Builder’s Risk Insurance Contractor shall provide a Builder’s Risk Policy to be made payable to the Owner and Contractor, as their interests may appear. The policy amount should be equal to 100% of the Contract Sum, written on a Builder’s Risk “All Risk”, or its equivalent. The policy shall be endorsed as follows: The following may occur without diminishing, changing, altering or otherwise affecting the coverage and protection afforded the insured under this policy:
Flood Insurance With respect to each Mortgaged Property, obtain flood insurance in such total amount as the Administrative Agent or the Required Lenders may from time to time reasonably require, if at any time the area in which any improvements located on any Mortgaged Property is designated a “flood hazard area” in any Flood Insurance Rate Map published by the Federal Emergency Management Agency (or any successor agency), and otherwise comply with the National Flood Insurance Program as set forth in the Flood Disaster Protection Act of 1973, as amended from time to time.
Reinsurance The Contractor shall purchase reinsurance from a commercial reinsurer and shall establish reinsurance agreements meeting the requirements listed below. The Contractor shall submit new policies, renewals or amendments to OMPP for review and approval at least one hundred and twenty (120) calendar days before becoming effective. Agreements and Coverage The attachment point shall be equal to or less than $200,000 and shall apply to all services, unless otherwise approved by OMPP. The Contractor electing to establish commercial reinsurance agreements with an attachment point greater than $200,000 must provide a justification in its proposal or submit justification to OMPP in writing at least one hundred and twenty (120) calendar days prior to the policy renewal date or date of the proposed change. The Contractor must receive approval from OMPP before changing the attachment point. The Contractor’s co-insurance responsibilities above the attachment point shall be no greater than twenty percent (20%). Reinsurance agreements shall transfer risk from the Contractor to the reinsurer. The reinsurer's payment to the Contractor shall depend on and vary directly with the amount and timing of claims settled under the reinsured contract. Contractual features that delay timely reimbursement are not acceptable. The Contractor shall maintain a plan acceptable to the IDOI commissioner for continuation of benefits in the event of receivership. The Contractor must finance the greater of $1,000,000 or total projected costs as calculated by the form set forth in 760 IAC 1-70-8. The Contractor shall obtain continuation of coverage insurance (insolvency insurance) to continue plan benefits for members until the end of the period for which premiums have been paid. This coverage shall extend to members in acute care hospitals or nursing facility settings when the Contractor’s insolvency occurs during the member’s inpatient stay. The Contractor shall continue to reimburse for its member’s care under those circumstances (i.e., inpatient stays) until the member is discharged from the acute care setting or nursing facility. Requirements for Reinsurance Companies The Contractor shall submit documentation that the reinsurer follows the National Association of Insurance Commissioners' (NAIC) Reinsurance Accounting Standards. The Contractor shall be required to obtain reinsurance from insurance organizations that have Standard and Poor's claims- paying ability ratings of "AA" or higher and a Xxxxx’x bond rating of “A1” or higher, unless otherwise approved by OMPP. Subcontractors Subcontractors’ reinsurance coverage requirements must be clearly defined in the reinsurance agreement. Subcontractors should be encouraged to obtain their own stop-loss coverage with the above-mentioned terms. If subcontractors do not obtain reinsurance on their own, the Contractor is required to forward appropriate recoveries from stop- loss coverage to applicable subcontractors.
