Referenced Standards This Section incorporates by reference the latest revision of the following documents. These references are a part of this Section as specified and modified. In case of conflict between the requirements of this Section and those of a listed document, the requirements of this Section shall prevail. Reference Title ANSI B16.5
International Standards 1. Each Party shall use relevant international standards, to the extent provided in Article 2.4 of the TBT Agreement, as a basis for its technical regulations.
NATIONAL STANDARDS This Agreement will not operate so as to cause any employee to suffer a reduction in ordinary time earnings or in national standards, such as national standard hours of work (38), annual leave or long service leave or any other standard which has been established by the Australian Industrial Relations Commission (AIRC).
OMB Standards Unless specified otherwise within this agreement, the Subrecipient shall procure all materials, property, or services in accordance with the requirements of 24 CFR 84.40−48.
ETHICAL STANDARDS a. Distributor and each of its sub-distributors will comply with the United States Foreign Corrupt Practices Act and without derogating from the generality of the foregoing, will not have its directors, officers or employees, directly or indirectly, offer, promise or pay any bribes or other improper payments for the purposes of promoting and/or selling Products to any individual, corporation, government official or agency or other entity. No gift, benefit or contribution in any way related to MEC or the promotion and/or sale of Products will be made to political or public officials or candidates for public office or to political organizations, regardless of whether such contributions are permitted by local laws.
WORKLOAD STANDARDS One (1) Direct Service Hour (DSH) will be equal to sixty (60) minutes of direct services.
Professional Standards The Contractor agrees to maintain the professional standards applicable to its profession and to Contractors doing business in the United States Virgin Islands.
General Standards An Assistant Professor will be competent to teach in a particular field, will be current in the literature of that field, and will seek to meet student needs in both the classroom and in non-classroom environments. However, an Assistant may be a junior member of the academic community, with little professional and/or teaching experience. Furthermore, an Assistant may have little experience in curriculum development, committee work, governance, professional and/or community service, etc. In short, an Assistant Professor generally will be new to tenure-track college teaching. For eligibility for promotion from Assistant to Associate Professor, the candidate must have served a minimum of four (4) years at the rank of Assistant Professor, and must show evidence that he/she has grown professionally and consistently has sought to meet student needs, in both the classroom and in non-classroom environments. A successful candidate for the rank of Associate Professor will have remained current in the field, and will have improved his/her teaching in some demonstrable way. He/she also will have demonstrated professional growth in one or more of the following ways: completion of additional appropriate course work (if applicable), attendance at professional conferences, service on campus and/or District committees, professional and/or community service, or, the production of some creative work. Evidence of professional growth will be drawn from a careful analysis of student evaluations and peer evaluations over a period of time, and from a critical reading of materials submitted by the candidate. For promotion from Associate to Professor, the candidate must have served a minimum of four (4) years at the rank of Associate Professor, and must show evidence that he/she has grown professionally to a point where he/she has mastered both a particular field of knowledge and the teaching of that knowledge. A successful candidate must show evidence that he/she consistently has sought to meet student needs, in both the classroom and non-classroom environments. A Professor should be a senior member of the faculty, one who has such substantial experience, knowledge, and skill that he/she could mentor junior faculty in his/her area of expertise. A Professor will have demonstrated all the same kinds of achievements and attributes necessary for promotion to the Associate Professor rank, but in addition will demonstrate that he/she is a leader in some appropriate sense. Evidence of professional growth and leadership will be drawn from a careful analysis of student evaluations and peer evaluations over a period of time, and from a critical reading of materials submitted by the candidate.
Safety Standards Performance of the Contract for all commodities or contractual services must comply with requirements of the Occupational Safety and Health Act and other applicable State of Florida and federal requirements.
REPORT STANDARDS Reports or written material prepared by the Contractor in response to the requirements of this Contract or request of the Project Officer shall, unless otherwise provided for in the Contract, meet standards of professional writing established for the type of report or written material provided, shall be thoroughly researched for accuracy of content, shall be grammatically correct and not contain spelling errors, shall be submitted in a format approved in advance by the Project Officer, and shall be submitted for advance review and comment by the Project Officer. The cost of correcting grammatical errors, correcting report data, or other revisions required to bring the report or written material into compliance with these requirements shall be borne by the Contractor. When submitting documents to APS, The Contractor shall comply with the following guidelines: All submittals and copies shall be printed on at least thirty percent (30%) recycled-content and/or tree-free paper; All submittals must be in the required tabular format in a binder. Report covers / binders shall be recyclable, made from recycled materials, and/or easily removable to allow for recycling of report pages (reports with glued bindings that meet all other requirements are acceptable); The use of plastic covers or dividers should be avoided; and Unnecessary attachments or documents not specifically asked for should not be submitted, and superfluous use of paper should be avoided.
