LIVING WAGE An Authorized User subject to a local law establishing a “living wage”, such as Section 6-109 of the New York City Administrative Code, is required to ensure the Contractor sought to be hired complies with such local law. If the pay rate(s) for a job title(s) as set forth in Appendix E – Pricing Pages, are less than the local law “living wage” than Authorized User subject to such local law cannot use this Contract for such job title(s). Local laws, however, are not a term and condition of the OGS Contract. PREVAILING WAGE RATES - PUBLIC WORKS AND BUILDING SERVICES CONTRACTS Work being done under a resulting Authorized User Agreement may be subject to the prevailing wage rate provisions of the New York State Labor Law. Such work will be identified by the Authorized User within the RFQ. See “Prevailing Wage Rates – Public Works and Building Services Contracts’ in Appendix B, Clause 10, OGS General Specifications. Any federal or State determination of a violation of any public works law or regulation, or labor law or regulation, or any OSHA violation deemed "serious or willful" may be grounds for a determination of vendor non-responsibility and rejection of proposal. The Prevailing Wage Case Number for this Contract is PRC# 2014011745. The Prevailing Wage Rates for various occupations and General Provisions of Laws Covering Workers on Article 8 Public Work Contract can be accessed at the following NYS Department of Labor website: xxxx://xxx.xxxxx.xxxxx.xx.xx/wpp/xxxxXxxxXxxxxxx.xx?method=showIt Insert PRC# 2014011745 in the box provided and click Submit. Click Wage Schedule located underneath the main header of this page. The PDF file may be searched to obtain the Prevailing Wage Rate for a specific occupation. SHORT TERM EXTENSION In the event a replacement Contract has not been issued, any Contract let and awarded hereunder by the State, may be extended unilaterally by the State for an additional period of up to three (3) months upon notice to the Contractor with the same terms and conditions as the original Contract including, but not limited to, prices and delivery requirements. With the concurrence of the Contractor, the extension may be for a period of up to six (6) months in lieu of three (3) months. However, this extension terminates should the replacement Contract be issued in the interim. PROCUREMENT INSTRUCTIONS Authorized Users should refer to Attachment 1 – How to Use the Manufacturer Umbrella Contract for specific instructions on the usage of this Contract. OGS reserves the right to unilaterally make revisions, changes and/or updates to Attachment 1 – How to Use the Manufacturer Umbrella Contract without processing a formal amendment and/or modification. SPECIFICATIONS During the term of the Contract, the Authorized User may request Product specifications for particular items that have been included by the Contractor in Appendix E – Pricing Pages. These specifications will be provided by the Contractor at no cost.
Minimum Wages a. All laborers and mechanics employed or working upon the site of the work, will be paid unconditionally and not less often than once a week, and without subsequent deduction or rebate on any account (except such payroll deductions as are permitted by regulations issued by the Secretary of Labor under the Xxxxxxxx Act (29 CFR part 3)), the full amount of wages and bona fide fringe benefits (or cash equivalents thereof) due at time of payment computed at rates not less than those contained in the wage determination of the Secretary of Labor which is attached hereto and made a part hereof, regardless of any contractual relationship which may be alleged to exist between the contractor and such laborers and mechanics. Contributions made or costs reasonably anticipated for bona fide fringe benefits under section 1(b)(2) of the Xxxxx-Xxxxx Act on behalf of laborers or mechanics are considered wages paid to such laborers or mechanics, subject to the provisions of paragraph 1.d. of this section; also, regular contributions made or costs incurred for more than a weekly period (but not less often than quarterly) under plans, funds, or programs which cover the particular weekly period, are deemed to be constructively made or incurred during such weekly period. Such laborers and mechanics shall be paid the appropriate wage rate and fringe benefits on the wage determination for the classification of work actually performed, without regard to skill, except as provided in 29 CFR 5.5(a)(4). Laborers or mechanics performing work in more than one classification may be compensated at the rate specified for each classification for the time actually worked therein: Provided, That the employer's payroll records accurately set forth the time spent in each classification in which work is performed. The wage determination (including any additional classification and wage rates conformed under paragraph 1.b. of this section) and the Xxxxx-Xxxxx poster (WH–1321) shall be posted at all times by the contractor and its subcontractors at the site of the work in a prominent and accessible place where it can be easily seen by the workers.
