Submission of Samples. Contractor shall also submit Samples to Architect for review and approval in accordance with the acceptable schedule of Shop Drawings and Sample submittals. Each Sample will be identified clearly as to material, Supplier, pertinent data such as catalog numbers, and the use for which intended and otherwise as Architect may require to enable Architect to review the submittal for the limited purposes required by subparagraph 10.19.5 below. The numbers of each Sample to be submitted will be as specified in the Specifications.
Submission of Samples. 7.1 The samples shall be submitted as per mentioned in the ITB/Evaluation Criteria/Specifications. If demanded
Submission of Samples. Labeling and Packing of the product would be examined in accordance with Labeling and Packing Rules 1986 of the Drugs Act 1976. The Supplier shall provide FOUR (04) samples (free of cost) of the product to procuring agency where applicable.
Submission of Samples. If required by Owner or Owner’s Representative, Contractor shall, without undue delay, furnish and submit to Owner or Owner’s Representative any samples that require Owner's or Owner’s Representative’s approval, and also any samples that may be requested by Owner or Owner’s Representative, of any and all materials or equipment Contractor proposes to use, and shall prepay all shipping charges on the samples. Samples shall be furnished sufficiently in advance to allow Owner or Owner’s Representative reasonable time for examination, investigation, or consideration, without delay to the Work. Where samples are required, they shall be submitted by and at the expense of Contractor. Such submittal shall be made not less than thirty (30) calendar days prior to the time that the materials represented by such samples must be ordered (if the materials must be ordered) or are needed for incorporation into any of the Work or other portion of Owner's facility relating or adjacent to the Work.
Submission of Samples. The Supplier shall provide samples (free of cost) of the product to procuring agency where applicable.
Submission of Samples. 7.1 The samples (one prototype sample in case of furniture before bulk supplies) shall be submitted as mentioned in the approved technical specifications and subsequent supplies shall be in accordance with approved sample.
Submission of Samples. 7.1 The samples shall be submitted as per detail in ITB 16.3.
Submission of Samples. Pilot Models and Drawings. Samples and descriptive literature shall not be submitted unless expressly requested elsewhere in the contract or contract documents. Any unsolicited samples or descriptive literature which are submitted shall not be examined or tested and shall not be deemed to vary any of the provisions of this contract. When samples, pilot models or drawings are requested from the Bidder or required by this Contract, they shall be delivered by the Bidder, properly identified, within fifteen (15) calendar days of the request unless this Contract indicates a different time. If the Bidder fails to deliver the same in a timely manner, the Agency Chief Contracting Officer shall have the right to deem the bid non-responsive or to cancel and terminate the contract. Samples, drawings and pilot models requested by the City shall be submitted to the 18th floor, Municipal Building, New York, New York 10007, unless some other place is indicated. Samples, drawings and pilot models shall be submitted free of charge.
Submission of Samples. The Licensee agrees to make available to PDI, at PDI’s request, sample water hammer arresters on which the Mark is used for inspection and testing by PDI, and to submit any data requested by PDI necessary to demonstrate the Licensee’s compliance with this Agreement and the compliance of such water hammer arresters with the applicable Standard.
Submission of Samples. 7.1 Before commencing supplies, the Supplier shall provide samples free of cost, if and as specified in the Schedule of Requirements, of the product to the designated office or staff, as the case may be.
