SEISMIC SAFETY REQUIREMENTS. This provision applies only to Agreements for the construction of new buildings or additions to existing buildings. The Contractor agrees that any new building or addition to an existing building that is the subject of this Agreement will be designed and constructed in accordance with the standards for Seismic Safety required in U.S. DOT Seismic Safety Regulations 49 CFR Part 41 and will certify to compliance with such regulations to the extent required by the regulations. The Contractor also agrees to ensure that all work performed under this Agreement, including work performed by a subcontractor, is in compliance with the standards required by the Seismic Safety Regulations and the certification of compliance issued on the project.
SEISMIC SAFETY REQUIREMENTS. The Service Provider agrees that any new building or addition to an existing building will be designed and constructed by the standards for Seismic Safety required in the Department of Transportation Seismic Safety Regulations 49 CFR Part 41 and will certify compliance to the extent required by the regulation. The Service Provider also agrees to ensure that all work performed under this Contract, including work performed by a subcontractor, complies with the standards required by the Seismic Safety Regulations and the certification of compliance issued on the project.
SEISMIC SAFETY REQUIREMENTS. The Seismic Safety requirements apply only to contracts for the construction of new buildings or additions to existing buildings. The contractor agrees that any new building or addition to an existing building will be designed and constructed in accordance with the standards for Seismic Safety required in Department of Transportation Seismic Safety Regulations 49 CFR Part 41 and will certify to compliance to the extent required by the regulation. The contractor also agrees to ensure that all work performed under this contract including work performed by a subcontractor is in compliance with the standards required by the Seismic Safety Regulations and the certification of compliance issued on the project.
SEISMIC SAFETY REQUIREMENTS. (Applies to New Building Construction and Additions to Existing Buildings) The recipient agrees to comply with the Earthquake Hazards Reduction Act of 1977, as amended, 42 U.S.C. §§ 7701 et seq., with Executive Order No. 12699, “Seismic Safety of Federal and Federally-Assisted or Regulated New Building Construction,” 42 U.S.C. § 7704 note, and with U.S. DOT regulations, “Seismic Safety,” 49 C.F.R. Part 41, specifically, 49 C.F.R. § 41.117.
SEISMIC SAFETY REQUIREMENTS. With respect to construction financed in whole or in part by the RUS, the Borrower shall comply with the seismic design requirements of 7 C.F.R. Part 1792, to the extent applicable to such construction. (c)
SEISMIC SAFETY REQUIREMENTS. 42 U.S.C. 7701 et seq. 49 CFR Part 41 This section does not apply to this contract.
SEISMIC SAFETY REQUIREMENTS. SB 1953 requires hospitals to retrofit or replace facilities that do not meet State-designated safety criteria by January 1, 2013. Further requirements must be met by 2030. If a hospital does not comply with these mandates, the State may revoke the hospital’s operating license. On September 30, 2010, Governor Xxxxxxxxxxxxxx signed SB 608, which will provide SHC with the ability to apply for up to five additional years for extensions to meet seismic requirements. If the extensions are granted, the legislation sets a new deadline of January 1, 2018. Effective January 1, 2011, SHC may apply for a three-year extension of the structural compliance deadline; from January 1, 2013 to January 1, 2016. SHC may also be eligible for an additional two-year extension of the 2016 deadline, subject to certain patient safety criteria. The Office of Statewide Health Planning and Development is responsible for approving plans for construction work required by SB 1953.
