Test 2 Sample Clauses

Test 2. For activation of BAS The vehicle shall be driven in a straight line at the test speed specified in paragraph 2.4. of this section. The driver shall apply the brake pedal quickly according to Figure 2, simulating emergency braking so that BAS is activated and ABS is fully cycling. In order to activate BAS the brake pedal shall be applied as specified by the car manufacturer. The manufacturer shall notify the Technical Service of the required brake pedal input at the time of submission of the application for type-approval. It shall be demonstrated to the satisfaction of the Technical Service that the BAS activates under the conditions specified by the manufacturer in accordance with paragraph 22.1.2. or 22.1.3 of Annex 1. After t = t0 + 0.8 s and until the vehicle has slowed down to a speed of 15 km/h, the brake pedal force shall be maintained in a corridor between FABS, upper and FABS, lower, where FABS, upper is 0.7 FABS and FABS, lower is 0.5 FABS. The requirements are also considered to be met if, after t = t0 + 0.8 s, the pedal force falls below FABS, lower provided the requirement of paragraph 4.3. is fulfilled.
Sample 1Sample 2See All (6)
AutoNDA by SimpleDocs
Test 2. The publisher, consistent with any rights it may have in the Book under the author-publisher contract, publicly has announced to the trade that it has undertaken concrete steps to publish an existing or new edition of the Book, and that edition is published within twelve months of the announcement.
Sample 1
Test 2. For activation of BAS
Sample 1

Related to Test 2

  • Drug Test Results 1. All records pertaining to department-required drug tests shall remain confidential, and shall not be provided to other employers or agencies without the written permission of the person whose records are sought. However, medical, administrative, and immediate supervisory personnel may have access to relevant portions of the records as necessary to insure the acceptable performance of the officer's job duties.

  • Test method 3.3.1. The method used shall be that described in Annex 3, paragraph 3.1.

  • Test The outer surface of the lamp lenses shall be subjected once or more than once to the action of the sand jet produced as described above. The jet shall be sprayed almost perpendicular to the surface to be tested. The deterioration shall be checked by means of one or more samples of glass placed as a reference near the lenses to be tested. The mixture shall be sprayed until the variation in the diffusion of light on the sample or samples measured by the method described in Appendix 2, is such that: Δ d = (T5 - T4) / T2 ≤ 0.0250 ± 0.0025 Several reference samples may be used to check that the whole surface to be tested has deteriorated homogeneously. Annex 6 - Appendix 4

  • Test procedure The engine speed shall be gradually increased from idle to the target engine speed, not exceeding the tolerance band of ±3 per cent of the target engine speed, and held constant. Then the throttle control shall be rapidly released and the engine speed shall be returned to idle. The sound pressure level shall be measured during a period of operation consisting of a maintaining constant engine speed of 1 second and throughout the entire deceleration period. The maximum sound level meter reading during this period of operation, mathematically rounded to the first decimal place, is taken as the test value.

Time is Money Join Law Insider Premium to draft better contracts faster.