Updating of Specifications Sample Clauses

Updating of Specifications. Xxxxxxxx may revise these Cable Installation Specifications to include new procedures, materials, or processes so long as the changes achieve the objectives of the specifications set forth above and are in accordance with, or superior to, then-current telecommunications industry standards. EXHIBIT G Transmission Site Specifications All Transmission Sites shall have redundant HVAC (heating, ventilation, and air conditioning) units each capable of handling the site's full HVAC load. All unattended (unmanned) Transmission Sites shall have a minimum of eight (8) hours' battery reserve. All attended Transmission Sites without an on-site generator shall have a minimum of eight (8) hours' battery reserve. If there is no generator on site, Xxxxxxxx shall have a portable generator at the Transmission Site within eight (8) hours of a power failure. All attended Transmission Sites with an on-site generator shall have a minimum of four (4) hours' battery reserve. All on-site generators shall be capable of powering the total site for a minimum of twenty-four (24) hours. All generators shall have auto-start and auto-load transfer capabilities. All generators shall be inspected, tested, and refueled (to replace consumed fuel) once per month. Xxxxxxxx shall use approximately forty-mile spacing between Transmission Sites (or between a Transmission Site and a point of presence or System end point), except where geographic factors dictate shorter spacing. All Transmission Site buildings shall be grounded with a target specification of 5 ohms or less. The Cable sheath will be exposed and grounded, typically at least fifty (50) cable feet before the entrance to the building transition of outside plant to inside plant cabling. EXHIBIT H As-Built Drawing Specifications
Sample 1Sample 2
AutoNDA by SimpleDocs
Updating of Specifications. Williams xxx xxxxse these Cable Installation Specifications to include new procedures, materials, or processes so long as the changes achieve the objectives of the specifications set forth above and are in accordance with, or superior to, then-current telecommunications industry standards. A copy of any such revised specifications shall be provided to CTC in a reasonably prompt manner. EXHIBIT E OPERATIONS SPECIFICATIONS, MAINTENANCE THIS EXHIBIT E is attached to and made a part of that certain Dark Fiber IRU Agreement dated as of March 31, 2000, by and between Williams xxx XXX ("Agreement"). Capitalized terms used and not defined herein shall have the meanings set forth for such terms in the Agreement.
Sample 1
Updating of Specifications. The Xxxxxxxx Communications may revise these Cable Installation Specifications to include new procedures, materials, or processes so long as the changes achieve the objectives of the specifications set forth above and are in accordance with, or superior to, then-current telecommunications industry standards. EXECUTION COPY CONFIDENTIAL PORTION MARKED [*************] HAS BEEN OMITTED PURSUANT TO A REQUEST FOR CONFIDENTIAL TREATMENT AND FILED SEPARATELY WITH THE SECURITIES AND EXCHANGE COMMISSION. FIRST AMENDMENT TO LEASE AGREEMENT THIS FIRST AMENDMENT ("Amendment") is made by and between XXXXXXXX COMMUNICATIONS, LLC, a Delaware limited liability company ("Xxxxxxxx Communications"), METROMEDIA FIBER NATIONAL NETWORK, INC., a Delaware corporation ("Lessee") and METROMEDIA FIBER NETWORK SERVICES, INC. ("MFNS") a Delaware corporation. Background Lessee and Xxxxxxxx Communications are parties to the Lease Agreement dated April 26, 2002 (the "Agreement"). On May 20, 2002, Lessee and most of its direct and indirect domestic subsidiaries, including MFNS, each filed voluntary petitions for reorganization pursuant to Chapter 11 of title 11 of the United States Code. (the "Bankruptcy Code") with the United States Bankruptcy Court for the Southern District of New York (the "Bankruptcy Court") and Lessee is currently operating its business and managing its property as a debtor-in-possession. The parties now wish to amend the Agreement in accordance with the terms set forth in this Amendment.
Sample 1

Related to Updating of Specifications

  • Updating of Schedules Borrowers hereby reaffirm the warranties and representations made in Article 5 of the Loan Agreement as true and correct given as of the date hereof, subject to (i) matters therein that were expressly disclosed as of a particular date other than the Closing Date, and (ii) the matters disclosed in the updated complete set of Schedules to the Loan Agreement attached hereto as Exhibit A.

