Sanitary Sewer. Provide a standard bubble map, as part of the plans, showing locations of numbered points, and a table with point number, northing and easting coordinates, description, and BL station for each point, for the following: ▪ all possible control as established or attained during preliminary survey, including but not limited to – section corners, property irons, intersection center-center irons, other set monuments ▪ benchmarks, including TBM set with preliminary survey ▪ center of manholes ▪ end of manhole stubs (when longer than five feet)
Sanitary Sewer. 3.09 Before the Payment Date, the Developer shall pay to the City the Sanitary Sewer Assessment Levy per hectare of the Development Area as set out in Schedule 2.
Sanitary Sewer. The Developer hereby agrees:
Sanitary Sewer. This plat is subject to a lateral sanitary sewer special assessment under Minnesota Statutes Chapter 429. The assessment rate is adjusted annually. The 2019 rate is $1,277 per acre. If the development contract is signed by the Developer and City in 2019, the assessment amount is calculated as follows: 4.825 acres minus 0.265 acres of wetland = 4.560 acres x $1,277 per acre = $5,823.12. If the development contract is signed in another year, that year’s per acre rate will be used in the calculation. The assessment will be divided evenly among the lots and blocks in the final plat. The charge will be spread over five years at 3.33% interest on the unpaid balance. The assessment shall be deemed adopted on the date this contract is signed by the City. The Developer waives any and all procedural and substantive objections to the special assessment, including but not limited to, hearing requirements and any claim that the assessment exceeds the benefit to the property. The Developer waives any appeal rights otherwise available pursuant to M.S.A. 429.081.
Sanitary Sewer. 30. The Developer agrees to connect to the existing sanitary sewer system at a point to be determined by the Town Engineer and utilizing methods of connection approved by the Town Engineer.
Sanitary Sewer. (a) This property is currently serviced by the municipal sanitary sewer system. The existing 100mm-diameter service will be adequate for the proposed development and may be retained. An inspection chamber (IC) must be installed on the service at the owner’s cost as required by the sewer-use bylaw.
Sanitary Sewer. Design and construct sanitary sewer main lines within the project roadways and easements where necessary, to serve each lot within the project development. Plans will include main line connections to existing trunk sewers. (See attached Sewer System.)
Sanitary Sewer. Sanitary sewer service shall be installed to service the new Lot 2 by City forces, to current bylaw standards. The Owner will be responsible for all related costs of installation of the new service.
Sanitary Sewer. (a) If a larger service is required it can be provided at the owner’s cost.
Sanitary Sewer. The existing house is provided with a single 100mm-diameter sanitary sewer service that shall be used to service the main residence and the proposed suite. An inspection chamber is in place. The Owner shall arrange for individual lot connections before submission of the subdivision plan, including payment of connection fees, and shall provide a copy of the receipt. A sanitary service for the proposed additional lot shall be provided by the Owner from a 200mm diameter PVC sewer main on Park Avenue.
