Rigid Board Insulation Sample Clauses

Rigid Board Insulation. 8.3.1 Rigid board insulation shall be cut accurately for the job requirements; all joints will be tightly butted. Insulation shall be cut to fit between standing seams and stiffeners and shall be secured by impaling over metal fasteners or welded pins. The excess pin length will be cut off or bent over. The washer will be set solidly into the insulation surface. All fastener and washer penetrations shall be sealed to provide a complete vapor barrier. Joints at stiffeners, standing seams and angle irons will be insulated and then will be completely sealed.
AutoNDA by SimpleDocs

Related to Rigid Board Insulation

  • Insulation In exterior walls? Yes No Unknown In ceiling/attic? Yes No Unknown In any other areas? Yes No Where? Comments:

  • COVID-19 Protocols Contractor will abide by all applicable COVID-19 protocols set forth in the District’s Reopening and COVID-19 Mitigation Plan and the safety guidelines for COVID-19 prevention established by the California Department of Public Health and the Ventura County Department of Public Health.

  • Prescription Medications Medications whose sale and use are legally restricted to the order of a physician.

  • ROAD DIMENSIONS Purchaser shall perform road work in accordance with the dimensions shown on the TYPICAL SECTION SHEET and the specifications within this road plan.

  • Technical Standards Applicable to a Wind Generating Plant i. Low Voltage Ride-Through (LVRT) Capability A wind generating plant shall be able to remain online during voltage disturbances up to the time periods and associated voltage levels set forth in the standard below. The LVRT standard provides for a transition period standard and a post-transition period standard.

  • Uniform Cleaning The County agrees to provide for a contract cleaning arrangement whereby pickup service will be available at the Yakima County Department of Corrections. Cleaning shall be authorized for all personnel required to wear uniforms in the course of their employment. The County shall determine the place where such clothing shall be cleaned and make disbursements directly to the contract cleaner(s).

  • Reporting of Metered Data and Parameters 7.2.1 The grid connected Solar PV power plants will install necessary equipment for regular monitoring of solar irradiance (including GHI, DHI and solar radiation in the module plane), ambient air temperature, wind speed and other weather parameters and simultaneously for monitoring of the electric power (both DC and AC) generated from the Project.

  • Smoke Detectors At Owner's expense, smoke detectors will be installed on the Property in working condition in accordance with the law prior to the tenant's occupancy. During the occupancy, it shall be the tenant's responsibility to maintain all smoke detectors. Owner will replace smoke detector equipment as needed.

  • Safety Boots Each employee, after 3 months’ continuous service, will be reimbursed (on production of a receipt), the cost of one pair of safety boots (approved by the employer), in each year, to a maximum of $110.00. Wet Weather All protective clothing such as wet weather jackets, safety helmets, welding jackets, welding xxxxxxx, welding gauntlets, rubber boots, etc, (which remain the property of the Company), will be supplied on all occasions deemed necessary.

  • Packaging Materials and Containers for Retail Sale Packaging materials and containers in which a good is packaged for retail sale shall, if classified with the good, be disregarded in determining whether all the non-originating materials used in the production of the good undergo the applicable change in tariff classification set out in Annex 4, and, if the good is subject to a regional value-content requirement, the value of such packaging materials and containers shall be taken into account as originating or non-originating materials, as the case may be, in calculating the regional value content of the good.

Time is Money Join Law Insider Premium to draft better contracts faster.