  • Quality Specifications SANMINA-SCI shall comply with the quality specifications set forth in its Quality Manual, incorporated by reference herein, a copy of which is available from SANMINA-SCI upon request.

  • Technical Specifications Each Bloom System is an integrated system comprised of a fuel cell stack assembly and associated balance of plant components that converts a fuel into electricity using electrochemical means that (i) has a Nameplate Capacity of at least 0.5 kilowatts of electricity using an electrochemical process and (ii) has an electricity-only generation efficiency greater than thirty percent (30%).

  • Changes to Specifications All Specifications and any changes thereto agreed to by the parties from time to time shall be in writing, dated and signed by the parties. Any change to the Process shall be deemed a Specification change. No change in the Specifications shall be implemented by Catalent, whether requested by Client or requested or required by any Regulatory Authority, until the parties have agreed in writing to such change, the implementation date of such change, and any increase or decrease in costs, expenses or fees associated with such change (including any change to Unit Pricing). Catalent shall respond promptly to any request made by Client for a change in the Specifications, and both parties shall use commercially reasonable, good faith efforts to agree to the terms of such change in a timely manner. As soon as possible after a request is made for any change in Specifications, Catalent shall notify Client of the costs associated with such change and shall provide such supporting documentation as Client may reasonably require. Client shall pay all costs associated with such agreed upon changes. If there is a conflict between the terms of this Agreement and the terms of the Specifications, this Agreement shall control. Catalent reserves the right to postpone effecting changes to the Specifications until such time as the parties agree to and execute the required written amendment.

  • Notice of Special Matters The Corporation covenants with the Warrant Agent that, so long as any Warrant remains outstanding, it will give notice to the Warrant Agent and to the Registered Warrantholders of its intention to fix a record date that is prior to the Expiry Date for any matter for which an adjustment may be required pursuant to Section 4.1. Such notice shall specify the particulars of such event and the record date for such event, provided that the Corporation shall only be required to specify in the notice such particulars of the event as shall have been fixed and determined on the date on which the notice is given. The notice shall be given in each case not less than 14 days prior to such applicable record date. If notice has been given and the adjustment is not then determinable, the Corporation shall promptly, after the adjustment is determinable, file with the Warrant Agent a computation of the adjustment and give notice to the Registered Warrantholders of such adjustment computation.

  • Specification Changes (a) During the Term, GSK will accept a labeling change from Prometheus as contemplated by this Section 4.2 but otherwise the Parties acknowledge and agree that GSK does not intend to make any material changes (such as packaging design, manufacturing process or similar or related changes) to the existing Product during the Term.

  • Update of Schedules Schedules 7.05(b) (in respect of the lists of Patents, Copyrights and Trademarks under Section 7.05(b)(i) only), 7.05(c), 7.06, and 7.16, may be updated by Borrower prior to each Borrowing Date to insure the continued accuracy of such Schedule as of such Borrowing Date, by Borrower providing to the Lenders, in writing (including via electronic means), a revised version of such Schedule in accordance with the provisions of Section 12.02. Each such updated Schedule shall be effective immediately upon the receipt thereof by the Lenders.

  • Updates Each Affected Person agrees that if any form or certification it previously delivered pursuant to this Section 5.03 expires or becomes obsolete or inaccurate in any respect, it shall update such form or certification or promptly notify the Borrower and the Administrative Agent in writing of its legal inability to do so.

  • Specifications Shipper will ensure that all of its Products tendered at the Origin Point for transportation on the Pipeline System meet the applicable specifications for the Product as set forth in the Tariff (as defined below) (the “Specifications”).

  • Product Specifications The Company agrees that all Products sold to Xxxx hereunder shall conform to the respective specifications set forth on Schedule A or to such other specifications as are from time to time agreed upon by the Parties.

Time is Money Join Law Insider Premium to draft better contracts faster.