Unsafe Condition. Where an unsafe condition is alleged to exist, the affected employee shall first notify his / her immediate supervisor who shall take whatever necessary corrective action the supervisor deems appropriate. Where an unsafe condition is alleged to exist by the Union on behalf of affected employees, or the matter referred by the employee to the supervisor is not resolved to the satisfaction of the employee, the matter will be submitted to the next LMC for discussion. Nothing in this Article requires the Employer to take any corrective actions, and matters raised herein are not subject to the Dispute Resolution Procedures.
Unsafe Condition. The product contains design features where experience with other products in service has shown an unsafe condition might occur in that product, even though compliance with the regulations in the VA Certification Basis can be demonstrated. Unsafe is measured with respect to the overall level of safety intended by the product VA Certification Basis. Note: This principle of “unsafe condition” should not be used to upgrade the level of safety of the product unless the VA has mandated, or will immediately mandate, in accordance with its own regulation, that upgraded safety to products with similar design features for which it is responsible.
Unsafe Condition. If an employee has justifiable reason to believe that his safety is in danger due to an alleged unsafe working condition or alleged unsafe equipment, he must inform his supervisor and may inform the appropriate Union official. Serious disputes may necessitate the decision of the division head. Allegations of an unsafe working condition or equipment will not be applicable unless substantiated in writing as to date, time and witnesses involved. The requirement that there be a prompt resolution to safety disputes is of utmost concern to the City of Galesburg.
Unsafe Condition a) Any fixture or jig or moving machine which is in an unsafe or hazardous condition, shall be "red tagged" until it is made whole.
Unsafe Condition. This AD was prompted by a report of broken and bent attachment bolts of the main rotor (MR) hub scissors assembly and a determination that additional part markings of the washer, scissor branch, and mast ring of the corresponding nut side, and repetitive inspections of those part markings, are necessary to detect any rotation. The FAA is issuing this AD to address broken and bent attachment bolts of the MR xxx scissors assembly, which could lead to detachment of a MR hub scissors attachment bolt, possibly resulting in complete loss of control of the helicopter.
Unsafe Condition. MOVE. In the event of a relocation of employees due to unsafe or unhealthy conditions, the Union will be notified as soon as practicable.
Unsafe Condition. This AD was prompted by a report that the pitot probes are indicating the wrong airspeed during flight in icing conditions. We are issuing this AD to correct the unsafe condition on these products.
Unsafe Condition. If the Employer determines that an unsafe condition exists at any clinic, employees may be transferred temporarily to another clinic at the Employer's option unless the employee can demonstrate the transfer would cause undue hardship. If not transferred, the employee may take vacation, sick time or unpaid hours.
Unsafe Condition. Despite any other Contract provision, if Contractor discovers an unsafe condition or Regulated Substance release at a Work Site, it must notify immediately Company and any applicable regulatory authority and suspend Work Site performance, pending Company’s decision on course of action. Although Company has no duty to supervise, Company may suspend Services (per Suspension (Section 8.1)) upon learning of an unsafe condition. If Contractor action or inaction caused or exacerbated the condition, Contractor must restore to the prior condition, without Contract Price or Contract Time adjustment.
Unsafe Condition the Set-out Site is not safely accessible to Vehicles or Contractor’s employees.
