Supervisory Control And Data Acquisition (SCADA. 8.1 In addition to the monitoring of the integrity of the Audio Transport Stream at the Signal Interface Points and transmitter outputs as outlined in Section 3 and 7 of this Appendix A, the Service Provider operates a SCADA system and this is used to control and monitor the System performance. There are two levels of interface with the transmission sites:
Supervisory Control And Data Acquisition (SCADA. 3.1 Interconnection Points containing SCADA and communications equipment installed prior to the Effective Date shall be considered to satisfy the terms and conditions of this Article 4. Local Distribution Company shall install and operate such SCADA and communications equipment as is necessary, consistent with Good Utility Practice and ERO and RRO requirements for Transmission Owner to perform monitoring, state estimation and contingency analysis for (i) Interconnection Points that existed prior to the Effective Date and did not contain SCADA and communications equipment or (ii) new Interconnection Points installed after the Effective Date. Each Interconnection Point or other mutually agreeable location with SCADA and communications equipment shall have one dedicated communications path to Balancing Authority/Control Area Operator’s control center for the RTU data. In the instance where the Local Distribution Company also performs the Balancing Authority/Control Area Operator function, data path provisions between the Local Distribution Company’s distribution control center and Balancing Authority/Control Area control center are at its discretion. Additional data paths and communications equipment requested, either emanating from the substation or the Balancing Authority/Control Area Operator’s control center, will be at the expense of the requestor. The SCADA and communications equipment may provide data and status information in real time or with a time delay acceptable to Transmission Owner and shall provide data and control via an industry standard protocol such as ICCP or another method agreed by the Parties. Such data may include, but not be limited to megawatts, megavars, voltage, amperes, device status and communication system status.
Supervisory Control And Data Acquisition (SCADA. 4.1 Interconnection Points containing SCADA and communications equipment installed prior to January 1, 2001, shall be considered to satisfy the terms and conditions of this Article. For those Interconnection Points that existed prior to January 1, 2001 that did not contain SCADA and communications equipment, and for new Interconnection Points installed after January 1, 2001, where SCADA and communications equipment is necessary for the Transmission Provider to perform monitoring, state estimation and contingency analysis, the Local Distribution Company shall install, and operate such equipment. The Parties, or an entity acting on behalf of a Party, shall share equally in the ownership and all costs of the equipment and its installation, unless mutually agreed otherwise. Each Interconnection Point or other mutually agreeable location with SCADA and communications equipment shall have one dedicated communications path to the Local Distribution Company's Distributed Control Area Operator's control center for the RTU data. The cost of the dedicated communications path and general use station phone shall be shared on an equal basis. Additional data paths and communications equipment requested, either emanating from the substation or the Distributed Control Area Operator's control center, will be at the expense of the requestor. This data and status information may be real time or with a time delay acceptable to the Transmission Provider. The method of providing this data and control will be via an industry standard protocol such as ICCP or other method agreed to by the Parties. Such data may include, but not be limited to megawatts, megavars, voltage, amperes, device status and communication system status.
Supervisory Control And Data Acquisition (SCADA. South Central will install SCADA equipment to detect any facility upsets. SCADA information will be monitored 24 hr/day.
Supervisory Control And Data Acquisition (SCADA. In lieu of the provisions of Article VII regarding On-Call, Call Back and Standby, employees who provide coverage for the Supervisory Control and Data Acquisition System (SCADA) outside of their regularly scheduled work hours shall be compensated as follows:
Supervisory Control And Data Acquisition (SCADA
