Circuit Mileage means, with respect to any Circuit, the length of such Circuit in airline miles computed according to industry standard V&H coordinates as specified in the Purchase Order pursuant to which such Circuit is ordered.

Examples of Circuit Mileage in a sentence

Table 2-xx13 shows the income ranges limits for each income category based on household size, as reported by the California Department of Housing and Community Development the 2008 HUD MFI for Orange County.
Circuit Mileage The distance of physical transmission facilities from originating point to terminating point, measured on a route of circuit basis.
The airline distance in miles developed in (a) preceding will be multiplied by the Circuit Mileage - Per Mile rate element times the billing percentage to determine the appropriate Circuit Mileage-Per Mile charges.
For Special Access, the total Circuit Mileage charges shall be the Circuit Mileage-Per Mile charge determined in (b) preceding plus the Circuit Mileage-Fixed charges.
Table I gives the average azimuth and range spatial resolution, integrated sidelobe ratio (ISLR), peak sidelobe ratio (PSLR) and spurious sidelobe ratio (SSLR) for 6 Level 1.5 PALSAR products.

More Definitions of Circuit Mileage

Circuit Mileage means the length of a Circuit specified in the applicable Purchase Order. "DS-0" means a circuit complying with TR-TSY-000333. "Switched and Special Access Services - Transmission Parameter Limits and Interface Combinations" Issue 1, July 1990. A "DS-1" is a signal conforming to the requirements set forth in Sections 9.3 and 10.2 of Bellcore TR-NWT-000499, Issue 5, December 1993. A "DS-3" is a signal conforming to the requirements set forth in Section 9.6 and 10.5 of Bellcore TR-NWT-000499, Issue 5, December, 1993. "Purchase Order" means any Excel purchase order accepted by IXC. "Requested Service Date" means the date Private Line Service on a Circuit is requested to commence specified in the applicable Purchase Order. "Service" means transmission service provided between North American DSX standard cross-connect panels located in IXC's terminal locations.

Circuit Mileage means the length of a Circuit specified in the applicable Purchase Order. "DS-0" means a circuit complying with TR-TSY-000333 "Switched and Special Access Services - Transmission Parameter Limits and Interface Combinations" Issue 1, July 1990. A "DS-1" is a signal conforming to the requirements set forth in Sections 9.3 and 10.2 of Bellcore TR-NWT-000499, Issue 5, December, 1993. A "DS-3" is a signal conforming to the requirements set forth in Section 9.6 and 10.5 of Bellcore TR-NWT-000499, Issue 5, December, 1993. A "Firm Order Commitment" means the written confirmation provided to Customer which confirms the specific date that the Circuit is available to Customer. An "OC-3" is a signal based on the SONET frame structure as specified in Bellcore GR-253-CORE, Synchronous Optical Network (SONET) Transport Systems: Common Criteria Physical Layer, and ANSI T1.105, Digital Hierarchy-Optical Interface Rates and Formats Specifications. An "OC-12" is a signal based on the SONET frame structure as specified in Bellcore GR-253-CORE, Synchronous Optical Network (SONET) Transport Systems: Common Criteria Physical Layer, and ANSI T1.105, Digital Hierarchy-Optical Interface Rates and Formats Specifications. "Purchase Order" means any Customer purchase order accepted by Supplier. "Requested Service Date" means the date Service on a Circuit is requested to commence specified in the applicable Purchase Order. "Service" means transmission service provided between North American DSX standard cross-connect panels located in Supplier's terminal locations. 9 EXHIBIT A [FORM OF PURCHASE ORDER/MARKET SERVICE ORDER] 10 EXHIBIT B PRIVATE LINE SERVICE ANCILLARY PRICING [Superceded] 11 EXHIBIT C On Net City Listing for Private Line* Location LATA Address/(NPA) NXX -------- ----------- ----------------- [ * * * ] [ * * * ] [ * * * ] * Subject to Availability 12 EXHIBIT D Private Line Pricing [ Superceded ] 13 Exhibit E Taxes on Telecommunications Service [ * * * ] 14 AMENDMENT NO. 1 TO IXC MASTER SERVICE AGREEMENT [IXC COMMUNICATIONS LOGO] This Amendment No. 1 to the Master Service Agreement is made and entered into by and between IXC COMMUNICATIONS SERVICES, INC., a Delaware corporation with its principal place of busines at 1122 Xxxxxxx xx Xxxxx Xxx. Xxxxx, Xxxxxx, Xxxxx 00000-0000 ("Xupplier"), and PATHNET, INC., a Delaware corporation with its principal place of business at 1015 00xx Xxxxxx Xxxxxxxxx, Xxxxx 000, Xxxxxxxxxx XX 00000 ("Xustomer"). For purposes of this Amendment, th...

