Remote Services. Remote Services offer a secure remote internet connection to FPA-5000/FPA-1200 for system integrators. The following features are available: – Remote Maintenance – Remote Connect – Remote Alert For these services the secure network gateway for Remote Services is required. For detailed instructions on setting up any of the Remote Services please refer to the Networking Guide.
Remote Services. Remote Support Desk Services will be provided 24x7. Client agrees that Marco may provide Support Desk Services remotely and that Marco may install such software on Client’s personal computers and servers as Xxxxx xxxxx appropriate in its sole discretion for that purpose (“Remote Access Software”). Client agrees to provide Marco with: a) access to Client Equipment; b) Client Information and Access (defined below); and
Remote Services. Certain models of Equipment are supported and serviced using product information that is automatically collected by Xerox or transmitted to or from Xerox by the Equipment connected to your network ("Remote Product Info") via electronic transmission to a secure off-site location ("Remote Transmission"). Remote Transmission also enables Xerox to transmit Releases of Software to you and to remotely diagnose and modify Equipment to repair and correct malfunctions. Examples of Remote Product Info include product registration, meter read, supply level, Equipment configuration and settings, software version, and problem/fault code information. Remote Product Info may be used by Xerox for billing, report generation, supplies replenishment, support services, recommending additional products and services, and product improvement/development purposes. Remote Product Infowill be transmitted to and from you in a secure manner mutually agreeable to the parties. Remote Transmission will not allow Xerox to read, viewor download the content of any of your documents or other information residing on or passing through the Equipment or your information management systems. You grant the right to Xerox, without charge, to conduct Remote Transmission for the purposes described above. Upon Xerox's request, you will (a) provide contact information for Equipment such as name and address of your contact and IP and physical addresses/locations of Equipment and (b) ensure that any Maintenance Release or Update released by Xerox to provide security patches, releases and/or certificates for the Remote Transmission and/or Software is promptly enabled by Customer upon notification by Xerox or by the Equipment or when otherwise made available on xxxxx.xxx. You will enable Remote Transmission via a method mutually agreeable to both parties, and you will provide reasonable assistance to allow Xerox to provide Remote Transmission. Unless Xerox deems Equipment incapable of Remote Transmission, you will ensure that Remote Transmission is maintained at all times Maintenance Services are being performed. If you are unable to maintain Remote Transmission, or if Xerox disables Remote Transmission from any Equipment at your request, or if you disable Remote Transmission fromany Equipment, Xerox reserves the right to charge you a per device fee for such affected Equipment due to the increased service visits that will be required in order to (x) obtain such information, (y) provide such transmissions,...
Remote Services. Certain models of Equipment are supported and serviced using data that is automatically collected by Xerox or transmitted to or from Xerox by the Equipment connected to your network ("Remote Data") via electronic transmission to a secure off-site location ("Remote Data Access"). Remote Data Access also enables Xerox to transmit Releases of Software to you and to remotely diagnose and modify Equipment to repair and correct malfunctions. Examples of Remote Data include product registration, meter read, supply level, Equipment configuration and settings, software version, and problem/fault code data. Remote Datamay be used by Xerox for billing, report generation, supplies replenishment, support services, recommending additional products and services, and product improvement/development purposes. Remote Data will be transmitted to and from you in a secure manner specified by Xerox. Remote Data Access will not allow Xerox to read, viewor download the content of any of your documents or other information residing on or passing through the Equipment or your information management systems. You grant the right to Xerox, without charge, to conduct Remote Data Access for the purposes described above. Upon Xerox's request, you will provide contact information for Equipment suchas name and address of your contact and IP and physical addresses/locations of Equipment. You will enable Remote Data Access via a method prescribed by Xerox, and you will provide reasonable assistance to allow Xerox to provide Remote Data Access. Unless Xerox deems Equipment incapable of Remote Data Access, you will ensure that Remote Data Access is maintained at all times Maintenance Services are being performed.
Remote Services. (a) S&SC will ensure that the Remote Services achieve a monthly uptime percentage of at least 99.9% (the “Service Level”), where such uptime is calculated as the total number of minutes in a calendar month minus the number of minutes of unavailability suffered in a calendar month, as such unavailability is limited in subsection (b), divided by the total number of minutes in the calendar month. If the Service Level is not met during any calendar month, then Customer, as its exclusive remedy, may, upon written request to S&SC in accordance with subsection (c) (a “Service Level Claim”), request a service credit calculated as follows: Service Level Service Credit
Remote Services. Additional professional services associated with Customer’s subscription outside of the scope of any Set- Up Services will be in accordance with a statement of work under a separate professional services agreement between Customer and IBM.
Remote Services. Client acknowledges and agrees that Provider may provide Remote Services to Client to assist in analyzing and Resolving any Incident. Client agrees to provide Provider with access to Client's network, system, and or computers to install and use remote access software ("Remote Access Software") necessary for Provider to provide the Remote Services to Client. The Remote Access Software contains technological measures designed to collect and transmit to Provider certain diagnostic, technical, usage, and related information, including information about Client's computers, systems, network, and any Third-Party Materials, relating to or derived from Client's use of Software. Client acknowledges and agrees that: (a) Provider may collect, maintain, process, and use this information in the course of performing the Services under these Terms, provided that Provider shall only access, control, and gather such information that it reasonably believes to be necessary to assist in analyzing and Resolving an Incident; and (b) all or portions of the Remote Access Software may remain on Client's network, system, or computers after an Incident is Resolved.
Remote Services. Remote connection Notice! If another menu is called up while the remote connection is still active, Teleservice Active is displayed. To blank out the text, touch the screen. The text re-appears every 30 seconds for as long as the remote connection remains active. To create a remote connection via telephone: – In the start menu, select Further functions – Remote access – Enable call The system can now be called from remote. Afterwards, the connection is disconnected. – Active is displayed when a connection has been made. To disconnect the connection, select Stop remote access . Remote Maintenance To stop the data transmission of Remote Maintenance: – In the start menu, select Further functions – Remote Services
Remote Services any Service or set of Services offered by Pay Unicard under this Agreement that can be provided to the Client through the Remote Service Channels.
Remote Services. Client agrees that Xxxxx may provide Services remotely and that Xxxxx may install such software on Client’s computers, servers, devices as Xxxxx xxxxx appropriate in its sole discretion for that purpose (“Remote Access Software”). Client agrees to provide Xxxxx with: a) access to Client Equipment; b) Client Information and Access (defined below); and c) any other items Marco reasonably requests for the installation of the Remote Access Software and for Marco’s remote provision of Support Desk Services to Client.
