Topographic Survey Services Sample Clauses

Topographic Survey Services. ENGINEER will provide survey support as follows.
Sample 1
AutoNDA by SimpleDocs
Topographic Survey Services. Perform field topographic survey, within Swedish Hospital private property, for approximately 800 LF of water main installation, approximately 260 LF of new water and fire service lines, including new meter/DCDA installations, to locate and show existing surface conditions and approximate locations of buried utilities within project limits, using electronic surveying equipment and one or two-person crew. • Request and review available franchise utility companies’ record drawings information including underground power, gas, telephone, fiber optic, and other known utilities, and incorporate into the base drawings. • Review records provided by Swedish Hospital for locations of under drains and private drains and side sewers and incorporate into design base drawings as applicable. • Provide underground utility locates (through services of a subcontractor to the Consultant) for franchise utilities to field xxxx approximate horizontal locations of existing buried utilities, excluding water main and services, side sewers, under drains and private drains. Services will include the following: o Preliminary research and review of available City, Swedish Hospital, and utility companies’ record drawings to confirm approximate locations. o Provide utility paint marks of existing known utilities prior to field survey. • Reduce field data and prepare survey base drawings for design. Base drawings will typically be established using 1 inch = 20 feet drawing scale and will include two-foot contour intervals. • Horizontal and vertical control will be compatible with NAD 83 Horizontal datum and NAVD 88 Vertical Datum. GPS surveying methodology will be employed where practical and feasible. • Property and rights-of-way boundaries will be as shown on available City or County GIS. Property addresses and/or parcel numbers will be shown for each parcel adjacent to the work. Assumptions: • Utility locates performed for design purposes are not exact locations and may be incomplete. Construction contractor should rely on utility locates performed by representatives of the utility purveyor, made in response to Utility Notification Center (one-call) process and on potholing at time of construction. The utility locates performed by the City, Stantec, and Stantec’s utility locates subcontractor (APS) will be suitable for design purposes and will not be confirmed by potholing during design. If required, selective utility potholing would be performed under the contingent item of work 8, ...
Sample 1
Topographic Survey Services. The topographic survey will be prepared at a scale of 1 inch = 20 feet and relative to NAVD 88 elevations consistent with FEMA mapping. Topography limits shown in red on exhibit. Contours will be shown at 1-foot intervals, with spot shots at 50-foot intervals taken to 0.01 foot on hard surfaces and drainage inverts and 0.1 foot on other surfaces. Utilities will be shown based on locations by Tennessee-One-Call and available mapping from local utilities.
Sample 1
Topographic Survey Services a. Detailed terrestrial topographic survey data will be collected within the approximate limits identified on Exhibit A, to identify the following information:
Sample 1

Related to Topographic Survey Services

  • Topographic Survey 3.1 Notify affected property owners of pending survey.

  • SERVICE MONITORING, ANALYSES AND ORACLE SOFTWARE 11.1 We continuously monitor the Services to facilitate Oracle’s operation of the Services; to help resolve Your service requests; to detect and address threats to the functionality, security, integrity, and availability of the Services as well as any content, data, or applications in the Services; and to detect and address illegal acts or violations of the Acceptable Use Policy. Oracle monitoring tools do not collect or store any of Your Content residing in the Services, except as needed for such purposes. Oracle does not monitor, and does not address issues with, non-Oracle software provided by You or any of Your Users that is stored in, or run on or through, the Services. Information collected by Oracle monitoring tools (excluding Your Content) may also be used to assist in managing Oracle’s product and service portfolio, to help Oracle address deficiencies in its product and service offerings, and for license management purposes.

  • Infrastructure Vulnerability Scanning Supplier will scan its internal environments (e.g., servers, network devices, etc.) related to Deliverables monthly and external environments related to Deliverables weekly. Supplier will have a defined process to address any findings but will ensure that any high-risk vulnerabilities are addressed within 30 days.

  • Geotechnical Services Engineer will obtain all necessary subsurface investigations, tests, reports, and perform related surveys.

