The Regional Value Content Sample Clauses

The Regional Value Content. 1. Annex 4.1 (where specific rules of origin) specifies a regional value content test to determine whether a product is originating, each Party shall provide to the person requesting preferential tariff treatment for the good to calculate the regional value content based on one of the following methods:
AutoNDA by SimpleDocs
The Regional Value Content. 1. The regional value content of the goods shall be calculated according to the following formula: Vt-vmn VCR = _ × 100 Or Where: VCR is the regional value content, expressed as a percentage; VL is the transaction value of the good adjusted on a FOB basis, except as provided in paragraph 3. in the event that there is no value or cannot be determined according to the principles of article 1 of the Customs Valuation Agreement; the same shall be calculated in accordance with this Agreement and: Vmn is the transaction value of non-originating materials adjusted on a CIF basis, except as provided in paragraph 5. in the event that there is no value or cannot be determined according to the principles of article 1 of the Customs Valuation Agreement; the same shall be calculated in accordance with this Agreement.
The Regional Value Content. 1. The regional value content (hereinafter VCR) of a good shall be calculated on the basis of the following method: FOB - vmn X VCR = 100 FOB Where: VCR: is the regional value content, expressed as a percentage; : is the FOB value of the good free on board in accordance with article 3.35; and Vmn: is the value of non-originating materials.
The Regional Value Content. The regional value content of the goods shall be calculated on the basis of the transaction value method, which shall apply to the following formula: VCR=[(VT-VMN)/VT]*100 Where: VCR = regional value content, expressed as a percentage. VT = the transaction value of the good adjusted on the basis of FOB VMN = non-originating goods value of the Parties used in the production of the good. It is obtained from subtract the transaction value of the good or the value of the non-originating goods used in the region in the development or production, and shall be divided between the transaction value of the same; all of which is multiplied by 100. When the producer of a good exported not directly, the transaction value shall be adjusted to the point at which the buyer receives the good within the territory where the producer is located. When the origin is determined by the regional value content of the required percentage specified in annex corresponding to the specific rules of origin. All costs considered for the calculation of regional value content shall be recorded and maintained in accordance with generally accepted accounting principles applicable in the territory of the Party where the good is produced.

Related to The Regional Value Content

  • DATA USED FOR CALCULATIONS The calculations for payments under this Agreement shall be initially based upon the valuations that are placed upon all taxable property in the District, including the Applicant’s Qualified Property, by the Appraisal District in its annual certified tax roll submitted to the District for each Tax Year pursuant to TEXAS TAX CODE § 26.01 on or about July 25 of each year of this Agreement. Immediately upon receipt of the valuation information by the District, the District shall submit the valuation information to the Third Party selected and appointed under Section 4.3. The certified tax roll data shall form the basis of the calculation of any and all amounts due under this Agreement. All other data utilized by the Third Party to make the calculations contemplated by this Agreement shall be based upon the best available current estimates. The data utilized by the Third Party shall be adjusted from time to time by the Third Party to reflect actual amounts, subsequent adjustments by the Appraisal District to the District’s certified tax roll or any other changes in student counts, tax collections, or other data.

  • Service Content SORACOM Air Global Service contains the following services. Subscription (plan) Content plan01s It is suitable for IoT/M2M equipment. plan01s - Low Data Volume It is suitable for IoT/M2M equipment. Especially, it is suitable for small data usage. plan01 plan01 can be purchased in the USA and Japan. It is characterized by a wide coverage area. plan01 - Low Data Volume plan01 - Low Data Volume can be purchased in the USA and Japan. It is suitable for small data usage. plan02 plan02 can be purchased in Europe. Data communication charges are kept low in Europe and it is suitable for use in Europe. Subscription (Speed Class) Content s1 class Data Transmission Service that adjusts the outgoing and incoming transmission speed between the terminal and SORACOM so that the transmission is symmetrical

  • Minimum Site Requirements for TIPS Sales (when applicable to TIPS Sale). Cleanup: When performing work on site at a TIPS Member’s property, Vendor shall clean up and remove all debris and rubbish resulting from their work as required or directed by the TIPS Member or as agreed by the parties. Upon completion of work, the premises shall be left in good repair and an orderly, neat, clean and unobstructed condition. Preparation: Vendor shall not begin a project for which a TIPS Member has not prepared the site, unless Vendor does the preparation work at no cost, or until TIPS Member includes the cost of site preparation in the TIPS Sale Site preparation includes, but is not limited to: moving furniture, installing wiring for networks or power, and similar pre‐installation requirements. Registered Sex Offender Restrictions: For work to be performed at schools, Vendor agrees that no employee of Vendor or a subcontractor who has been adjudicated to be a registered sex offender will perform work at any time when students are, or reasonably expected to be, present unless otherwise agreed by the TIPS Member. Vendor agrees that a violation of this condition shall be considered a material breach and may result in the cancellation of the TIPS Sale at the TIPS Member’s discretion. Vendor must identify any additional costs associated with compliance of this term. If no costs are specified, compliance with this term will be provided at no additional charge. Safety Measures: Vendor shall take all reasonable precautions for the safety of employees on the worksite, and shall erect and properly maintain all necessary safeguards for protection of workers and the public. Vendor shall post warning signs against all hazards created by the operation and work in progress. Proper precautions shall be taken pursuant to state law and standard practices to protect workers, general public and existing structures from injury or damage. Smoking: Persons working under Agreement shall adhere to the TIPS Member’s or local smoking statutes, codes, ordinances, and policies.

  • NASPO ValuePoint Summary and Detailed Usage Reports In addition to other reports that may be required by this solicitation, the Contractor shall provide the following NASPO ValuePoint reports.

  • Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.

  • Technical References Technical References that describe the practices, procedures and specifications for certain services (and the applicable interfaces relating thereto) are listed on Schedule 2.3 (the “Technical Reference Schedule”) to assist the Parties in meeting their respective responsibilities hereunder.

  • Multiple Listing Service (MLS). Due to rules administered by the local Multiple Listing Service (“MLS”), all details of any transaction that are procured by the Agency may be used for publication in the MLS. Seller hereby consents to such publication on an unrestricted basis whereas the Agency must comply with all applicable MLS rules to allow data about the Property to be shown and made available by the MLS in addition to other internet websites. MLS rules generally provide that any property entered into its database be updated within forty-eight (48) hours, or some other period of time, after all necessary signatures have been obtained in regard to the Property. The Seller has the right to prohibit any and all publication of information in regard to a transfer of the Property. In order to exercise this right, the Seller is required to authorize a separate addendum provided by the Agency and attach to this Agreement.

Draft better contracts in just 5 minutes Get the weekly Law Insider newsletter packed with expert videos, webinars, ebooks, and more!