Scope of Work and Milestones. The RECIPIENT shall perform the Project in accordance with this Agreement and as outlined in Application RP101219 submitted by the RECIPIENT and approved by the INSTITUTE. The RECIPIENT shall conduct the Project within the State of Texas with Texas-based employees, Contractors and/or Collaborators unless otherwise specified in the Scope of Work or the Approved Budget. The INSTITUTE and the RECIPIENT hereby adopt the terms of Attachment A in their entirety, incorporate them as if fully set forth herein, and agree that the Project description, goals, timeline and milestones included as Attachment A accurately reflect the Scope of Work of the Project to be undertaken by the RECIPIENT (the “Scope of Work”) and the milestones expected to be achieved. RECIPIENT and the INSTITUTE mutually agree that the outcome of scientific research is unpredictable and cannot be guaranteed. The RECIPIENT shall use commercially reasonable efforts to complete the goals of the Project pursuant to the timeline reflected in Attachment A and shall timely notify the INSTITUTE if circumstances occur that materially and adversely affect completion thereof. Modifications, if any, to the Scope of Work must be agreed to in writing by both parties as set forth in Section 2.06 “Amendments and Modifications” herein. Material changes to the Scope of Work include, but are not limited to, changes in key personnel involved with the Project, the site of the Project, and the milestones expected to be achieved.
Scope of Work and Milestones. Include the Detailed Project Plan here (Scope of Work). The project plan must describe, in detail, the activities to be undertaken, including the proposed work, reporting, major tasks, and project milestones including the identification of the anticipated start and ending dates of all major stages/tasks of the project proposal. This section does not have to include the entire project proposal but needs to include enough detail and set forth estimated milestones for the activities to be conducted under the Agreement. The full project proposal, if necessary, can also be incorporated by attachment to the agreement. However, incorporation by attachment does not alleviate the requirement to provide the description of the scope of work in this section along with the major project milestones.
Scope of Work and Milestones. Under this Agreement, the Recipient’s project team (Project Team) shall conduct research to identify better surrogates for online monitoring of virus rejection (Project). The Project will aim to identify surrogates that can be measured with practical online monitors, or by collecting frequent grab samples to mimic online monitoring, to enable continuous monitoring of reverse osmosis (RO) performance for reuse scenarios where demonstrating pathogen log removal is critical to public health. The Project will be accomplished in two parts. Part 1 of the Project will take place at the Orange County Water District (OCWD) Advanced Water Purification Facility (AWPF) and will test novel surrogates for 3-6 months at a full-scale reuse facility to assess their feasibility to replace traditional surrogates. Part 2 will take place at the Padre Dam Municipal Water District (Padre Dam) Advanced Water Purification (AWP) demonstration facility with a closed-circuit reverse osmosis (CCRO) pilot unit to identify a membrane integrity surrogate that allows pathogen removal crediting greater than 2 logs.