  • Network Interconnection Architecture Each Party will plan, design, construct and maintain the facilities within their respective systems as are necessary and proper for the provision of traffic covered by this Agreement. These facilities include but are not limited to, a sufficient number of trunks to the point of interconnection with the tandem company, and sufficient interoffice and interexchange facilities and trunks between its own central offices to adequately handle traffic between all central offices within the service areas at P.01 grade of service or better. The provisioning and engineering of such services and facilities will comply with generally accepted industry methods and practices, and will observe the rules and regulations of the lawfully established tariffs applicable to the services provided.

  • PUBLIC WORKS AND BUILDING SERVICES CONTRACTS Work being done under a resulting Authorized User Agreement may be subject to the prevailing wage rate provisions of the New York State Labor Law. Such work will be identified by the Authorized User within the RFQ. See “Prevailing Wage Rates – Public Works and Building Services Contracts’ in Appendix B, Clause 10, OGS General Specifications. Any federal or State determination of a violation of any public works law or regulation, or labor law or regulation, or any OSHA violation deemed "serious or willful" may be grounds for a determination of vendor non-responsibility and rejection of proposal. The Prevailing Wage Case Number for this Contract is PRC# 2014011745. The Prevailing Wage Rates for various occupations and General Provisions of Laws Covering Workers on Article 8 Public Work Contract can be accessed at the following NYS Department of Labor website: xxxxx://xxxxxxxxxxxx.xxxxx.xx.xxx/wpp/xxxxXxxxXxxxxxx.xx?method=showIt  Insert PRC# 2014011745 in the box provided and click Submit.  Click Wage Schedule located underneath the main header of this page. The PDF file may be searched to obtain the Prevailing Wage Rate for a specific occupation. SHORT TERM EXTENSION In the event a replacement Contract has not been issued, any Contract let and awarded hereunder by the State, may be extended unilaterally by the State for an additional period of up to 3 months upon notice to the Contractor with the same terms and conditions as the original Contract including, but not limited to, prices and delivery requirements. With the concurrence of the Contractor, the extension may be for a period of up to 6 months in lieu of 3 months. However, this extension terminates should the replacement Contract be issued in the interim. PROCUREMENT INSTRUCTIONS Authorized Users should refer to the documents attached as Appendix G – Processes and Forms Templates for specific instructions on the usage of this Contract. OGS reserves the right to unilaterally make revisions, changes, additions and/or updates to the documents attached as Appendix G - Processes and Forms Templates without processing a formal amendment and/or modification. SPECIFICATIONS During the term of the Contract, the Authorized User may request Product specifications for particular items that have been included by the Contractor in its Pricing Pages. These specifications will be provided by the Contractor at no cost.

  • SCOPE OF ARCHITECT’S BASIC SERVICES 3.1 The Architect’s Basic Services consist of those described in this Article 3 and include usual and customary structural, mechanical, and electrical engineering services. Services not set forth in this Article 3 are Supplemental or Additional Services.

  • Professional Engineering and Architect’s Services Professional Engineering and Architect’s Services are not permitted to be provided under this Agreement. Texas statutes prohibit the procurement of Professional Engineering and Architect’s Services through a cooperative agreement.

  • Sites Sites shall mean the locations set forth in the Contract Documentation.

  • Engineering Forest Service completed survey and design for Specified Roads prior to timber sale advertisement, unless otherwise shown in A8 or Purchaser survey and design are specified in A7. On those roads for which Forest Service completes the design during the contract, the design quantities shall be used as the basis for revising estimated costs stated in the Schedule of Items and adjusting Timber Sale Account. Forest Service engineering shall be completed according to the schedule in A8. Should Forest Service be unable to perform the designated survey and design by the completion date or other agreed to time, upon written agreement, Purchaser shall assume responsibility for such work. In such event, Contracting Officer shall revise:

Time is Money Join Law Insider Premium to draft better contracts faster.