Typical Sections The Engineer shall prepare typical sections for all proposed and existing roadways and structures. Typical sections must include width of travel lanes, shoulders, outer separations, border widths, curb offsets, managed lanes, and ROW. The typical section must also include Proposed Profile Gradeline (PGL), centerline, pavement design, longitudinal joints, side slopes, sodding or seeding limits, concrete traffic barriers and sidewalks, if required, station limits, common proposed and existing structures including retaining walls, existing pavement removal, riprap, limits of embankment and excavation, etc.
The following sections of Section 4 OGS Centralized Contract Terms and Conditions have been renumbered as depicted in the following chart: Current Amended Section Title 4.25 4.26 Severability 4.26 4.27 Entire Agreement
RELATED SECTIONS Not Used
Miscellaneous Sections a. General Mail Facility Administrative Building – by Tour
CRIMINAL PROVISIONS AND SANCTIONS The Contractor agrees to perform the Agreement in conformance with safeguards against fraud and abuse as set forth by the H-GAC, the State of Texas, and the acts and regulations of any related state or federal agency. The Contractor agrees to promptly notify H-GAC of any actual or suspected fraud, abuse, or other criminal activity through the filing of a written report within twenty-four (24) hours of knowledge thereof. Contractor shall notify H-GAC of any accident or incident requiring medical attention arising from its activities under this Agreement within twenty-four (24) hours of such occurrence. Theft or willful damage to property on loan to the Contractor from H-GAC, if any, shall be reported to local law enforcement agencies and H-GAC within two (2) hours of discovery of any such act. The Contractor further agrees to cooperate fully with H-GAC, local law enforcement agencies, the State of Texas, the Federal Bureau of Investigation and any other duly authorized investigative unit, in carrying out a full investigation of all such incidents. The Contractor shall notify H-GAC of the threat of lawsuit or of any actual suit filed against the Contractor pertaining to this Agreement or which would adversely affect the Contractor’s ability to perform services under this Agreement.
Coverage Types and Policy Limits The types of coverage and policy limits required from the Contractor are specified in Paragraph B Insurance Requirements below.
Provisions Applicable to Certain Agreements The provisions in this section are applicable only to the types of orders specified in the first sentence of each subsection. If this Agreement is not of the type described in the first sentence of a subsection, then that subsection does not apply to the Agreement.
Tax Law Section 5-A Section 5-a of the Tax Law, requires certain Contractors awarded State Contracts for commodities, services and technology valued at more than $100,000 to certify to the NYS Department of Taxation and Finance (DTF) that they are registered to collect New York State and local sales and compensating use taxes. The law applies to Contracts where the total amount of such Contractors’ sales delivered into New York State are in excess of $300,000 for the four quarterly periods immediately preceding the quarterly period in which the certification is made, and with respect to any affiliates and subcontractors whose sales delivered into New York State exceeded $300,000 for the four quarterly periods immediately preceding the quarterly period in which the certification is made. A Vendor is required to file the completed and notarized Form ST-220-CA with OGS certifying that the Vendor filed the ST-220-TD with the NYS Department of Taxation and Finance (DTF). Please note that the NYS Department of Taxation and Finance should receive the completed Form ST-220-TD, not OGS. OGS should only receive the Form ST-220-CA. Proposed Contractors should complete and return the certification forms within five (5) business days of request (if the forms are not completed and returned with Vendor Submission). Failure to make either of these filings may render a Vendor non- responsive and non-responsible. Each Vendor shall take the necessary steps to provide properly certified forms within a timely manner to ensure compliance with the law. Website links to the Contractor certification forms and instructions are provided below. Form No. ST- 220-TD must be filed with and returned directly to DTF and can be found at xxxx://xxx.xxx.xx.xxx/pdf/current_forms/st/st220td_fill_in.pdf. Unless the information upon which the ST-220-TD is based changes, this form only needs to be filed once with DTF. If the information changes for the Contractor, its affiliate(s), or its subcontractor(s), a new Form No. ST-220-TD must be filed with DTF. Form ST-220-CA must be submitted to OGS. This form provides the required certification that the Contractor filed the ST-220-TD with DTF. This form can be found at xxxx://xxx.xxx.xx.xxx/pdf/current_forms/st/st220ca_fill_in.pdf. Vendors may call DTF at 000-000-0000 for any and all questions relating to §5-a of the Tax Law and relating to a company's registration status with the DTF. For additional information and frequently asked questions, please refer to the DTF web site: xxxx://xxx.xxx.xx.xxx.
FOIPP Clause 1. By submitting your bid, you agree to disclosure of the information supplied, subject to the provisions of the Freedom of Information and Protection of Privacy Act (FOIPP).
Prohibition on Use of Public Funds for Political Activity In performing the Services, Contractor shall comply with San Francisco Administrative Code Chapter 12G, which prohibits funds appropriated by the City for this Agreement from being expended to participate in, support, or attempt to influence any political campaign for a candidate or for a ballot measure. Contractor is subject to the enforcement and penalty provisions in Chapter 12G.
