Subloop Sample Clauses

Subloop. The subloop network element is defined as any portion of the loop that is technically feasible to access at terminals in BellSouth’s outside plant, including inside wire. An accessible terminal is any point on the loop where technicians can access the wire or fiber within the cable without removing a splice case to reach the wire or fiber within. Such points may include, but are not limited to, the pole or pedestal, the network interface device, (“NID”) the minimum point of entry, (“MPOE”) the single point of interconnection, the main distribution frame, the remote terminal, and the feeder/distribution interface (“FDI”).
Sample 1Sample 2
AutoNDA by SimpleDocs
Subloop. Verizon shall provide RNK with nondiscriminatory access to Subloops on an unbundled basis at any technically feasible point (including at fiber distribution facilities) and pursuant to Section 251(c)(3) of the Act, Section 51.319(b) of the FCC’s rules, and any other Applicable Law. One type of Subloop is Inside Wire Subloop, which is defined in Section 4.7.22 below. The Subloop element shall include any and all of the features, functions, and capabilities of the Subloop, including, but not limited to: (i) loop concentration/multiplexing functionality, (ii) loop distribution, and (iii) on-premises wiring owned or controlled by Verizon. Verizon shall also provide any combination of Subloop elements ordinarily combined in the Verizon network, and any pre-existing combination of Subloop elements shall not be separated unless so directed by RNK.
Sample 1
Subloop. Verizon shall provide ***CLEC Acronym TXT*** with nondiscriminatory access to subloops on an unbundled basis pursuant to Applicable Law.
Sample 1
Subloop. Verizon shall provide AT&T with nondiscriminatory access to subloops on an unbundled basis at any technically feasible point (including at fiber distribution facilities) and pursuant to Section 251(c)(3) of the Act, Section 51.319(b) of the FCC’s rules, and any other Applicable Law. One type of Subloop is Inside Wire Subloop, which is defined in Section 2.17 above. The subloop element shall include any and all of the features, functions, and capabilities of the subloop, including, but not limited to: (i) loop concentration/multiplexing functionality, (ii) loop distribution, and (iii) on- premises wiring owned or controlled by Verizon. Verizon shall also provide any combination of subloop elements ordinarily combined in the Verizon network, and any pre-existing combination of subloop elements shall not be separated unless so directed by AT&T.
Sample 1
Subloop. 9.3.1 2-Wire Distribution $15.68 $ 121.69/6/ ----------------------------------------------------------------------------------------------------------------------------------- 9.3.2 Installation for Each Additional 2-Wire Distribution $ 55.62/6/ Loop ----------------------------------------------------------------------------------------------------------------------------------- 9.3.3 DS1 Capable Feeder Loop $95.15/1/ $ 372.69/1/ ----------------------------------------------------------------------------------------------------------------------------------- DS1 Capable Feeder Each Additional $ 301.48/1/ ----------------------------------------------------------------------------------------------------------------------------------- 9.3.4 OSS Under Under Development Development ----------------------------------------------------------------------------------------------------------------------------------- 9.4 Field Connection Point ----------------------------------------------------------------------------------------------------------------------------------- 9.4.1 Feasibility Fee/Quote Preparation Fee $ 1642.35/1/ ----------------------------------------------------------------------------------------------------------------------------------- 9.4.2 Construction Fee ICB/3/ ----------------------------------------------------------------------------------------------------------------------------------- ----------------------------------------------------------------------------------------------------------------------------------- 9.5 Line Sharing ----------------------------------------------------------------------------------------------------------------------------------- 9.5.1 Shared Loop, per Loop $12.76/1/ $ 71.80/1/ ----------------------------------------------------------------------------------------------------------------------------------- 9.5.2 OSS, per Order $ 3.13/1/ ----------------------------------------------------------------------------------------------------------------------------------- 9.5.3 Engineering - Collocation Augment ICB/3/ ----------------------------------------------------------------------------------------------------------------------------------- 9.5.4 Splitter Shelf Charge $ 4.85/1/ $2,893.50/1/ ----------------------------------------------------------------------------------------------------------------------------------- 9.5.5 Splitter TIE Cable Connections $1,303.65/1/ ----------------------------...
Sample 1
Subloop. A Copper Subloop or Subloop for Access to a Multi-Unit Premises Wiring.
Sample 1
Subloop. A subloop (including Inside Wire Subloops, defined above) is a portion of a copper loop, or hybrid loop, comprised entirely of copper wire or copper cable, between any technically feasible point in Verizon’s outside plant, including inside wire owned, controlled or leased by Verizon, and the end-user customer premises. A subloop includes all intermediate devices (e.g. repeater and load coils), and includes the features, functions, and capabilities of the loop. A subloop includes two-wire and four-wire analog voice grade subloops and two-wire and four-wire subloops conditioned for digital service, regardless of whether the subloops are in service or held as spares.
Sample 1
AutoNDA by SimpleDocs
Subloop. Subloop is a network element defined as any portion of the loop that is technically feasible to access at terminals in CenturyTel’s outside plant, including Inside Wiring. An accessible terminal is any point on the loop where technicians can access the wire or fiber within the cable without removing the splice case to reach the wire within. Such points may include, but are not limited to, the pole or pedestal, the network interface device, the minimum point of entry, the single point of interconnection, the main distribution frame, the remote terminal and the feeder distribution interface.
Sample 1

