Configuration The configuration for the Purchase Right Aircraft will be the Detail Specification for Model 767-3S2F aircraft at the revision level in effect at the time of the Supplemental Agreement. Such Detail Specification will be revised to include (i) changes required to obtain required regulatory certificates and (ii) other changes as mutually agreed upon by Boeing and Customer.
Software Title and ownership to Existing Software Product(s) delivered by Contractor under the Contract that is normally commercially distributed on a license basis by the Contractor or other independent software vendor proprietary owner (“Existing Licensed Product”), embedded in the Custom Products, shall remain with Contractor or the proprietary owner of other independent software vendor(s) (ISV). Effective upon acceptance, such Product shall be licensed to Authorized User in accordance with the Contractor or ISV owner’s standard license agreement, provided, however, that such standard license, must, at a minimum: (a) grant Authorized User a non-exclusive, perpetual license to use, execute, reproduce, display, perform, adapt (unless Contractor advises Authorized User as part of Contractor’s proposal that adaptation will violate existing agreements or statutes and Contractor demonstrates such to the Authorized User’s satisfaction) and distribute Existing Licensed Product to the Authorized User up to the license capacity stated in the Purchase Order or work order with all license rights necessary to fully effect the general business purpose(s) stated in the Bid or Authorized User’s Purchase Order or work order, including the financing assignment rights set forth in paragraph (c) below; and (b) recognize the State of New York as the licensee where the Authorized User is a state agency, department, board, commission, office or institution. Where these rights are not otherwise covered by the ISV’s owner’s standard license agreement, the Contractor shall be responsible for obtaining these rights at its sole cost and expense. The Authorized User shall reproduce all copyright notices and any other legend of ownership on any copies authorized under this clause. Open source software is developed independently of Contractor and may be governed by a separate license (“open source software”). If the open source software is governed by a separate License and provided under this Contract, Contractor shall provide a copy of that license in the applicable Documentation and the Authorized User's license rights and obligations with respect to that open source software shall be defined by those separate license terms and subject to the conditions, if any, therein. Nothing in this Contract shall restrict, limit, or otherwise affect any rights or obligations the Authorized User may have, or conditions to which the Authorized User may be subject, under such separate open source license terms.
No Circumvention Each Party agrees not to directly or indirectly take any actions, act in concert with any Person who takes any action, or cause or allow any of its Subsidiaries to take any actions (including the failure to take any reasonable action) such that the resulting effect is to materially undermine the effectiveness of any of the provisions of this Agreement (including adversely affecting the rights or ability of any Party to successfully pursue indemnification or payment pursuant to the provisions of this Agreement).
Technical Specifications The Technical Specifications furnished on the CD are intended to establish the standards for quality, performance and technical requirements for all labor, workmanship, material, methods and equipment necessary to complete the Work. When specifications and drawings are provided or referenced by the County, these are to be considered part of the Scope of Work, and to be specifically documented in the Detailed Scope of Work. For convenience, the County supplied specifications, if any, and the Technical Specifications furnished on the CD.
Specifications That part of the Contract Documents consisting of written requirements for materials, equipment, systems, standards, and workmanship as applied to the Work, and certain administrative requirements and procedural matters applicable thereto. The term "Specifications" shall also include all written matter in the Project Manual or on the drawings and any Addenda or Change Orders thereto.
Open Source Software The Software product may include certain open source components that are subject to open source licenses (“Open Source Software”), in which case, the embedded Open Source Software is owned by a third party. The Open Source Software is not subject to the terms and conditions of this XXXX. Instead, each item of Open Source Software is licensed under its applicable license terms which accompanies such Open Source Software. Nothing in this XXXX limits your rights under, nor grants you rights that supersede, the terms and conditions of any applicable license terms for the Open Source Software. Any fees charged by GC in connection with the SOFTWARE, do not apply to the Open Source Software for which fees may not be charged under the applicable license terms. The terms and conditions of the applicable license for the Open Source Software are available on the LICENSE.txt file, which is provided with the SOFTWARE.
Raw Materials Lonza shall procure all required Raw Materials as well as consumables other than those Raw Materials that are Customer Materials. Customer shall be responsible for payment for all consumables and Raw Materials ordered or irrevocably committed to be procured by Lonza hereunder. Upon cancellation of any Batch or termination of the Agreement, all unused Raw Materials shall be paid for by Customer within [***] days of invoice and at Customer’s option will either be (a) held by Lonza for future use for the production of Product, (b) delivered to Customer, or (c) disposed of by Lonza.
Manufacturing (a) The Supplier shall without limitation be responsible, at no additional cost to the Purchaser, for: sourcing and procuring all raw materials for the Products; obtaining all necessary approvals, permits and licenses for the manufacturing of the Products; providing sufficient qualified staff and workers to perform the obligations under this Purchase Agreement; implementing and maintaining effective inventory and production control procedures with respect to the Products; and handling other matters as reasonably requested by the Purchaser from time to time.
Computer Software The Grantee certifies that it has appropriate systems and controls in place to ensure that state funds will not be used in the performance of this Grant Agreement for the acquisition, operation, or maintenance of computer software in violation of copyright laws.
Product Specifications The Company agrees that all Products sold to Xxxx hereunder shall conform to the respective specifications set forth on Schedule A or to such other specifications as are from time to time agreed upon by the Parties.