Minimum Wage The Contractor and the Surety, in consideration of the award of this Contract to the said Contractor, jointly and severally for themselves, their heirs, executors, administrators, and successors or assigns hereby agree to pay all employees in and about the construction or performance of the work under this Contract in accordance with the schedule of wages contained in the Instructions to Bidders for work in any trade or occupation listed therein. The Contractor shall make wage reports as required by said Instructions. Strict compliance with said minimum wage requirements is demanded by the Owner and shall be considered as of the essence of this Contract. It is hereby agreed that the City of Milwaukee by its Milwaukee Board of School Directors shall have the right at all times to examine all persons employed upon the project by the Contractor and carryon and make such investigations as it may deem necessary to see that the terms of this agreement, relating to such wage payments, are being fully observed.
Driver Training A. All drivers are to be provided with appropriate training and refresher courses each year in the following areas as a minimum: * Proper use of equipment including communications equipment; * Defensive driving; * Emergency and accident procedures; * Identifying unusual passenger behavior; * Student harassment and bullying; * Conducting evacuation drills; * Sensitivity training in working with disabled persons; * Human relation skills in working with parents, school staff, etc; * General vehicle maintenance and pre-trip inspections; and * Map reading and city street coordinates. The Department of Business and Transportation Services may review Contractors’ bus driver training program, upon request.
MINIMUM WAGE LAWS A. Pursuant to the United States of America Fair Labor Standards Act of 1938, as amended, and State of California Labor Code, §1178.5, CONTRACTOR shall pay no less than the greater of the federal or California Minimum Wage to all its employees that directly or indirectly provide services pursuant to this Agreement, in any manner whatsoever. CONTRACTOR shall require and verify that all its contractors or other persons providing services pursuant to this Agreement on behalf of CONTRACTOR also pay their employees no less than the greater of the federal or California Minimum Wage.
London Living Wage 38.1 Without prejudice to any other provision of this Agreement, the Grant Recipient shall (and will ensure that their consultants, contractors and sub-contractors shall):
Training and Education SECTION 1 – Law Enforcement Supervisors’ Training The state and the PBA recognize the importance of supervisor training programs to develop management skills in our law enforcement supervisors. The state will make a reasonable effort to continue existing training programs in law enforcement techniques and to develop new programs in performance review techniques, supervisory skills, and managerial techniques.
Apprentice Wages (a) Apprentices’ rates of pay are set out in Appendix B which includes the description of the calculations.
New Hire Orientation The Union’s Business Representative or designee shall be given the opportunity to make a membership presentation at the employer’s regularly scheduled new employee orientation sessions.
Safety Orientation All employees shall be certified in Safety Orientation. Safety Orientation shall consist of three parts: PART 1 - the CODC Interactive Rights and Responsibilities course; PART 2 - the XXXX course or equivalent, and PART 3 - Employer or Owner Project Specific Training. It is the responsibility of each employee to hold current certification and maintain certification in part 1 and Part 2. The Employer or Owner shall provide to each Employee before commencing work with PART 3 - Employer or Owner Project Specific Training. Each Employee shall be on the payroll and paid while receiving PART 3 training. As a condition of employment it is the sole responsibility of each and every employee to obtain, hold and maintain all current certification(s) in any and all legislated safety training requirements (i.e. WHMIS, Fall Arrest, etc.) that are trade specific. Supporting documentation of all legislated training must be provided by the employee to the Union prior to dispatch and to the employer upon hire and may be further requested by the employer at any time during the duration of their employment. Prior to the expiration of any certification, the Employer will notify the Employee of the pending expiration and give the Employee reasonable time to renew their certification. Further, prior to arriving at site, employees shall hold current qualification(s) for the specific tasks and equipment identified in the dispatch request. If the employee has to be trained after dispatch, all costs borne by the Employer shall be reimbursed by the Training Fund. The CODC Harassment Policy and Procedures, including the provisions regarding General Harassment and as amended from time to time shall be the minimum standard of this Agreement.