Related to Subloop

  • Conhecimento da Lingua O Contratado, pelo presente instrumento, declara expressamente que tem pleno conhecimento da língua inglesa e que leu, compreendeu e livremente aceitou e concordou com os termos e condições estabelecidas no Plano e no Acordo de Atribuição (“Agreement” xx xxxxxx).

  • Information Systems Acquisition Development and Maintenance Security of System Files. To protect City Information Processing Systems and system files containing information, Service Provider will ensure that access to source code is restricted to authorized users whose specific job function necessitates such access.

  • Underground Storage Tanks In accordance with the requirements of Section 3(g) of the D.C. Underground Storage Tank Management Act of 1990, as amended by the District of Columbia Underground Storage Tank Management Act of 1990 Amendment Act of 1992 (D.C. Code § 8-113.01, et seq.) (collectively, the “UST Act”) and the applicable D.C. Underground Storage Tank Regulations, 20 DCMR Chapter 56 (the “UST Regulations”), District hereby informs the Developer that it has no knowledge of the existence or removal during its ownership of the Property of any “underground storage tanks” (as defined in the UST Act). Information pertaining to underground storage tanks and underground storage tank removals of which the D.C. Government has received notification is on file with the District Department of the Environment, Underground Storage Tank Branch, 00 X Xxxxxx, X.X., Xxxxx Xxxxx, Xxxxxxxxxx, X.X., 00000, telephone (000) 000-0000. District’s knowledge for purposes of this Section shall mean and be limited to the actual knowledge of Xxxxxx Xxxxx, Property Acquisition and Disposition Division of the Department of Housing and Community Development, telephone no. (000) 000-0000. The foregoing is set forth pursuant to requirements contained in the UST Act and UST Regulations and does not constitute a representation or warranty by District.

  • Generator Subject to the provisions of this Section 29.36, Tenant shall be entitled to install, operate and maintain a generator and any other equipment related thereto, including, without limitation, a fuel system, wiring and shaft space (“Generator”) next to the Building at Tenant’s sole cost and expense (without paying any additional fee or rental to Landlord for the use thereof). Prior to the installation of the Generator, Tenant shall inspect the proposed location to determine a suitable location for the Generator, and Tenant shall submit written plans and specifications relative to the type, size and proposed location (including any proposed screening) of the Generator to Landlord for its review and written approval. Tenant shall be solely responsible for the cost of acquisition, installation, operation, and maintenance of the Generator; and Tenant shall install, maintain and operate the Generator in accordance with all federal, state, and local laws, statutes, ordinances, rules and regulations, including without limitation, obtaining and maintaining any and all permits, approvals and licenses required to install and operate the Generator by any governmental authority having jurisdiction. Landlord and Tenant agree that, upon the expiration of earlier termination of the Lease Term, Tenant shall not be required to remove the Generator, any associated cabling, wiring and screening or other improvements. Tenant shall not be entitled to grant or assign to any third party (other than a permitted assignee of Tenant’s rights under the Lease or a permitted subtenant relative to the Premises (or a portion thereof)) the right to use the Generator without Landlord’s prior written consent (which consent may be granted or withheld in Landlord’s discretion). Upon reasonable advance notice to Tenant (and provided Landlord reasonably coordinates with Tenant and provides an alternate source of backup generator capacity during said transition), Landlord shall be entitled to cause the Generator to be moved to another location near the Building, at Landlord’s cost and expense. Tenant shall pay all personal property taxes on the Generator. Tenant shall also pay any increases in the real property taxes of the Building due to the installation of the Generator within thirty (30) days of receipt of notice from Landlord which includes proof of such increase in taxes. Tenant’s indemnity obligations under Section 5.4.1.5 of the Lease, relating to the use of Hazardous Materials, shall apply to the use and operation of the Generator. Finally, Tenant’s insurance obligations under Section 10.3 of the Lease shall apply to the Generator.

