Relevant Items Sample Clauses

Relevant Items. In carrying out their functions under Article 6 of the Order, the Regulator and the Department acknowledge that mitigation measures normally available under regulation (e.g. Reserves, IDOKs) cannot be used in the initial period. The Regulator and the Department will therefore agree relevant items for which some provision, outside a determination, should be made. Where the Department and the Regulator have agreed additional provision for relevant items they will agree that such expenditure should be included in a bid for public expenditure resources in addition to determined expenditure. However, any such additional provision must be held by the Department and only made available to xxx Xxxxxxxxxx in accordance with agreed written procedures for dealing with alterations to funding.
AutoNDA by SimpleDocs
Relevant Items. 10.1. This clause 10 applies to such of the Relevant Items which, at any time, are sited at the Location (and references in this clause 10 to the ‘Relevant Items’ shall be construed accordingly).

Related to Relevant Items

  • Commercial Items The Software, including all related documentation, are “Commercial Item(s),” as that term is defined at 48 C.F.R. Section 2.101, consisting of “Commercial Computer Software” and “Commercial Computer Software Documentation,” as such terms are used in 48 C.F.R. Section 12.212 or 48 C.F.R. Section 227.7202, as applicable. Consistent with 48 C.F.R. Section 12.212 or 48 C.F.R. Sections 227.7202-1 through 227.7202-4, as applicable, the Commercial Computer Software and Commercial Computer Software Documentation are being licensed to U.S. Government end users (i) only as Commercial Items; and (ii) with only those rights as are granted to all other end users pursuant to the terms and conditions herein. Unpublished-rights reserved under the copyright laws of the United States.

  • Measurement and Billing The Parties shall measure Interconnection in accordance with this Section 4.6 and xxxx in accordance with Article XXVII and this Section 4.6.

  • Account Verification Whether or not a Default or Event of Default exists, Agent shall have the right at any time, in the name of Agent, any designee of Agent or any Borrower, to verify the validity, amount or any other matter relating to any Accounts of Borrowers by mail, telephone or otherwise. Borrowers shall cooperate fully with Agent in an effort to facilitate and promptly conclude any such verification process.

  • SECURITY PROCESSES If requested by an Authorized User as part the Request for Quote process, Contractor shall complete a Consensus Assessment Initiative Questionnaire (CAIQ) including on an annual basis thereafter, if requested by the Authorized User. The CAIQ is available at Cloud Security Alliance (xxxxx://xxxxxxxxxxxxxxxxxxxxx.xxx/). The CAIQ may be used to assist the Authorized User in building the necessary assessment processes when engaging with Contractors. In addition to a request for a CAIQ, Contractor shall cooperate with all reasonable Authorized User requests for a Written description of Contractor’s physical/virtual security and/or internal control processes. The Authorized User shall have the right to reject any Contractor’s RFQ response or terminate an Authorized User Agreement when such a request has been denied. For example, Federal, State and local regulations and/or laws may require that Contractors operate within the Authorized User’s regulatory environment. In order to ensure that security is adequate and free of gaps in control coverage, the Authorized User may require information from the Contractor’s Service Organization Controls (SOC) audit report.

  • Adding agenda items Any agenda item requiring a decision by the Members of a Consortium Body must be identified as such on the agenda. Any Member of a Consortium Body may add an item to the original agenda by written notification to all of the other Members of that Consortium Body up to the minimum number of days preceding the meeting as indicated below. General Assembly 14 calendar days, 7 calendar days for an extraordinary meeting Executive Board 2 calendar days

  • Allowable Customizations The Student is permitted to alter or add files to customize the assigned Computer to her/his own working style (i.e., background screens and images, display settings).

