Testing Equipment. The Contractor shall be responsible for providing all of the specialist tools and test equipment necessary to carry out the maintenance of the Security equipment and validate that the equipment is operating correctly to the optimum performance settings.
Testing Equipment. (a) Cylinder Molds. Provide an ample supply of cylinder molds for the casting of test cylinders. All molds are subject to approval of the Engineer. Use 6" x 12" cylinders. The Engineer may approve the use of 4" x 8" cylinders, provided reliable correction factors have been developed and submitted, along with supporting data, for review and acceptance.
Testing Equipment. The goal is to accurately measure the TRUE power consumption2 of the MFD. This necessitates the use of a True RMS Watt-Hour Meter, one per phase, accurate to three figures. There are many Watt-hour meters to choose from, but manufacturers will need to exercise care in selecting an appropriate model. The following factors should be considered when purchasing a meter and setting up the actual test. Crest Factor To begin, it is important to understand that MFDs which contain switching power supplies draw current in a waveform different from typical sinusoidal current.3 Figure 1 shows the typical current 2True power is defined as (volts)x(amps)x(power factor), and is typically reported as Xxxxx. Apparent power is defined as (volts)x(amps) and is usually expressed in terms of VA or volt-amps. The power factor for equipment with switching power supplies is always less than 1.0; so true power is always less than apparent power.
Testing Equipment. The testing equipment described in detail on Schedule 2.2(a)(i);
Testing Equipment. Noise measuring equipment will include sound level measuring devices, which must meet Type O, or 1 specification under American National Standards Institute S1.4-1983. A loudspeaker with a directional characteristic, which at 2000 Hz the free- field radiated sound pressure, up to an angle of 45 degrees, shall not be more than 6 dB different from the on-axis sound pressure. The test signal to be emitted through the loudspeaker should be Pink Noise.
Testing Equipment. Within the ninety (90) days after the Effective Date, SLT may purchase from Reliant the testing equipment set forth below at Reliant's replacement cost for such item as set forth below, the terms and conditions of any such sale to be set forth in a separate written purchase order:
Testing Equipment. The Agency shall use disposable thermometers for testing the urine samples or otherwise preclude the possibility of contamination by the thermometer.
Testing Equipment. 33.2.1 GIS testing equipment as per the Technical specification. SET 1 34 ESSENTIAL TOOLS and SPARES for GIS
Testing Equipment. Calibrated at reasonable intervals with devices of an accuracy traceable to either the National Bureau of Standards or to the accepted values of natural physical constants.
Testing Equipment. The arrays measurements carried out by the RU8 were performed using between 13 and 17 EDL 24bit acquisition systems equipped with short-period Mark-L4-C-3D 1Hz sensors and GPS timing. The unique exception was BVG, where 15 LE-3D/5s sensors coupled with Reftek 130 digitizers (24bit) were adopted. In this case, measurements were carried out by INGV-Mi in September 2007.