  • TELEPHONE SERVICES All telegraph, telephone, and communication connections which Tenant may desire outside the Premises shall be subject to Landlord’s prior written approval, in Landlord’s sole discretion, and the location of all wires and the work in connection therewith shall be performed by contractors approved by Landlord and shall be subject to the direction of Landlord, except that such approval is not required as to Tenant’s cabling from the Premises in a route designated by Landlord to any telephone cabinet or panel provided for Tenant’s connection to the telephone cable serving the Building, so long as Tenant’s equipment does not require connections different than or additional to those to the telephone cabinet or panel provided. As to any such connections or work outside the Premises requiring Landlord’s approval, Landlord reserves the right to designate and control the entity or entities providing telephone or other communication cable installation, removal, repair and maintenance outside the Premises and to restrict and control access to telephone cabinets or panels. In the event Landlord designates a particular vendor or vendors to provide such cable installation, removal, repair and maintenance for the Building, Tenant agrees to abide by and participate in such program. Tenant shall be responsible for and shall pay all costs incurred in connection with the installation of telephone cables and communication wiring in the Premises, including any hook-up, access and maintenance fees related to the installation of such wires and cables in the Premises and the commencement of service therein, and the maintenance thereafter of such wire and cables; and there shall be included in Operating Expenses for the Building all installation, removal, hook-up or maintenance costs incurred by Landlord in connection with telephone cables and communication wiring serving the Building which are not allocable to any individual users of such service but are allocable to the Building generally. If Tenant fails to maintain all telephone cables and communication wiring in the Premises and such failure affects or interferes with the operation or maintenance of any other telephone cables or communication wiring serving the Building, Landlord or any vendor hired by Landlord may enter into and upon the Premises forthwith and perform such repairs, restorations or alterations as Landlord deems necessary in order to eliminate any such interference (and Landlord may recover from Tenant all of Landlord’s costs in connection therewith). No later than the Termination Date, Tenant agrees to remove all telephone cables and communication wiring installed by Tenant for and during Tenant’s occupancy, which Landlord shall request Tenant to remove. Tenant agrees that neither Landlord nor any of its agents or employees shall be liable to Tenant, or any of Tenant’s employees, agents, customers or invitees or anyone claiming through, by or under Tenant, for any damages, injuries, losses, expenses, claims or causes of action because of any interruption, diminution, delay or discontinuance at any time for any reason in the furnishing of any telephone or other communication service to the Premises and the Building.

  • Virus Management Transfer Agent shall maintain a malware protection program designed to deter malware infections, detect the presence of malware within the Transfer Agent environment.

  • Floor Load Tenant shall not place a load upon any floor of the Premises that exceeds 50 pounds per square foot “live load”. Landlord reserves the right to reasonably designate the position of all Equipment which Tenant wishes to place within the Premises, and to place limitations on the weight thereof.

  • Floor Loading Floor loading capacity shall be within building design capacity. Tenant may exceed floor loading capacity with Landlord’s consent, at Landlord’s sole discretion and must, at Tenant’s sole cost and expense, reinforce the floor as required for such excess loading.

Time is Money Join Law Insider Premium to draft better contracts faster.