Payment Methods A. Except as otherwise provided by this Contract, the payment method will be one or more of the following:
Time and Method of Payment (Amounts Distributed by the Administrative Agent). Except as otherwise provided in Section 4.02, all amounts payable to any Funding Agent or Investor hereunder or with respect to the Series 2019-1 Class A-1 Advance Notes shall be made to the Administrative Agent for the benefit of the applicable Person, by wire transfer of immediately available funds in Dollars not later than 3:00 p.m. (Eastern time) on the date due. The Administrative Agent will promptly, and in any event by 5:00 p.m. (Eastern time) on the same Business Day as its receipt or deemed receipt of the same, distribute to the applicable Funding Agent for the benefit of the applicable Person, or upon the order of the applicable Funding Agent for the benefit of the applicable Person, its pro rata share (or other applicable share as provided herein) of such payment by wire transfer in like funds as received. Except as otherwise provided in Section 2.07 and Section 4.02, all amounts payable to the Swingline Lender or the L/C Provider hereunder or with respect to the Swingline Loans and L/C Obligations shall be made to or upon the order of the Swingline Lender or the L/C Provider, respectively, by wire transfer of immediately available funds in Dollars not later than 3:00 p.m. (Eastern time) on the date due. Any funds received after that time on such date will be deemed to have been received on the next Business Day. The Master Issuer’s obligations hereunder in respect of any amounts payable to any Investor shall be discharged to the extent funds are disbursed by the Master Issuer to the Administrative Agent as provided herein or by the Trustee or Paying Agent in accordance with Section 4.02, whether or not such funds are properly applied by the Administrative Agent or by the Trustee or Paying Agent. The Administrative Agent’s obligations hereunder in respect of any amounts payable to any Investor shall be discharged to the extent funds are disbursed by the Administrative Agent to the applicable Funding Agent as provided herein whether or not such funds are properly applied by such Funding Agent.
Construction Methods No four course of brick-work, with three joints, shall exceed in height, when built, one inch more than the same bricks piles upon one another without mortar. The bricks are to be well soaked in water before use on works, in proper through so as to be thoroughly wet when layed. The Cessation of the bubbles through the water is an irldication of saturation being complete. For ensuring thorough soaking of the bricks every one or two bricklayers or more as necessary, shall be provided with tubs for use The wall of structures shall be carried up regularly in all cases 1` when the nature of the work will admit of it not leaving any part 915mm (3 feet) lower than another. Horizontal courses shalI be straight, level and even and faces of walls smooth and plumb. A straight edge and a plumb- xxx shall be used for constant checking during progress of the work. No brick-bats shall be permitted to be used except when necessary for obtaining the dimension of the different course or for obtaining the specified bond. All unfinished work must be raked back in course unless otherwise directed arid when new work is to be jointed to it the surface of unfinished work must be cleaned and wetted. The bricks shall be laid by placing sufficient mortar on the wall and forcing every brick into it in such a manner as to completely fill every joint with moratar whether at the bottom, side or end of the brick. The mortar to be used shall be that specified for the relevant schedule items and shall comply with the specification for the mortar specified. The bound used shall be English and shall be carried throughout the work. At all angles forming the junction of any two walls, the bricks shall, at each alternate course be carried into each of the respective walls, so as to thoroughly unite the work. V'Jhen the faces are to be plastered, the joints shall be well raked out before any plaster is laid on should the plaster from want of proper joint ranking detach and 7 fall off from the brick work, the contractor shall strip off the plaster bodily to the extent ordered by Superintending Engineer and shall re-do the work properly at his own expense. All requisite scaffolding shall be provided at the contractor's expense and shall be double i.e., must it have two sets of upright supports Care must be taken to ensure the safety of the work people and the contractor must comply with such instructions as the Superintending Engineer may issue to ensure such safety. The contractor will be entirely responsible for any damage or injuries to person or property resulting from ill-erected scaffolding, defective ladders, or otherwise arising out of his default in this respect. The brick work for the retaining wall shall proceed side by side with the depositing and compacting of earth between the retaining walls. At no time shall the brick-work be constructed more than 405mm (1'-4") above Y the compacted earth. In the retaining wall weep-holes shall be provided at suitable intervals as instructed during execution, with the inner surface of the weep-holed plastered 20mm (3/4") thick in cement mortar 1:4 crouched rock of grades in different layer shall be provided at the inner end of the weep-holes to prevent the choking of the weep-holes to have full drainage. No extra payment will be made for this and no deductions will be made for this in the brick-work.
Payment Methodology The Contractor shall be compensated based on the Service Rates in Attachment for units of service authorized by the Institution in a total amount not to exceed the Contract Maximum Liability established in Section C.1. The Contractor’s compensation shall be contingent upon the satisfactory completion of units of service or project milestones identified in Attachment B. The Contractor shall submit invoices, in form and substance acceptable to the Institution with all of the necessary supporting documentation, prior to any payment. Such invoices shall be submitted for completed units of service or project milestones for the amount stipulated.
ICE Method The method used to calculate One-Month LIBOR, as described in Section 3.05.
Compensation and Method of Payment Subject to any limitations set forth below or elsewhere in this Agreement, District agrees to pay Consultant the amounts specified in Exhibit B “Compensation”. The total compensation, including reimbursement for actual expenses, shall not exceed Four Thousand Five Hundred Dollars ($4,500.00), unless additional compensation is approved in writing by the District.
Procurement Method (a) Quality-Based Selection (b) Selection under a Fixed Budget
Transfer Methods and Amounts Section 15 of the General Terms (Payment Methods and Amounts) applies to the Service, even in circumstances where the External Account is closed and we are attempting to return funds to such Account.
Purchase Price and Method of Payment Buyer shall pay and Seller shall accept the purchase price for the Business as follows:
Materials and Methods 86 2.1 PARTICIPANTS 87 We used baseline measurements from a convenience sample of participants in previous (3) and 88 ongoing cohort studies investigating the effects of rehabilitation on balance responses (Table 1). PD 89 participants were mild-moderate with bilateral symptoms (Xxxxx and Xxxx stage 2-3 (13)). All 90 participants provided written informed consent and all study procedures were approved by Institutional 91 Review Boards at the Georgia Institute of Technology and Emory University.
