SMALL EQUIPMENT Sample Clauses

SMALL EQUIPMENT. Combination small equipment operators, operating and maintaining equipment listed in Article IX, Section 9.1, Classification 4, shall be assigned at the Pre job Conference.
AutoNDA by SimpleDocs
SMALL EQUIPMENT. An Operating Engineer servicing, operating and maintaining the following listed Class III machinery; Small Air Compressors, Small Generators, Small Electric Winches, and Welding Machines - shall not be required to maintain more than a total of six (6) such machines of the same type, except Small Electric Winches for which the total number maintained shall not be more than six (6) nor shall such employees be required to service, operate and maintain more than a total of six (6) of the above listed machines in combination. When employees of the bargaining unit are employed to service and maintain mechanical heaters, or ground heaters such employees shall not be required to service and maintain no more than a total of six (6) such heaters. Where a member of the bargaining unit is required to service, operate and maintain more than a total of six (6) heaters, such employee shall be compensated at the Class I rate of pay negotiated for Crane Operators in this Agreement. Assignment of such machines shall not exceed a total of nine (9). An Engineer shall not be required on one (1) small heater of less than 250,000 B.T.U.
SMALL EQUIPMENT. Refers to low-voltage electrical equipment, other than Lighting, mainly used in residential buildings, stores, offices, and the like, in a single-phase system. However, equipment that may interfere with the use of Lighting by other customers or pose a risk of such interference due to sudden voltage fluctuations, and cannot be used together with Lighting, is excluded.
SMALL EQUIPMENT. Micropipettes of 20 μl, 200 μl and 1000 μl (Xxxxxx,) • EasiGlow glow discharge device (Pelco, Redding, CA, USA)
SMALL EQUIPMENT. An Operating Engineer servicing, operating and maintaining the following listed Class IV machinery; Small Air Compressors, Small Generators, Small Electric Winches, Welding Machines, and Sump Pumps four (4”) inches or under, shall not be required to maintain more than a total of six
SMALL EQUIPMENT. 1.13.1 Provide scheduled maintenance in accordance with OEM manuals, technical/service bulletins, and best equipment maintenance practices. Maintenance must comply with OEM Warranty requirements. As a minimum, maintenance routines must include, but are not limited to, the following:

Related to SMALL EQUIPMENT

  • Safe Equipment The City shall furnish and maintain in the best possible working condition, within the limits of its financial capability, the necessary tools, facilities, vehicles, supplies, and equipment required for members to safely carry out their duties. Members are responsible for reporting unsafe conditions or practices, for avoiding negligence, and for properly using and caring for tools, facilities, vehicles, supplies, and equipment provided by the City.

  • School Equipment The Association shall have the right to use audio-visual and/or duplicating equipment provided all costs incurred therewith are paid for by the Association. Association use of school equipment shall not interfere with school use. The building principal must approve any Association use that involves a cost.

  • Electrical Equipment Residents must use only CSA, UL-approved or Canadian-certified electrical equipment; the rated wattage of light fixtures must never be exceeded; and only replacement bulbs supplied by Waterloo maintenance staff may be used. Do not leave any unattended electrical equipment turned on (i.e. hair straighteners, lights etc.)

  • STANDARD EQUIPMENT All items of standard equipment which are provided by the OEM shall be furnished unless such items are expressly deleted by the Authorized User or are specified to be other than standard in the Mini-Bid. When Optional equipment is specified, all components listed in the OEM’s data book as being included with the Option shall be furnished.

  • Stored equipment We accept no responsibility for any stored equipment or other property brought on to or left at the premises, and all liability for loss or damage is hereby excluded. All equipment and other property (other than stored equipment) must be removed at the end of each hiring or we will charge fees each day or part of a day at the hire fee per hiring until the same is removed. We may, in our discretion, dispose of any items referred to below by sale or otherwise on such terms and conditions as we think fit, and charge you any costs we incur in storing and selling or otherwise disposing of the same, in any of the following circumstances:

  • Monitoring Equipment 2.2.1 24-hour TSP air quality monitoring was performed using High Volume Sampler (HVS) located at each designated monitoring station. The HVS meets all the requirements of the Project Specific EM&A Manual. Portable direct reading dust meters were used to carry out the 1-hour TSP monitoring. Brand and model of the equipment is given in Table 2.1.

  • Metering Equipment 13.01. Utility will furnish, install, own and maintain metering equipment capable of measuring the flow of kilowatt-hours (kWh) of energy. The Customer's service associated with the CRG will be metered at a single metering point. The metering equipment will measure energy delivered by Utility to Customer and also measure energy delivered by Customer to Utility. Customer agrees to provide safe and reasonable access to the premises for installation of this equipment and its future maintenance or removal.

  • Furniture, Fixtures and Equipment Sublessee shall have the right to use during the Term the office furnishings and equipment within the Subleased Premises that are identified on Exhibit C attached hereto, as such exhibit may be adjusted by mutual agreement of the parties prior to the Third Floor Premises Delivery Date (the “Furniture”), provided Sublessee may only use the Furniture located in the Second Floor Premises after the Second Floor Commencement Date. The Furniture is provided in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever. Sublessee shall insure the Furniture under the property insurance policy required under the Master Lease, as incorporated herein, and pay all taxes with respect to the Furniture. Sublessee shall maintain the Furniture in good condition and repair, reasonable wear and tear excepted, and shall be responsible for any loss or damage to the same occurring during the Term. Sublessee shall surrender the Furniture to Sublessor upon the termination of this Sublease in the same condition as exists as of the applicable Delivery Date, reasonable wear and tear excepted. Sublessee shall not remove any of the Furniture from the Subleased Premises. Notwithstanding anything to the contrary herein, Sublessee may provide Sublessor with written notice one (1) time not less than forty-five (45) days prior to the Third Floor Premises Delivery Date that lists any items of Furniture that Sublessee does not want to use and Sublessor shall, at no cost to Sublessee, remove such items from the Subleased Premises prior to the Third Floor Premises Delivery Date and such items shall no longer be considered Furniture hereunder. Notwithstanding the foregoing, provided Sublessee is not in default beyond the expiration of any applicable cure or grace period as of the date of the expiration or earlier termination of this Sublease, which condition may be waived by Sublessor in its sole discretion, then upon the expiration or earlier termination of this Sublease, the Furniture shall become the property of Sublessee, and Sublessee shall accept the same in its “AS IS, WHERE IS” condition, without representation or warranty whatsoever except as provided in the Bill of Sale referred to in the following sentence. In the event the Furniture is to become the property of Sublessee upon the expiration or earlier termination of this Sublease pursuant to the terms of the immediately preceding sentence, then Sublessor agrees to execute and deliver to Sublessee a Bill of Sale in the form of Exhibit D attached hereto conveying and transferring to Sublessee the Furniture.

  • MEASURING EQUIPMENT 1. Seller will maintain and operate, at its own, expense and at the point of delivery of gas hereunder, a meter or meters and other necessary equipment by which the volume of gas delivered hereunder shall be measured. Such meters and equipment shall remain the property of the Seller.

  • Office Equipment The Client must not install any cabling, IT or telecom connections without the Provider’s consent, which the Provider may refuse at its absolute discretion. As a condition to the Provider’s consent, the Client must permit the Provider to oversee any installations (for example IT or electrical systems) and to verify that such installations do not interfere with the use of the accommodation(s) by other Clients or the Provider or any landlord of the building.

Time is Money Join Law Insider Premium to draft better contracts faster.