  • MEASUREMENT AND VERIFICATION The goal of this task is to report the benefits resulting from this project. Project team may use in- house expertise of the project demonstration site or use third party vendor for measurement and verification (M&V) of GHG and energy consumption reduction. The Recipient shall: • Enter into agreement with M&V subcontractor per Task 1.9 (if using outside vendor) • Coordinate site visits with the M&V subcontractor at the demonstration site(s) • Develop M&V protocol for pre-installation measurement (and calculations) following Section II.B.2 of the grant solicitation manual3: o Electric, natural gas and/or other fossil fuel consumption and greenhouse gas emissions (use appropriate emissions factor from Attachment 8 of the grant solicitation) of the equipment/process/system(s)/sub-system(s) that are be upgraded and/or replaced and/or modified; and o If necessary, ensure installation of sub-metering equipment and data loggers for pre/post data analysis. • Prepare and provide a detailed M&V Plan for each project demonstration site to include but not be limited to: o A description of the monitoring equipment and instrumentation which will be used; o A description of the key input parameters and output metrics which will be measured; o A description of the M&V protocol and analysis methods to be employed; and o A description of the independent, third-party measurement and verification services to be employed, if applicable. • Perform three months (or shorter period as approved in writing by the CAM) of pre- installation measurements (and calculations) based on the M&V protocol for pre- installation. • Prepare and provide a Pre-Installation M&V Findings Report that includes M&V protocol, pre-install measurements (and calculations), analysis, and results performed in this task. • Develop M&V protocol for post-installation measurements (and calculations) of: o Electric, natural gas and/or other fossil fuel consumption and greenhouse gas emissions (use appropriate emissions factor from Attachment 8 of the grant solicitation) of the equipment/process/system(s)/sub-system(s) that will be upgraded and/or replaced and/or modified.  Perform 12 months (or shorter period as approved in writing by the CAM) of post- installation measurements based on M&V protocol for post-installation. • Provide a summary of post-installation M&V progress in Progress Report(s) (see subtask 1.5) which shall include but not be limited to: o A narrative on operational highlights from the reporting period, including any stoppages in operation and why; and o A summary of M&V findings from the reporting period. • Analyze post-installation electrical, natural gas and/or other fossil fuel consumption and GHG emissions. 3 GFO-18-903, Food Production Investment Program, California Energy Commission, November 2018. xxxxx://xxx.xxxxxx.xx.xxx/contracts/GFO-18-903/000_FPIP_Solicitation_Manual.docx • Prepare and provide a Post-installation M&V Findings Report that includes M&V protocol, pre and post install measurements (and calculations), analysis, and results performed in this task. Results should at a minimum report on the reduction of electricity, natural gas and/or other fossil fuel usage and reductions of GHG emissions that directly result from this project.

  • Additional Items The Insurer has received such other documents, instruments, approvals or opinions in form and substance reasonably satisfactory to the Insurer as are reasonably requested by the Insurer, including evidence reasonably satisfactory to the Insurer that the conditions precedent, if any, in the Transaction Documents have been satisfied.

  • Traffic Measurement and Billing over Interconnection Trunks 6.1 For billing purposes, each Party shall pass Calling Party Number (CPN) information on at least ninety-five percent (95%) of calls carried over the Interconnection Trunks.

  • Payment and Billing All Subscription Charges are due in full upon commencement of Your Subscription Term, or with respect to a Deployed Associated Service, at the time such Deployed Associated Service is purchased, subscribed to or otherwise deployed, unless otherwise expressly set forth in this Agreement, an Order Form, a Statement of Work, or in Supplemental Terms, or as otherwise agreed for Usage Charges. You are responsible for providing valid and current payment information and You agree to promptly update your Account information, including payment information, with any changes that may occur (for example, a change in Your billing address or credit card expiration date). If You fail to pay Your Subscription Charges or any other charges indicated on any Order Form or Statement of Work, or in any Supplemental Terms, within five (5) business days of Our notice to You that payment is delinquent, or if You do not update payment information upon Our request, in addition to Our other remedies, We may suspend or terminate access to and use of the Services by You, Agents and End-Users.

Time is Money Join Law Insider Premium to draft better contracts faster.