Power Distribution. In switchboards, distribution panelboards, branch circuit panelboards and feeders and busways allow for:
Power Distribution. Power for normal office use is provided by an underfloor raceway system from a panel located in the electrical room located on the same floor as the Premises.
Power Distribution a. Distribution shall be one electrical room for approximately each 19,000 usable square feet.
Power Distribution. Adaptaspace consoles include all internal AC power distribution. Standard power distribution is provided with UL certified surge protected power distribution bars, but optional hard‐wired configurations are available. Power bars are mounted in the equipment cabinets, as well as under the work surface to support all desktop power requirements to minimize the cables moving up and down with the work surface. Power bars are sized with sufficient outlets to support all equipment, and can be 15 amp or 20 amp. Drawings and reference information representing the proposed electrical distribution will be submitted to the customer for review and approval prior to fabrication.
Power Distribution. UNIT (PDU) Ensure that Power Distribution Unit (PDU) conforms to the following specifications:
Power Distribution. The power supply to the airport shall be provided by BESCOM/ KPTCL at 66kv level. The main power station will be provided with 2 no 16mva transformers for stepping down 66kv to 11kv. From these transformers the main power system of the airport will be supplied at 11kv level. The electrical power system includes transformer stations, a distribution network, and emergency power supply. The distribution network will be planned with ring mains, so that power supply is always possible from two different sources. An auxiliary power generator system (approx. 6 MVA) is installed in the power station north which will supply the essential consumers of the Airport in case of power supply failure.
Power Distribution. New receptacles and new branch circuits from a new branch circuit panel (or panels) are to be provided. New branch circuits will be required for any new HVAC equipment.
Power Distribution. In open office areas power will be provided to accommodate Pac-Pole installation to modular work stations. Wall outlets will be provided at the rate of 2 / 150 sq.ft. in the enclosed office and meeting room areas.
Power Distribution. This area will include electrical power distribution systems starting at the main utility company substation and continuing through the MCCs. Electrical or drive rooms civil, structural and architectural costs, are be included in that area's building cost. All electrical power will be purchased from the local utility. This proposal is based on a nominal 15 kV distribution system within the mill site. Voltage levels on this project include:
Power Distribution. Main switch, service panels and metering area have been included. Wiring for warehouse mechanical units, warehouse outlets quads at every other dock door and motor door operator at the drive-in overhead door is included. Service outlets are provided at the warehouse mechanical units. 3 bxxx ducts, end to end, 400 amps across warehouse. 6 ea empty sub panels and conduit is included. Wall duplex receptacles and phone stubs will be provided in the office area and warehouse toilet/lunchroom. Telephone/data/fire alarm outlets will include a metal junction box installed in the wall and a conduit stub continuing into the plenum area above the suspended ceiling. Office area lighting to be provided by 3 lamp, 18 cell parabolic, 2’ x 4’ lay-in fixtures and controlled by wall switches. The office electrical, emergency signs and office HVAC wiring and distribution from the office panel will be included as part of the Office Buildout Allowance.
