II-VI, “Guidelines for the Evaluation and Control of Lead-Based Paint Hazards in Housing,”

Related to Clearance inspection

  • Home inspection means the on-site, physical review of the home of an applicant to assure the applicant and the home meets all health and safety requirements within these rules.

  • Home inspection report means a written report that is

  • Final Inspection means the process and procedure described in UGC Section 12.1.

  • Onsite means within the Prescribed Premises boundary.

  • Site means the place or places where the permanent Works are to be carried out including workshops where the same is being prepared.

  • Initial inspection means the first on-site inspection of facilities to verify declarations submitted pursuant to Articles III, IV, V and VI and this Annex.

  • Offsite means located outside the lot lines of the lot in question

  • Certificate of inspection means an unsworn statement,

  • Internal inspection means as complete an examination as can be reasonably made of the internal and external surfaces of a boiler or pressure vessel while it is shut down and while manhole plates, handhole plates or other inspection opening closures are removed as required by the inspector.

  • Due Diligence Examination shall have the meaning set forth in Section 3.2.

  • Inspection means activities such as measuring, examining, testing, gauging one or more characteristics of the product or service and comparing the same with the specified requirement to determine conformity.

  • External inspection means an inspection that does not involve examination of the internal surfaces of the pressure parts of the boiler.

  • Inspections has the meaning set forth in Section 4.1.2.

  • Initial Environmental Examination or “IEE” means the initial environmental examination for the Project, including any update thereto, prepared and submitted by the Borrower and cleared by ADB;

  • Phase II means the second part of the tuition incentive assistance program which provides assistance in the third and fourth year of 4-year degree programs.

  • Inspection Report means the report delivered by the Master Servicer or the Special Servicer, as the case may be, substantially in the form of Exhibit L hereto.

  • Examined Facility means (I) each proposed new Generator and proposed new UDR project, and each existing Generator that has ERIS only and no CRIS, that is a member of the Class Year Study, Additional SDU Study or Expedited Deliverability Study that requested CRIS, or that requested an evaluation of the transfer of CRIS rights from another location in the Class Year Facilities Study commencing in the calendar year in which the Class Year Facility Study determination is being made (the Capability Periods of expected entry as further described below in this Section, the “Mitigation Study Period”), and (II) each (i) existing Generator that did not have CRIS rights, and (ii) proposed new Generator and proposed new UDR project, provided such Generator under Subsection (i) or (ii) is an expected recipient of transferred CRIS rights at the same location regarding which the ISO has been notified by the transferor or the transferee of a transfer pursuant to OATT Attachment S Section 25.9.4 that will be effective on a date within the Mitigation Study Period (“Expected CRIS Transferee”). The term “Examined Facilities” does not include any facility exempt from an Offer Floor pursuant to the provisions of Section 23.4.5.7.7. Exceptional Circumstances: shall mean one or more unavoidable circumstances, as determined by the ISO, that individually or collectively render as unavailable the data necessary for the ISO to perform an audit and review of a Market Party, pursuant to Section 23.4.5.6.2 of this Services Tariff. Exceptional Circumstances may include, but are not limited to: the inaccessibility of the physical facility; the inaccessibility of necessary documentation or other data; and the unavailability of information regarding the regulatory obligations with which the Market Party will be required to comply in order to return its Generator to service which regulatory obligations are not yet known but which will be made known by the applicable regulatory authority under existing laws and regulations provided that none of the above described circumstances are the result of delay or inaction by the Market Party. The magnitude of the repair cost, alone, shall not be an Exceptional Circumstance.

  • Phase I Environmental Assessment A “Phase I assessment” as described in, and meeting the criteria of, the ASTM, plus a radon and asbestos inspection.

  • Recertification means the process by which a client’s eligibility to continue to receive child care assistance benefits are determined.

  • Validation as used in WAC 222-20-016, means the department's agreement that a small forest landowner has correctly identified and classified resources, and satisfactorily completed a roads assessment for the geographic area described in Step 1 of a long-term application.

  • Phase I Environmental Site Assessment means a Phase I environmental property assessment of the Assets that satisfies the basic assessment requirements set forth under the current ASTM International Standard Practice for Environmental Site Assessments (Designation E1527-13) or any other visual site assessment or review of records, reports or documents.

  • Decontamination means a process that attempts to remove or reduce to an acceptable level a contaminant exceeding an allowable threshold set forth in these Rules in a harvest batch or production batch.

  • Site Visit means a visit to the Site; and

  • Phase I Environmental Report means a report by an Independent Person who regularly conducts environmental site assessments in accordance with then current standards imposed by institutional commercial mortgage lenders and who has a reasonable amount of experience conducting such assessments.

  • Busy Line Verification (BLV) means a service whereby an End User requests an operator to confirm the busy status of a line.

  • SITE / LOCATION means any Site where BHARAT PETROLEUM CORPORATION LTD. desires to receive materials any where in India as mentioned in RFQ.