Specific to Home Automation Sample Clauses

Specific to Home Automation. In additional to the exclusions listed above, this Agreement does not cover any loss, repairs or damage caused by or resulting from: (A) pre-existing conditions incurred or known to You; (B) any repair covered by a manufacturer’s warranty or any insurance; (C) installation, or improper installation; or improper installation of customer replaceable components, modules, parts or peripherals; (D) damage or failure due to causes beyond Our control such as environmental conditions, exposure to weather conditions or acts of nature including, but not limited to: fire, floods, smoke, sand, dirt, lightning, moisture, water damage, freezes, storms, wind, windstorm, hail, earthquake, animal or insect infestation, etc.; (E) damage or failure caused by riot, nuclear radiation, war, hostile action, or radioactive contamination, etc.; (F) battery failure or leakage; (G) collision, collapse, or explosion;
Specific to Home Automation. In additional to the exclusions listed above, this Agreement does not cover any loss, repairs or damage caused by or resulting from:
Specific to Home Automation. In additional to the exclusions listed above, this Agreement does not cover any loss, repairs or damage caused by or resulting from: (A) pre-existing conditions incurred or known to You; (B) any repair covered by a manufacturer’s warranty or any insurance; (C) installation, or improper installation; or improper installation of customer replaceable components, modules, parts or peripherals; (D) damage or failure due to causes beyond Our control such as environmental conditions, exposure to weather conditions or acts of nature including, but not limited to: fire, floods, smoke, sand, dirt, lightning, moisture, water damage, freezes, storms, wind, windstorm, hail, earthquake, animal or insect infestation, etc.; (E) damage or failure caused by riot, nuclear radiation, war, hostile action, or radioactive contamination, etc.; (F) battery failure or leakage; (G) collision, collapse, or explosion; (H) liquid spillage of any kind; (I) signal reception, transmission problems resulting from external causes, interruption of electrical service, loss of power, improper use of electrical/power, power “brown-out”, power overload or power surge (unless covered in this Agreement); (J) neglect, misuse, abuse, intentional damage, malicious mischief, theft, mysterious disappearance, vandalism or accidental damage; damage cause by dropping (K) rust, corrosion, warping, bending, etc.; (L) damage, warping, bending or rusting of any kind to the housing, cabinetry, outside casing or frame of the product; (M) any non-operating part, including but not limited to plastic, or decorative parts such as hinges, knobs, door liners, glass, handles, masks, rack rollers, shelves, etc.; (N) loss of or repair to components within the product not originally covered by the manufacturer’s warranty;
Specific to Home Automation. In additional to any applicable exclusions listed above, We do not cover any loss, repairs or damage caused by or resulting from: (A) pre-existing conditions incurred or known to you (pre-existing means a condition prior to Plan issuance); (B) any repair covered by a manufacturer warranty or other insurance; (C) installation, or improper installation; or improper installation of customer replaceable components, modules, parts or peripherals; (D) damage or failure due to causes beyond our control such as environmental conditions, exposure to weather conditions or acts of nature including, but not limited to: fire, floods, smoke, sand, dirt, lightning, moisture, water damage, freezes, storms, wind, windstorm, hail, earthquake, animal or insect infestation, etc.; (E) damage or failure caused by riot, nuclear radiation, war, hostile action, or radioactive contamination, etc.; (F) battery failure or leakage; (G) collision, collapse, or explosion; (H) liquid spillage of any kind;

Related to Specific to Home Automation

  • Ownership and Location of Metering Equipment The Metering Equipment to be constructed, the capability of the Metering Equipment to be constructed, and the ownership thereof, are identified on the attached Schedule C to this ISA.

  • Procurement of Small Works Works estimated to cost less than $30,000 equivalent per contract, up to an aggregate amount not to exceed $500,000 equivalent, may be procured under lump-sum, fixed-price contracts awarded on the basis of quotations obtained from three (3) qualified domestic contractors in response to a written invitation. The invitation shall include a detailed description of the works, including basic specifications, the required completion date, a basic form of agreement acceptable to the Bank, and relevant drawings, where applicable. The award shall be made to the contractor who offers the lowest price quotation for the required work, and who has the experience and resources to complete the contract successfully. Part D: Review by the Bank of Procurement Decisions

  • CLOTHING AND EQUIPMENT (a) Employees required by the Employer to wear uniforms will be supplied with an adequate number of uniforms appropriate to the occupation free of cost to Employees. Such items are to remain the property of the Employer and be laundered and maintained by such Employer free of cost to the Employee. (b) Instead of the provision of such uniforms, the Employer may, by agreement with the Employee, pay such Employee a uniform allowance at the rate set out in Item 1 of Table 5. This rate is expressed as per shift or part thereof, or as a weekly rate – an Employee is to be paid whichever is the lesser amount. (c) Where an Employee’s uniforms are not laundered by or at the expense of the Employer, the Employee will be paid a laundry allowance. For Aged Care, Health Professionals and Home Care Employees this will be paid at the rate set out in Item 2 of Table 5. This allowance is also expressed as a payment per shift of part thereof of as a weekly payment – an Employee is to be paid whichever is the lesser amount. For Nursing Employees this will be paid at the rate set out in Item 3 of Table 5. (d) The uniform allowance, but not the laundry allowance, will be paid during all absences on paid leave, except absences on long service leave and absence on personal/carer’s leave beyond 21 days. Where, prior to the taking of leave, an Employee was paid a uniform allowance other than at the weekly rate, the rate to be paid during absence on leave will be the average of the allowance paid during the four weeks immediately preceding the taking of leave. (e) Where an Employer requires an Employee to wear rubber gloves, special clothing or where safety equipment is required for the work performed by an Employee, the Employer must reimburse the Employee for the cost of purchasing such special clothing or safety equipment, except where such clothing or equipment is provided by the Employer.

  • Elements Unsatisfactory Needs Improvement Proficient Exemplary IV-A-1. Reflective Practice Demonstrates limited reflection on practice and/or use of insights gained to improve practice. May reflect on the effectiveness of lessons/ units and interactions with students but not with colleagues and/or rarely uses insights to improve practice. Regularly reflects on the effectiveness of lessons, units, and interactions with students, both individually and with colleagues, and uses insights gained to improve practice and student learning. Regularly reflects on the effectiveness of lessons, units, and interactions with students, both individually and with colleagues; and uses and shares with colleagues, insights gained to improve practice and student learning. Is able to model this element.

  • Selection of Subcontractors, Procurement of Materials and Leasing of Equipment The contractor shall not discriminate on the grounds of race, color, religion, sex, national origin, age or disability in the selection and retention of subcontractors, including procurement of materials and leases of equipment. The contractor shall take all necessary and reasonable steps to ensure nondiscrimination in the administration of this contract. a. The contractor shall notify all potential subcontractors and suppliers and lessors of their EEO obligations under this contract. b. The contractor will use good faith efforts to ensure subcontractor compliance with their EEO obligations.