Thickness. The nominal thickness of the unprinted film including adhesive shall be between 0.070mm to 0.090mm. The test procedure for measuring thickness is ASTM D 3652.
Thickness. 4.2.1 Standard thickness ***
Thickness. The Thickness is measured in approximately 7 grams force per setting and has 33 levels. In other words, the Silhouette can cut from 7 grams up to 230 grams force. Thicker materials will likely require higher Thickness levels. Double Cut – This check box will have the Silhouette cut through all lines present in your cutting area twice. It may be necessary when cutting thicker materials in order to obtain a cleaner cut. Cutting Mat – This check box notifies the program as to whether or not you are using the Silhouette’s cutting mat (sticky cutting mat). This option may only be selected for material sizes that do not exceed the ability to load materials onto the cutting mat. Many specialty material types offered by Silhouette America will have their own backing and so do not require the use of the cutting mat. However, if your material is either too narrow to be gripped by the rollers or does not have its own adhesive backing, you must check this option.
Thickness. The width of the supplied material shall have a minimum average thickness of 2.3 mm (90 mils).
Thickness. The film, without adhesive, shall have a minimum thickness of 1.55mm (60 mil).
Thickness. 1/4-inch (6 mm) 1/2-inch (13 mm) Type X, 5/8 inch (16 mm) thick.
Thickness i. Base Layer: 1-1/2 inches (38 mm) <Insert thickness>.
Thickness. Thickness of Sheet shall be 2.0mm 3.3 Xxxxx ances: As per BS 7531 4.0 SIZE AND FACE: Gasket Sheet Size (in mm) shall be as per BHEL Enquir y/ Or der . 5.0 DESIGNATION: Non Metallic Gasket Sheet as per BS 7531 Xx xxx X for Flat Face Flange connections. Shall be designated as “ NAB Sheet BS 7531 Grade X”. 6.0 TEST CERTIFICATES: Three copies of test cer tificates consisting of mechanical pr operties and chemical composition of the metals shall be fur nished. 7.0
Thickness a. For signs up to 20 sq. in., minimum 1/16 inch thick.
Thickness. The total pavement thickness of the HMA pavement will be based on a specified spread rate or plan thickness as shown in the Contract Documents. Before paving, propose a spread rate or thickness for each individual layer meeting the requirements of this specification, which when combined with other layers (as applicable) will equal the plan spread rate or thickness. When the total pavement thickness is specified as plan thickness, the plan thickness and individual layer thickness will be converted to spread rate using the following equation: Spread rate (lbs/yd2) = t x Gmm x 43.3 where: t = Thickness (in.) (Plan thickness or individual layer thickness) Gmm = Maximum specific gravity from the mix design For target purposes only, spread rate calculations shall be rounded to the nearest whole number.
