Examples of Axle Spacing in a sentence
If requirements appear to conflict it is the Vendor’s responsibility to bring these items to the attention of the District prior to the closing of the question period.
The error for individual axle spacings will be calculated using the following formula: 10 of [(WIM Axle Spacings - Actual Axle Spacing)]/10 = Mean Axle Spacing Error (Each of the four axle spacings calculated individually) All of the calculated errors will also be entered into the spreadsheet.
Appendices: Sample Axle Weight Compliance Analysis Sample Certificate of Clearance Sample Change of Information Certificate For the most recent version use the online link below, http://www.nnva.gov/950/Permits-ApplicationsSample Axle Weight Compliance Analysis-How to Determine Maximum Weights Allowed Based on Axle Spacing The maximum weight in pounds for any two or more consecutive axles shall not exceed the maximum weight allowed as specified in Section 6 – Table 2.
Suspension, rear, tandem:Walking Beam Type 54" Axle Spacing; 46,000-lb Capacity With BronzeCenter Bushings 11.
The permit program will prompt the user when the training due date is approaching.• This permit type can be issued for weights up to 200,000 lbs and will require an Axle Spacing Report NumberThe tractor/trailer combination will be considered a tractor and trailing unit(s) which can include jeeps and boosters to distribute the weight.
Procedure to Compute Axle Spacing for Multi-Axle Groups Axle spacing for multi-axle groups is the distance between the two consecutive axles of a tandem, tridem, or quad.
DEVELOPMENT OF DEFAULT AXLE SPACING AND WHEELBASE VALUES Average Axle Spacing and Wheelbase for JPCP Model Average axle spacing or wheelbase information is used for MEPDG applications involving the top-down slab cracking failure mode in JPCP.
The Oregon-specific data that were required for input into the MEPDG were: • Hourly truck volume distribution.• Site-specific Axle Weight Data• Average Number of Axles Per Truck• Average Axle Spacing Data files of the WIM axle data from all four sites are available for download from the internet for use in MEPDG.
Velocity and axle spacing were calculated using the data shown in Figure 3.10: Velocity = ∆Distance / ∆Time 1-2 = (7 ft) / (0.491 sec – 0.404 sec) = 80.5 ft/sec = 55mph Axle Spacing = Velocity * ∆Time 1-1 = (80.5 ft/sec) * (0.404 sec – 0.370 sec) = 2.74 ft The temperature sensor was installed to monitor variations in pavement temperature for future sensor calibration needs.
Eisenhower National System of Interstate and Defense Highways and for the movement of vehicles and/or loads exceeding 90,000 pounds or any of the provisions of the Oklahoma Weight and Axle Spacing Table shown in 47 O.S. 1991, Section 14-109(a)2, when proposed for movement on any other portion of the State Highway System.