Security Breach Notice and Reporting Sample Clauses

Security Breach Notice and Reporting. The Contractor shall have policies and procedures in place for the effective management of Security Breaches, as defined below, which shall be made available to the State upon request. In addition to the requirements set forth in any applicable Business Associate Agreement as may be attached to this Contract, in the event of any actual security breach or reasonable belief of an actual security breach the Contractor either suffers or learns of that either compromises or could compromise State Data (a “Security Breach”), the Contractor shall notify the State within 24 hours of its discovery. Contractor shall immediately determine the nature and extent of the Security Breach, contain the incident by stopping the unauthorized practice, recover records, shut down the system that was breached, revoke access and/or correct weaknesses in physical security. Contractor shall report to the State: (i) the nature of the Security Breach; (ii) the State Data used or disclosed; (iii) who made the unauthorized use or received the unauthorized disclosure; (iv) what the Contractor has done or shall do to mitigate any deleterious effect of the unauthorized use or disclosure; and (v) what corrective action the Contractor has taken or shall take to prevent future similar unauthorized use or disclosure. The Contractor shall provide such other information, including a written report, as reasonably requested by the State. Contractor shall analyze and document the incident and provide all notices required by applicable law. In accordance with Section 9 V.S.A. §2435(b)(3), the Contractor shall notify the Office of the Attorney General, or, if applicable, Vermont Department of Financial Regulation (“DFR”), within fourteen (14) business days of the Contractor’s discovery of the Security Breach. The notice shall provide a preliminary description of the breach. The foregoing notice requirement shall be included in the subcontracts of any of Contractor’s subcontractors, affiliates or agents which may be “data collectors” hereunder. The Contractor agrees to fully cooperate with the State and assume responsibility at its own expense for the following, to be determined in the sole discretion of the State: (i) notice to affected consumers if the State determines it to be appropriate under the circumstances of any particular Security Breach, in a form recommended by the AGO; and (ii) investigation and remediation associated with a Security Breach, including but not limited to, outside investi...
Sample 1Sample 2Sample 3See All (169)
AutoNDA by SimpleDocs
Security Breach Notice and Reporting. The Contractor shall have policies and procedures in place for the effective management of Security Breaches, as defined below, which shall be made available to the State upon request. In addition to the requirements set forth in any applicable Business Associate Agreement as may be attached to this Contract, in the event of any actual security breach or reasonable belief of an actual security breach the Contractor either suffers or learns of that either compromises or could compromise State Data (a “Security Breach”), the Contractor shall notify the State within 24 hours of its discovery. Contractor shall immediately determine the nature and extent of the Security Breach, contain the incident by stopping the unauthorized practice, recover records, shut down the system that was breached, revoke access and/or correct weaknesses in physical security. Contractor shall report to the State:
Sample 1Sample 2See All (4)
Security Breach Notice and Reporting. The Contractor shall have policies and procedures in place for the effective management of Security Breaches, as defined below, which shall be made available to the State upon request. In the event of any actual security breach or reasonable belief of an actual security breach the Contractor either suffers or learns of that either compromises or could compromise State Data (a “Security Breach”), the Contractor shall notify the State within 24 hours of its discovery. Contractor shall immediately determine the nature and extent of the Security Breach, contain the incident by stopping the unauthorized practice, recover records, shut down the system that was breached, revoke access and/or correct weaknesses in physical security. Contractor shall report to the State: (i) the nature of the Security Breach; (ii) the State Data used or disclosed;
Sample 1Sample 2
Security Breach Notice and Reporting. The Contractor shall have policies and procedures in place for the effective management of Security Breaches, as defined below, which shall be made available to the State upon request.
Sample 1

Related to Security Breach Notice and Reporting

  • Security Breach Notification In addition to the information enumerated in Article V, Section 4(1) of the DPA Standard Clauses, any Security Breach notification provided by the Provider to the LEA shall include:

  • Data Breach Notification Seller will promptly notify Buyer of any actual or potential exposure or misappropriation of Buyer data ("breach") that comes to Seller's attention. Seller will cooperate with Xxxxx and in investigating any such breach, at Xxxxxx's expense. Seller will likewise cooperate with Buyer and, as applicable, with law enforcement agencies in any effort to notify injured or potentially injured parties, and such cooperation will be at Seller's expense, except to the extent that the breach was caused by Xxxxx. The remedies and obligations set forth in this subsection are in addition to any others Buyer may have, including, but not limited to, any requirements in the “Privacy, Confidentiality, and Security” provisions of this Agreement.

  • Personal Data Breach Notification SAP will notify Customer without undue delay after becoming aware of any Personal Data Breach and provide reasonable information in its possession to assist Customer to meet Customer’s obligations to report a Personal Data Breach as required under Data Protection Law. SAP may provide such information in phases as it becomes available. Such notification shall not be interpreted or construed as an admission of fault or liability by SAP.

  • Breach Notification a. In the event of a Breach of unsecured PHI or disclosure that compromises the privacy or security of PHI obtained from DSHS or involving DSHS clients, Business Associate will take all measures required by state or federal law.

  • Handling Sensitive Personal Information and Breach Notification A. As part of its contract with HHSC Contractor may receive or create sensitive personal information, as section 521.002 of the Business and Commerce Code defines that phrase. Contractor must use appropriate safeguards to protect this sensitive personal information. These safeguards must include maintaining the sensitive personal information in a form that is unusable, unreadable, or indecipherable to unauthorized persons. Contractor may consult the “Guidance to Render Unsecured Protected Health Information Unusable, Unreadable, or Indecipherable to Unauthorized Individuals” issued by the U.S. Department of Health and Human Services to determine ways to meet this standard.

  • COMPLIANCE WITH NEW YORK STATE INFORMATION SECURITY BREACH AND NOTIFICATION ACT Contractor shall comply with the provisions of the New York State Information Security Breach and Notification Act (General Business Law Section 899-aa; State Technology Law Section 208).

  • COMPLIANCE WITH BREACH NOTIFICATION AND DATA SECURITY LAWS Contractor shall comply with the provisions of the New York State Information Security Breach and Notification Act (General Business Law § 899-aa and State Technology Law § 208) and commencing March 21, 2020 shall also comply with General Business Law § 899-bb.

Time is Money Join Law Insider Premium to draft better contracts faster.