Scope of Work and Milestones. The city will construct three new recharge basins. The recharge basins will be approximately four acres in size and will include sloped concrete or reinforced geotextile sides. The basins will include a flow control building, new electrical supply, pipeline connections to the main EBWF recharge pipelines, supervisory control and data acquisition (SCADA) equipment, monitoring xxxxx, security fencing, flow meters, valving, and other appurtenances. Milestone / Task / Activity Planned Start Date Planned Completion Date Recharge Basin Site Assessment January 2022 December 2022 Screening Level Evaluation January 2022 December 2022 Hydrogeological Investigation January 2022 December 2022 Permitting and Design January 2023 December 2023 Construction of New Basins and Supporting Infrastructure January 2024 December 2025
Scope of Work and Milestones. Phase I will require exploratory xxxxx to be completed for testing, planning, permitting, design, determining characteristics, and monitoring water level, pressure, flow rate, and quality. The exploratory xxxxx must be drilled to the full design diameter and depth, and must have the casing installed, to correctly test their capacity. Camino del Medio well funds will be used for pumping system and infrastructure. Completion of this phase is required to ensure success of the finalized groundwater xxxxx required to be constructed by the settlement. The tasks under this project includes: Task 1: Project Management, Grant Administration, and Meetings Task 2: Bataan Well Planning, Permitting, and Design Task 3: Camino del Media Well Pumping System and Infrastructure Task 4: Mitigation Well C Planning, Permitting, and Design Task 5: National Guard Well Planning, Permitting, and Design Task 6: UNM/Xxxxxx Well Planning, Permitting, and Design Task 7: Rio Pueblo Well Planning, Permitting, and Design Task 8: Treatment System Planning, Permitting, and Design Town of Taos Project Schedule FY17 FY18 FY19 FY20 Tasks Q1 Q2 Q3 Q4 Q1 Q2 Project Management, Grant Administration and Meetings Xxxxx oversight and management (ToT ) Contractor Oversight and Management (ToT) X X Billing and Coordination with Bureau of Reclamation X Xxxxxx Implementation Meetings X X X X X X X X Meetings with the Office of the State Engineer (OSE) X X X X X Monthly Progress Meetings/Conference calls X X X X X X X X Project staff meetings/Town Attorney Participation X X X X X X X X 6. RESPONSIBILITY OF THE PARTIES
Scope of Work and Milestones. This proposed project would redirect available raw water from Xxx Xxxxx Reservoir, a Bureau of Reclamation project and the City's principal source of supply, to Altus City Reservoir, a largely unused municipal supply originally constructed in 1940. The project would include the installation of sluice gates and weirs and renovation of the original pump station, built almost 80 years ago but currently unused. This project is expected to take 24 months to complete, including design, bidding and construction. The City is separately funding design, bidding, and construction management. Only the construction contract costs are included in the final budget for this agreement. Pipeline and Appurtenances The project involves tapping the existing 36-inch City-owned water line on the south side of the 1 million gallon holding tank that receives raw water from Xxx Xxxxx and installing a 36-inch by 30-inch tee with new gate valves on both the existing 36-inch pipe and the new 30-inch pipe. 4,050 feet of 30-inch C905 PVC pipe will be installed to convey raw water from the water treatment plant to the northeast corner of the east basin. Five 45 degree bends and one 22 degree bend will be needed. A new magnetic flow meter will also be installed on the 30-inch pipeline. A new 6ft x 6ft concrete headwall will be poured to stabilize the bank where the pipe discharges into the lake. Pump Station Restoration The existing pump station near the southwest corner of the east basin will be rehabilitated and brought back into service. It was constructed in 1939 and still has the original pump and controls. It has not been in use for decades. A new 30 HP pump will be installed to convey reservoir water to the water treatment plant. This restoration will also include new pump controls and electric improvements to bring the pump station up to code. Sluice Gates Sluice gates will be installed on the concrete box culverts that connect the western and eastern basins of the City Reservoir. This is needed to keep high salinity water in the west basin from contaminating the cleaner water in the east basin. The two existing culverts are at different elevations. The lower elevation culvert is currently submerged on both ends and will have sluice gates installed on each end. The higher culvert currently is above the water on both ends and is dry. This will have a sluice gate installed on the western end only. Sluice gates will also be installed on the two concrete siphon pipes that are connec...
