Contract Negotiation Meetings 14.09 When operational requirements permit, the Employer will grant leave without pay to an employee for the purpose of attending contract negotiation meetings on behalf of the Alliance. Preparatory Contract Negotiation Meetings
State Approval of Replacement Personnel The Engineer may not replace the project manager or key personnel without prior consent of the State. The State must be satisfied that the new project manager or other key personnel is qualified to provide the authorized services. If the State determines that the new project manager or key personnel is not acceptable, the Engineer may not use that person in that capacity and shall replace him or her with one satisfactory to the State within forty-five (45) days.
Preparatory Contract Negotiations Meetings Where operational requirements permit, the Employer will grant leave without pay to an employee to attend preparatory contract negotiations meetings.
Contract Negotiations Meetings Where operational requirements permit, the Employer will grant leave without pay to an employee for the purpose of attending contract negotiations meetings on behalf of the Institute.
Contractors Submission Respecting the Agreement The Contractor shall, as part of the Contractor's submission respecting this Contract, complete the attached Schedule B, Identification of Principles; Schedule C, Schedule of Tendered Unit Prices; Schedule D, Schedule of Equipment to be used on the work; and Schedule E, Schedule of Sub-Contractors. The Contract including all appended schedules shall be completed in complete conformity with the instructions to bidders contained in the document entitled "General Provisions and Contract Specification for Highway Construction". In presenting the Contractor’s submission for consideration by the Minister, the Contractor understands that until, and unless, the Contract is endorsed by the Minister, no Contract between the parties shall exist and the Minister shall not be bound to endorse any Contract.
COMMENCEMENT OF WORK UNDER A SOW AGREEMENT Commencement of work as a result of the SOW-RFP process shall be initiated only upon issuance of a fully executed SOW Agreement and Purchase Order.
CALENDAR FOR SUCCESSOR MEMORANDUM OF UNDERSTANDING In the event Union or Management desires a successor MOU, said party shall serve upon the other between April 1, 2018 and April 30, 2018, its written proposals for such successor MOU. Meet and confer sessions shall begin no later than thirty (30) calendar days following submittal of the proposals.
Technical Advisory Committee (TAC The goal of this subtask is to create an advisory committee for this Agreement. The TAC should be composed of diverse professionals. The composition will vary depending on interest, availability, and need. TAC members will serve at the CAM’s discretion. The purpose of the TAC is to: • Provide guidance in project direction. The guidance may include scope and methodologies, timing, and coordination with other projects. The guidance may be based on: o Technical area expertise; o Knowledge of market applications; or o Linkages between the agreement work and other past, present, or future projects (both public and private sectors) that TAC members are aware of in a particular area. • Review products and provide recommendations for needed product adjustments, refinements, or enhancements. • Evaluate the tangible benefits of the project to the state of California, and provide recommendations as needed to enhance the benefits. • Provide recommendations regarding information dissemination, market pathways, or commercialization strategies relevant to the project products. The TAC may be composed of qualified professionals spanning the following types of disciplines: • Researchers knowledgeable about the project subject matter; • Members of trades that will apply the results of the project (e.g., designers, engineers, architects, contractors, and trade representatives); • Public interest market transformation implementers; • Product developers relevant to the project; • U.S. Department of Energy research managers, or experts from other federal or state agencies relevant to the project; • Public interest environmental groups; • Utility representatives; • Air district staff; and • Members of relevant technical society committees. The Recipient shall: • Prepare a List of Potential TAC Members that includes the names, companies, physical and electronic addresses, and phone numbers of potential members. The list will be discussed at the Kick-off meeting, and a schedule for recruiting members and holding the first TAC meeting will be developed. • Recruit TAC members. Ensure that each individual understands member obligations and the TAC meeting schedule developed in subtask 1.11. • Prepare a List of TAC Members once all TAC members have committed to serving on the TAC. • Submit Documentation of TAC Member Commitment (such as Letters of Acceptance) from each TAC member. Products: • List of Potential TAC Members • List of TAC Members • Documentation of TAC Member Commitment
Schedule for Completing Agreement Closeout Activities Provide All Draft and Final Written Products on a CD-ROM or USB memory stick, organized by the tasks in the Agreement. Products: • Final Meeting Agreement Summary (if applicable) • Schedule for Completing Agreement Closeout Activities • All Draft and Final Written Products
PRICING for Markup of Non-Prepriced Items in RS Means Unit Price Book What is your proposed Markup Percentage on materials not found in the RS Means Price Book? If any materials being utilized for a project cannot be found in the RS Means Price Book, this question is what is the markup percentage on those materials? When answering this question please insert the number that represents your percentage of proposed markup. Example: if you are proposing a 30 percent markup, please insert the number "30". Remember that this is a ceiling markup. You may markup a lesser percentage to the TIPS Member customer when pricing the project, but not a greater percentage. EXAMPLE: You need special materials that are not in the RS Means Unit Price Book for a project. You would buy the materials and mark them up to the TIPS Member customer by the percentage you propose in this question. If the materials cost you, the contractor, $100 and you proposed a markup on this question for the material of 30 percent, then you would charge the TIPS Member customer $130 for the materials.
