Tensile test Sample Clauses

Tensile test. 2.1.2.2.1. Tensile test on parent metal
Sample 1Sample 2Sample 3See All (6)
AutoNDA by SimpleDocs
Tensile test. The tensile properties of welded steel in the inner vessel shall be tested in accordance with EN 895:1995 and EN 6892-1:2009.
Sample 1Sample 2Sample 3See All (5)
Tensile test. The tensile strength, yield strength and percentage elongation of steel shall be determined from standard test pieces cut either lengthwise or crosswise from plates. The tests shall be carried out on the standard test piece prepared in accordance with test edition of IS 1608 or its international equivalent standard. The tensile strength, yield strength and percentage elongation of steel should not be less than the specified values in Table 4-5. Only proportional test piece complying with the requirement Lo = 5.65√So should be used for the tensile test, where Lo is the gauge length and So is the cross-sectional area of the test piece. Number of Tensile Tests - For every 500 tons of finished steel, one tensile test shall be conducted.
Sample 1Sample 2
Tensile test. The finished stay sets when subject to tensile test shall comply with the requirement of the tensile strength as per the table given below: X.Xx. Diameter of rods Breaking load
Sample 1

Related to Tensile test

  • Performance Testing 7.2.1 The Design-Builder shall direct and supervise the tests and, if necessary, the retests of the Plant using Design-Builder’s supervisory personnel and the Air Emissions Tester shall conduct the air emissions test, in each case, in accordance with the testing procedures set forth in Exhibit A (the “Performance Tests”), to demonstrate, at a minimum, compliance with the Performance Guarantee Criteria. Owner is responsible for obtaining Air Emissions Tester and for ensuring Air Emissions Tester’s timely performance. Design-Builder shall cooperate with the Air Emissions Tester to facilitate performance of all air emissions tests. Design-Builder shall not be held responsible for the actions of Owner’s employees and third parties involved in the Performance Testing, including but not limited to Air Emissions Tester.

  • Drug Test A urinalysis test administered under approved conditions and procedures to detect drugs by a laboratory certified in accordance with Department of Health and Human Services rules and regulations.

  • Test The outer surface of the lamp lenses shall be subjected once or more than once to the action of the sand jet produced as described above. The jet shall be sprayed almost perpendicular to the surface to be tested. The deterioration shall be checked by means of one or more samples of glass placed as a reference near the lenses to be tested. The mixture shall be sprayed until the variation in the diffusion of light on the sample or samples measured by the method described in Appendix 2, is such that: Δ d = (T5 - T4) / T2 ≤ 0.0250 ± 0.0025 Several reference samples may be used to check that the whole surface to be tested has deteriorated homogeneously. Annex 6 - Appendix 4

  • Drug Testing (A) The state and the PBA agree to drug testing of employees in accordance with section 112.0455, F.S., the Drug-Free Workplace Act.

  • Acceptance Testing At the time of installation of a LIS trunk group, and at no additional charge, acceptance tests will be performed to ensure that the service is operational and meets the applicable technical parameters.

  • ACCEPTANCE TESTS 11.1 If the Contract provides acceptance tests for Goods and/or the result of Services after their completion and/or delivery to the Purchaser, the acceptance shall only be considered as definitive when such tests have demonstrated the compliance of the Goods and/or the result of the Services to the requirements in the Contract.

Time is Money Join Law Insider Premium to draft better contracts faster.