Circuit Mileage means the length of a Circuit specified in the applicable Purchase Order. "DS-0" means a circuit complying with TR-TSY-000333 "Switched and Special Acces rameter Limits and Interface Combinations" Issue 1, July 1990. A "DS-l" is a signal conforming to the requirements set forth in Sections 9.3 and 10.2 of Bellcore TR-NWT-000499, Issue 5, December, 1993. A "DS-3" is a signal conforming to the requirements set forth in Section 9.6 and 10.5 of Bellcore TR-NWT-000499, Issue 5, December, 1993. "Purchase Order" means any Customer purchase order accepted by Supplier. "Requested Service Date" means the date Service on a Circuit is requested to commence specified in r. "Service" means transmission service provided between North American DSX standard cross-connect panels located in Supplier's terminal locations. AMENDMENT No. 4 TO IXC MASTER SERVICE AGREEMENT This Amendment No. 4 to the Master Service Agreement is made as of the last date of execution below (the "Amendment Effective Date") and entered into by and between IXC Carrier, Inc./IXC Long Distance, Inc./IXC Broadband Services, Inc. (generically "IXC"), a Nevada/Delaware corporation with its principal place of business at 0000 Xxxxxxx xx Xxxxx Xxx. Xxxxx Xxxxxx, Xxxxx 00000 ("Supplier"), and Buyers United International, Inc. a Utah corporation with its principal place of business at 000 X. 0000 Xxxxx, This Amendment is made with reference to the following facts: A. Customer and Supplier are parties to that certain Master Service Agreement dated as of January 21, 1998 and subsequent Amendment No. 1, dated January 14, 1998, Amendment No. 2 dated January 21, 1998 and Amendment No. 3 dated March 24, 1998 (as amended the "Agreement").

Circuit Mileage means the length of a Circuit specified in the applicable Purchase Order. "DS-0" means a circuit complying with TR-TSY-000333 "Switched and Special Access Services - Transmission Parameter Limits and Interface Combinations" Issue 1, July 1990. "DS-1" means a circuit complying with AT&T Tech. Ref. Pub. 62411, December 1990,with Addexxxx 0, Xxxxx 0000, and Bellxxxx XX-XXX-000000, Xxsue 5, December 1993. "DS-3" means a circuit meeting the specifications set forth in AT&T Technical Reference Pub. 54014 Addendum 1, November 1992 and Bellxxxx XX-XXX-000000, Xxsue 5, December 1993. "Purchase Order" means any Customer purchase order accepted by Supplier. "Requested Service Date" means the date Service on a Circuit is requested to commence specified in the applicable Purchase Order. "Service" means transmission service provided between North American DSX standard cross-connect panels located in Supplier's terminal locations. *** Certain information on this page has been omitted and filed separately with the Commission. Confidential treatment has been requested with respect to the omitted portions. EXHIBIT A Req'st Svc Date:________ IXC - PRIVATE LINE OFFICE USE ONLY Accepted Earlier Activation: MARKET SERVICE ORDER (MSO) MSO #______________ Y______N_______ CKT ID:_____________ RELATED MSO:____________ PURCHASE ORDER FORM FOR CUSTOMER ORDER NO:__________ Pursuant to the MASTER SERVICE AGREEMENT by and between IXC as Supplier and __________________________ as Customer, dated______________, 19___, Customer orders and Supplier shall provide the following Digital Transmission Service: QTY RATE TERM MILES New ________ Renew __________ Cancel ________ Disconnect __________ DS-3 _____ _____ _____ _____ Change ________ Expedite Y____ N___ DS-1 _____ _____ _____ _____ On Net ________ Off Net __________ DS0 _____ _____ _____ _____ Protocol________ Reconfigure__________ CIF _____ _____ _____ _____ Other ________________________________ Other _____ _____ _____ _____ Customer Contact:____________________ Phone #: ________________ Fax # _______________ Technical Contact____________________ Phone #: ________________ Fax # _______________ CITY LOCATION A: ____________________ CITY LOCATION B:_________________________________ Special____________ Switched____________ Special________________ Switched________________ Bypass Y_____N_____ Owner ____________ Bypass Y_______N_______ Owner ________________