Scope of Work and Milestones. The NCWD is requesting assistance to conduct an appraisal of the quantity and quality of existing water resource supplies in the County and surrounding areas populated with small communities and Tribes, which is essential to support planning efforts for community and economic development, identify existing and projected demands, and determine the infrastructure required to continue to serve existing and projected, uncontrolled population growths in the area, neighboring Counties and communities, and plan management strategies that can be implemented to ensure the availability of an adequately clean water supply, bring water systems in compliance with acceptable drinking water supply standards, and identify back-up sources of drinking water. Small rural communities and surrounding Counties are dispersed throughout the geographic area and lack advanced infrastructure due to their isolation. Potential impacts of large industrial developments, mining operations, underground storage tanks, landfills, methamphetamine laboratories, gas stations, dairy farms, refineries, and manufacturing facilities present the possibility of water supply contamination. Soil contamination resulting from petroleum, heavy metals, and animal waste releases at these sites and the potential transfer of preventable contamination to the groundwater that serves as the County‘s drinking water supply is of major concern. The NCWD will work cooperatively with the Xxx County Administration and Nuclear Waste Repository Project Office (NWRPO) to coordinate and oversee the Project. Personnel assigned to the Project are: Xxxxxxx Xxxx, Acting General Manager of the NCWD and Director of NWRPO; Xxxx Xxxxxx, Geoscience Manager and Acting Natural Resources Manager, NWRPO; and Xxx Xxxxxxx, Grants Administrator, Xxx County Administration. Xxxx Xxxxxx, Xxxxxxx Xxxx and Xxx Xxxxxxx will prepare request for proposals for a Hydrology Consultant and select an appropriate contractor through a competitive bidding process to complete the appraisal investigation and report. Xxxx Xxxxxx will coordinate Reclamation and with selected contractor to review the contractor‘s data and document summaries and throughout preparation of the report, and will review the draft and final reports, participate in stakeholder meetings, coordinate with selected contractor throughout the preparation of the report and will review the draft and final reports; Xxxxxxx Xxxx will oversee activities and report progress to the NCWD Governi...
Scope of Work and Milestones. The City of Gallup shall replace 9 - 26 industrial, commercial and institutional mechanical water meters. Existing mechanical meters will be replaced with sonic and electromagnetic meters ranging in size from 2 inches to 6 inches. The meters will be replaced within the service area of the Water/Wastewater Department of the City of Gallup located at latitude and longitude 35.5281° N,108.7426° W. On the next page please see the attached list of meters that will be potentially replaced under this Agreement. In the Final Performance Report for the Agreement, the Recipient shall identify the locations of the meter installations completed under this Agreement. Gallup ICI Water Audits and AMR Meters (8-27-19) Milestones for the completion of the Scope of Work are as follows: Milestone / Task / Activity Planned Start Date Planned Completion Date Environmental and cultural compliance activities XXX XXX Begin installation of meters 06/01/20 06/30/20 Installation of meters (50% complete) 10/01/20 11/30/21 Installation of meters complete 12/31/20 01/31/21
Scope of Work and Milestones. Under this Agreement, the Recipient shall design and install an intertie pipeline to connect 3.2 miles of the Central Feeder water transmission pipeline to the EBX of the California Aqueduct. The intertie will facilitate the delivery of an additional 3,750 acre-feet per year of water stored in the Bunker Hill Basin. Project components are anticipated to include: Approximately 500 linear feet of pipe for the intertie, ranging in size from 24-inches to 60-inches Associated valves and meters A flow control vault structure, a guard valve vault, and a manhole structure Supervisory Control and Data Acquisition controls, process instrumentation controls and new electrical work The intertie will be constructed within San Bernardino Valley Municipal Water District’s service area at 0000 Xxxx Xxxxxx, Xxxxxxx, XX 00000, as shown in the map included below. The project latitude is 34.077800’N and longitude is 117.134001’W. The milestones for the completion of the Project are as follows: Milestone / Task / Activity Planned Start Date Planned Completion Date Complete environmental and cultural compliance November 2019 June 2020 Engineering and design October 2019 June 2020 Permitting March 2020 September 2020 Procurement for materials and supplies April 2020 December 2020 Mobilization November 2020 December 2020 Install piping December 2020 June 2021 Install concrete structures December 2020 June 2021 Implement controls and electrical work January 2021 June 2021 Testing and Implementation June 2020 June 2021
Scope of Work and Milestones. Under this Agreement, the Recipient shall plan, permit, design, engineer, construct, and equip the following five (5) deep water xxxxx described in and in accordance with the Taos Indian Water Rights Settlement Agreement (Settlement Agreement) Mutual Benefits Projects: • Bataan Well • Mitigation Well C • National I Guard Well • Xxxxxx Well • Rio Pueblo Well In addition, the Recipient shall permit, plan and construct a water treatment facility including plumbing and appurtenances, that will connect to the Town of Taos water system.
