Voltage and wattage Sample Clauses

Voltage and wattage. Light source module specific identification code: ............................................. Only for limited mounting height of equal to or less than 750 mm above the ground: yes/no2
Sample 1Sample 2See All (6)
Voltage and wattage. 1 Distinguishing number of the country which has granted/extended/refused/withdrawn approval (see approval provisions in the Regulation).
Sample 1Sample 2Sample 3See All (5)
Voltage and wattage. ... Light source module: yes/no2 Light source module specific identification code: ................................................. Only for limited mounting height of equal to or less than 750 mm above the ground, if applicable: yes/no2............................................................................ Geometrical conditions of installation and relating variations, if any: ................... Application of an electronic light source control gear/variable intensity control:
Sample 1Sample 2Sample 3See All (5)
Voltage and wattage. Light source module specific identification code: ............................................
Sample 1Sample 2Sample 3
Voltage and wattage. Light source module specific identification code: ....................................................... 1 Distinguishing number of the country which has granted/refused/withdrawn approval (see approval provisions in the Regulation).
Sample 1
Voltage and wattage. .. Light source module: yes/no3 Light source module specific identification code: ............................................ Application of an electronic light source control gear:
Sample 1
AutoNDA by SimpleDocs
Voltage and wattage. Application of an electronic light source control gear: - being part of the lamp yes/no 2/ - being not part of the lamp yes/no 2/
Sample 1

Related to Voltage and wattage

  • Loop Provisioning Involving Integrated Digital Loop Carriers 2.6.1 Where Xxxx Communications has requested an Unbundled Loop and BellSouth uses Integrated Digital Loop Carrier (IDLC) systems to provide the local service to the end user and BellSouth has a suitable alternate facility available, BellSouth will make such alternative facilities available to Xxxx Communications. If a suitable alternative facility is not available, then to the extent it is technically feasible, BellSouth will make alternative arrangements available to Xxxx Communications (e.g. hairpinning).

  • Traffic Measurement and Billing over Interconnection Trunks 6.1 For billing purposes, each Party shall pass Calling Party Number (CPN) information on at least ninety-five percent (95%) of calls carried over the Interconnection Trunks.

  • Bandwidth the amount of data (quantified as “Mbps” or “Gbps”) made available to Customer as specified in a Service Order.

  • FREQUENCY AND CAPACITY LEVELS No restriction on frequency, capacity or aircraft type.

  • Load A term that refers to either a consumer of Energy or the amount of demand (MW) or Energy (MWh) consumed by certain customers. Load Serving Entity (“LSE”). Any entity, including a Municipal Electric System and a Cooperatively Owned Electric System, authorized or required by law, regulatory authorization or requirement, agreement, or contractual obligation to supply Energy, Capacity and/or Ancillary Services to retail customers located within the NYCA, including an entity that takes service from the ISO to supply its own Load within the NYCA; provided, however, that such entity has obtained all governmental authorizations necessary to serve Load in the NYCA.

  • Interconnection Points 8.5.1 The IP of a Party (“Receiving Party”) for Measured Internet Traffic delivered to the Receiving Party by the other Party shall be the same as the IP of the Receiving Party for Reciprocal Compensation Traffic under Section 7.1 above.

  • Check Meters Developer, at its option and expense, may install and operate, on its premises and on its side of the Point of Interconnection, one or more check meters to check Connecting Transmission Owner’s meters. Such check meters shall be for check purposes only and shall not be used for the measurement of power flows for purposes of this Agreement, except as provided in Article 7.4 below. The check meters shall be subject at all reasonable times to inspection and examination by Connecting Transmission Owner or its designee. The installation, operation and maintenance thereof shall be performed entirely by Developer in accordance with Good Utility Practice.

  • Net Metering If you generate electricity from a renewable generating facility to offset your electricity consumption and/or use net metering at any time during the term of this Agreement, you must notify Starion.

Time is Money Join Law Insider Premium to draft better contracts faster.