Circuit Mileage means the length of a Circuit specified in the applicable Market Service Order. "DS-0" means a circuit complying with TR-TSY-000333 "Switched and Special Access Services - Transmission Parameter Limits and Interface Combinations" Issue 1, July 1990. A "DS-1" is a signal conforming to the requirements set forth in Sections 9.3 and 10.2 of Bellcore TR-NWT-000499, Issue 5, December 1993. A "DS-3" is a signal conforming to the requirements set forth in Section 9.6 and 10.5 of Bellcore TR-NWT-000499, Issue 5, December 1993. "FOC" means Firm Order Confirmation, the form Supplier submits to Customer indicating the date that an ordered Circuit will be activated. "Market Service Order" means any Customer Market Service Order accepted by Supplier. An "OC-3c" is a signal based on the SONET frame structure as specified in Bellcore GR-253-CORE, Synchronous Optical Network (SONET) Transport Systems: Common Criteria Physical Layer, and ANSI T1.105, Digital Hierarchy-Optical Interface Rates and Formats Specifications. An "OC-12c" is a signal based on the SONET frame structure as specified in Bellcore GR-253-CORE, Synchronous Optical Network (SONET) Transport Systems: Common Criteria Physical Layer, and ANSI T1.105, Digital Hierarchy-Optical Interface Rates and Formats Specifications. An "OC-12c Unprotected (1+0)" - 655 megabits Lambda - is the ANSI SONET transmission standard for high capacity optical telecommunications with line rate of 655 megabits per second in unprotected configuration, as specified in Bellcore GR-253-CORE. An "OC-48c" is a signal based on the SONET frame structure as specified in Bellcore GR-253-CORE, Synchronous Optical Network (SONET) Transport Systems: Common Criteria Physical Layer, and ANSI T1.105, Digital Hierarchy-Optical Interface Rates and Formats Specifications. An "OC-48c Unprotected (1+0)" - 2.5 gigabits Lambda - is the ANSI SONET transmission standard for high capacity optical telecommunications with line rate of 2.5 gigabits per second in unprotected configuration, as specified in Bellcore GR-253-CORE. "On-Net" means a Circuit(s) provided on Supplier's network between two cities. "Requested Service Date" means the date Service on a Circuit is requested to commence specified in the applicable Market Service Order. "Service" means transmission service provided between North American DSX standard cross-connect panels located in Supplier's terminal locations or when provided via Broadwing LDX Optical cross-connect panels located in Supplier...

Circuit Mileage means the length of a Circuit specified in the applicable Service Order. "DS-0" means a circuit complying with TR-TSY-000333 "Switched and Special Access Services—Transmission Parameter Limits and Interface Combinations" Issue 1, July 1990. A "DS-]" is a signal conforming to the requirements set forth in Sections 9.3 and 10.2 of Bellcore TR-NWT-000499, Issue 5, December 1993. A "DS-3" is a signal conforming to the requirements set forth in Section 9.6 and 10.5 of Bellcore TR-NWT-000499, Issue 5, December 1993. "E-l" is a European digital transmission format devised by the "International Telecommunications Union—Telephone Standard ("ITU-TS") and given the name by the Conference of European Postal and Telecommunication Administration ("CEPT"). E-l carries signals at 2.048 Mbps (32 channels at 64Kbps). "E-3" is a European digital transmission format devised by the ITU-TS and given the name by the CEPT. E-3 carries 16 E-l signals with a data rate of 34.368 Mbps. "Full Circuit IPL Service" means a Circuit whereby both local and foreign-end international Circuits are provided by Supplier and/or its affiliates. "Half Circuit IPL Service" means a Circuit whereby Supplier provides domestic-end half-Circuit and Customer, or Customer's end user, coordinates and procures matching half-Circuits directly from the foreign-end carrier. "International Circuit" means an E-1, X-0, XXX0, XXX0, XX-x, XX-0, OC-3c, or an OC-12. A Circuit shall be considered an "International Circuit" if at any time it is operational outside the domestic United States of America, regardless of the origination and/or termination of the signal. All such International Circuits shall be considered a part of "International Service." An "OC-3c" is a signal based on the SONET frame structure as specified in Bellcore OR-253-CORE, Synchronous Optical Network (SONET) Transport Systems: Common Criteria Physical Layer, and ANSI Tl.105, Digital Hierarchy-Optical Interface Rates and Formats Specifications. An "OC-12c" is a signal based on the SONET frame structure as specified in Bellcore GR-253-CORE, Synchronous Optical Network (SONET) Transport Systems: Common Criteria Physical Layer, and ANSI Tl.I05, Digital Hierarchy-Optical Interface Rates and Formats Specifications. An "OC-12c Unprotected (1±0)"—622.08 megabits Lambda—is the ANSI SONET transmission standard for high capacity optical telecommunications with line rate of 622.08 Mbps in unprotected configuration, as specified in Bellcore GR-253-CORE. An "OC...

Circuit Mileage definition

Filter & Search

Related Definitions