SUPPLY OF PARTS Sample Clauses

SUPPLY OF PARTS. In addition to the Mixed Signal Modules or Mixed Signal Modifications, and upon request of Ando, LTX shall supply certain parts to Ando for the manufacture of Fusion Test Systems under the System and Parts Supply Agreement or as otherwise mutually agreed.
AutoNDA by SimpleDocs
SUPPLY OF PARTS. The agreement should specify whether a particular type of material or component comes from the operator's or the approved maintenance organisation's store, which type of component is pooled, etc. Attention should be paid on the fact that it is the approved maintenance organisations competence and responsibility to be satisfied that the component in question meets the approved data/standard and to ensure that the aircraft component is in a satisfactory condition for fitment.
SUPPLY OF PARTS. (a) DuPont agrees to sell to Dade all of Dade's --------------- requirements for the Parts; provided, that, unless otherwise agreed to in -------- writing by DuPont, DuPont shall not be required to supply more than one hundred fifty percent (150%) of the minimum requirement for any Part as set forth on Schedule A in any Contract Year (as defined in Paragraph 2 below). ----------
SUPPLY OF PARTS. PRI shall sell to Yoplait, and Yoplait shall purchase and take delivery from PRI the Parts in accordance with the terms of Schedule C, attached hereto and made a part hereof. Purchases of Parts shall be in accordance with Yoplait's written purchase orders submitted to PRI. In the event there is any conflict between the terms of any such purchase order and the terms of this Agreement, the terms of this Agreement shall govern.
SUPPLY OF PARTS. The Dealer will offer actual and potential Customers a supply of BMW Parts which corresponds to such Customers' expectations.
SUPPLY OF PARTS. Notwithstanding termination of this Agreement, a Supplier shall continue to make available to the Distributor on a basis which shall be reasonable, in particular with respect to pricing and availability, sufficient parts to permit the Distributor to continue, after the Term hereof, to supply maintenance services to end users in the Distributor's Territory. 12.6
AutoNDA by SimpleDocs
SUPPLY OF PARTS. Vendor agrees to offer for sale to Facebook, during the term of this Agreement and until three (3) years after the expiration or termination of this Agreement, functionally equivalent maintenance, replacement, and repair parts (“Part(s)”) for the Hardware covered by this Agreement at the same discount level as the discount for the Hardware itself.
SUPPLY OF PARTS. Operator will provide all spares, LRU:s and consumables to the Contractor. Operator is fully responsible for replenish of this stock according to levels decided by its own convenience. Operator shall ensure the supply of spares and consumables needed for maintenance and repair as specified in the Purchase Order. Operator is responsible for component shipping and logistics administration. Contractor shall in cooperation with the Operator suggest alterations of the ranging, scaling and content of the spares stock. Contractor shall inspect all parts and materials in accordance with its MOE procedures prior to installation on the aircraft. Original FLYGI Form 1 or equivalent accepted by FLYGI and provided by the Operator, will be transferred to the operator after installation of equipment.

Related to SUPPLY OF PARTS

  • Removal of parts The Borrower shall not remove any material part of the Ship, or any item of equipment installed on the Ship, unless the part or item so removed is forthwith replaced by a suitable part or item which is in the same condition as or better condition than the part or item removed, is free from any Security Interest or any right in favour of any person other than the Lender and becomes on installation on the Ship the property of the Borrower and subject to the security constituted by the Mortgage Provided that the Borrower may install equipment owned by a third party if the equipment can be removed without any risk of damage to the Ship.

  • Replacement of Parts Except as otherwise provided herein, so long as the Airframe or Engine is subject to the Lien of this Indenture, Owner, at its own cost and expense, will, or will cause a Permitted Lessee to, at its own cost and expense, promptly replace (or cause to be replaced) all Parts which may from time to time be incorporated or installed in or attached to the Aircraft, Airframe or any Engine and which may from time to time become worn out, lost, stolen, destroyed, seized, confiscated, damaged beyond repair or permanently rendered unfit for use for any reason whatsoever. In addition, Owner may, at its own cost and expense, or may permit a Permitted Lessee at its own cost and expense to, remove (or cause to be removed) in the ordinary course of maintenance, service, repair, overhaul or testing any Parts, whether or not worn out, lost, stolen, destroyed, seized, confiscated, damaged beyond repair or permanently rendered unfit for use; provided, however, that Owner, except as otherwise provided herein, at its own cost and expense, will, or will cause a Permitted Lessee at its own cost and expense to, replace such Parts as promptly as practicable. All replacement parts shall be free and clear of all Liens, except for Permitted Liens and pooling arrangements to the extent permitted by Section 4.04(c) below (and except in the case of replacement property temporarily installed on an emergency basis) and shall be in good operating condition and have a value and utility not less than the value and utility of the Parts replaced (assuming such replaced Parts were in the condition required hereunder).

