Grant Amount The maximum amount payable by the State under this Agreement shall not exceed $2,000,000
Full-Time Equivalent (FTE) and Employer Contributions a) The FTE used to determine the Board’s benefits contributions will be based on the average of the Board’s FTE as of October 31st and March 31st of each year.
Payment for annual leave (a) Before going on annual leave, an employee will be paid the amount of wages they would have received for ordinary time worked had they not been on leave during that period.
Calculation of Annual Leave Pay Annual leave shall be paid at the employee’s ordinary weekly wage rate for ordinary hours for the period of annual leave (excluding shift allowances and weekend payments but including leading hand allowance); plus an amount equal to 17.5% of the amount
Payment for Unused Sick Leave a. An employee with less than ten (10) years of continuous University service, as defined herein, who separates from the University shall not be paid for any unused sick leave. For employees appointed on or before 1/7/03 University service includes continuous employment by the University or the State of Florida.
Adjustment for Excess Volume If Sale Area Map indicates that there are incompletely Marked subdivisions and if Contracting Officer determines that the volume cut will be more than 120 percent of the total es- timated volume listed in A2, Forest Service, upon request by Purchaser, shall make an adjustment in Marking or cutting unit boundaries with the objective of designating for cutting the approximate estimated volumes by species listed in A2. Such adjustments in volumes shall be con- fined to (a) Marking adjustments on Sale Area and (b) re- duction in area to be cut over. Such adjustments or re- ductions shall not conflict with the silvicultural treatment being applied on Sale Area and shall not materially change the average value by species of the timber desig- nated for cutting. Such adjustments may be made not- withstanding the provisions of B1.1 and B2.3. If the timber designated for cutting is not reduced by such adjustments to less than 120 percent of the total es- timated quantity listed in A2, Purchaser, after cutting 120 percent of the total estimated volume listed in A2, may elect to have Sale Area reduced to eliminate the remain- ing Included Timber. However, where felling operations have been started, units of minimum practical size shall be retained in Sale Area.
Retirement Formula The City contracts with CalPERS to provide the 2.5% at 55 retirement formula set forth in California Government Code Section 21354.4.
Payment for Working on a Holiday (The following clause is applicable to part-time employees only) The holidays listed in the part-time local Appendix for the purposes of Article 16.03(b) shall be the same holidays as are listed in the full-time Local Provisions Appendix. If an employee is required to work on any of the holidays set out in the local Appendix the employee shall be paid at the rate of time and one-half (1-1/2) her regular straight time hourly rate of pay for all hours worked on such holiday.
Average Log Length and Payment Reduction If the average log length for all logs delivered under this contract is less than the average log length specified in the table in clause G-024.2, The amount of allowable payment reduction shall be calculated by multiplying the payment rate in P-028.2 by the total volume delivered, and the difference between the average length of logs delivered and the average log length specified in G-024.2, times 1% as follows: Log Length Payment Reduction = (B x V x L) x (.01) 1/10th) Where: B = Bid rate from P-028.2 clause V = total delivered log Volume L = Length in feet below specified average (rounded to nearest Average log length payment reductions calculated by the Purchaser must be approved by the State, prior to payment for the final billing period. Third-party scaling organization information is required to determine Xxxxxxxx mbf and Average log length for payment reduction purposes. Average log length is determined on a piece count basis. Value of log length price reduction will be derived from the applicable sort value as described in this contract. Scale information for determining Average log length for payment reduction eligibility must be obtained from roll-out scale. Truck-ramp, sample scaling, and/or bundle scaling information is not acceptable for determining eligibility. Purchaser’s exclusive remedy for below average log lengths shall be the payment reduction described in this clause, notwithstanding other provisions in the Uniform Commercial Code.