  • Supply of Materials The following materials will be supplied by the department Name of Materials Rate. Place of delivery 1.

  • Supply of Products During the term of this Agreement and any extension hereof, the Seller shall sell and supply the products as set out in Schedule 1 hereto (“Products”) to SiPM and SiPM shall buy from the Seller such Products on a non-exclusive basis. The specifications of the Products are set out in Schedule 2 hereto. SUPPLY AGREEMENT - SiPM A Supply Agreement is a document between two parties, a Supplier and a Purchaser. The Supplier can be an individual or business and is the party that " supplies," or sells, the goods to the Purchaser. The Purchaser can also be an individual or a business and is the party that purchases for its use the goods that the Supplier provides.

  • Supply of Product Salix shall use reasonable efforts to supply the Product during the Co-Promotion Period in sufficient quantities to satisfy the levels of Product sales forecasted in the then current Marketing Plan. Salix shall maintain reasonable inventory levels of the Product in order to ensure their ability to fulfill this obligation. Salix shall have the sole responsibility and right to fill orders with respect to the Product. Altana shall not solicit orders for the Product but, if for any reason, Altana shall receive an order for the Product, Altana shall promptly forward to Salix any such orders. All orders for Product shall be subject to acceptance by Salix, in its sole discretion, which acceptance shall not be unreasonably withheld. Salix may cancel any order for Product at any time after acceptance without incurring any liability to Altana. Salix shall be solely responsible for responding to requests from Target Physicians for individual patients who need the Product but are unable to afford it. Any such request shall be forwarded by Altana to Salix for processing. Salix shall have the sole right and responsibility for establishing and modifying the terms and conditions of the sale of the Product, including (a) the price at which the Product will be sold, (b) whether the Product will be subject to trade or quantity discounts, (c) whether any discount will be provided for payments on accounts receivable, (d) whether the Product will be subject to rebates, returns and allowances or retroactive price reductions, (e) the channels of distribution of the Product, and (f) whether credit [*] Confidential treatment requested; certain information omitted and filed separately with the SEC. is to be granted or refused in connection with any sale of Product. In the event that Salix fails to supply the Product as required pursuant to this Agreement for any reason other than a Force Majeure, which such failure results in lost sales for Altana, the Parties shall meet and attempt to negotiate a mutually agreeable and commercially reasonable solution. If the Parties cannot reach such an agreement within a reasonable period of time, the issue will be dealt with as contemplated under Section 4.4 of this Agreement.

  • Spare Parts 14.1 As specified, the supplier may be required to provide any or all of the following materials, notifications, and information pertaining to spare parts manufactured or distributed by the supplier:

  • Quality Specifications SANMINA-SCI shall comply with the quality specifications set forth in its Quality Manual, incorporated by reference herein, a copy of which is available from SANMINA-SCI upon request.

  • Product Specifications The Company agrees that all Products sold to Xxxx hereunder shall conform to the respective specifications set forth on Schedule A or to such other specifications as are from time to time agreed upon by the Parties.

  • Supply Agreement The Supply Agreement shall have been executed on behalf of the Seller and delivered to the Purchaser.

  • Technical Specifications The Technical Specifications furnished on the CD are intended to establish the standards for quality, performance and technical requirements for all labor, workmanship, material, methods and equipment necessary to complete the Work. When specifications and drawings are provided or referenced by the County, these are to be considered part of the Scope of Work, and to be specifically documented in the Detailed Scope of Work. For convenience, the County supplied specifications, if any, and the Technical Specifications furnished on the CD.

Time is Money Join Law Insider Premium to draft better contracts faster.