Scoping Meeting 4.2.1 A scoping meeting will be held within ten (10) Business Days after the Interconnection Request is deemed complete, or as otherwise mutually agreed to by the Parties. The Utility and the Interconnection Customer will bring to the meeting personnel, including system engineers and other resources as may be reasonably required to accomplish the purpose of the meeting. The scoping meeting may be omitted by mutual agreement in writing.
Convening meetings The chairperson of a Consortium Body shall convene meetings of that Consortium Body. Ordinary meeting Extraordinary meeting General Assembly At least once a year At any time upon written request of the Executive Board or 1/3 of the Members of the General Assembly Executive Board At least quarterly At any time upon written request of any Member of the Executive Board
Review Meeting i. Either the BCTF or BCPSEA may request in writing a meeting to review the issues in a provincial matters grievance that has been referred to arbitration.
Orientation Meeting Within thirty (30) calendar days from execution of the Contract, Vendor and Order Fulfillers will be required to attend an orientation meeting to discuss the content and procedures of the Contract to include reporting requirements. DIR, at its discretion, may waive the orientation requirement for Vendors who have previously held DIR contracts. The meeting will be held in the Austin, Texas area at a date and time mutually acceptable to DIR and the Vendor or by teleconference, at DIR’s discretion. DIR shall bear no cost for the time and travel of the Vendor or Order Fulfillers for attendance at the meeting.
Company Meetings Attendance at Company meetings (as distinguished from store meetings) shall not be required, but shall be completely voluntary on the part of the employee.
Project Kick-off Meeting The Contractor shall hold a project kick-off meeting within thirty days from the contract execution date. The Contractor shall coordinate with NYSERDA's Project Manager to arrange the meeting at a mutually convenient time and place. The Contractor is encouraged to invite representatives of sub-contractors and equipment vendors. The purpose of this meeting shall be to finalize the strategies for accomplishing the objectives of this work. In a timely manner, the Contractor shall submit to NYSERDA’s Project Manager a brief report summarizing the issues discussed and decisions made, if any, during this meeting. Deliverable: A brief report regarding the project kickoff meeting.
Pre-Operations Meeting PURCHASER shall meet with STATE no later than 30 days from execution of the contract to discuss the Threatened and Endangered Species survey, protection, and planning requirements. Operations Plan. PURCHASER shall prepare an Operations Plan for all operations to be conducted under this contract and submit the plan to STATE at least 5 calendar days prior to commencement of any operation. This plan shall be prepared on a form provided by STATE, and shall be used for all types of operations, including road maintenance, project work, logging, and postharvest requirements. STATE may require an on-site meeting prior to approval of the plan, attended by PURCHASER, subcontractor, and STATE representatives. STATE's approval of the plan must be obtained prior to commencement of any operation, and PURCHASER must comply with this plan. If PURCHASER fails to comply with any of the terms of the plan, including completion dates, STATE may, after giving written notice, suspend PURCHASER's operations until such time as an acceptable alternate plan is submitted by PURCHASER and that alternate plan is accepted by STATE, as provided in Section 29, "Violations, Suspensions, and Cancellation." PURCHASER shall notify STATE whenever operations will be inactive for more than 3 days, and again when operations will be resumed. Upon approval by STATE, the Operations Plan shall automatically be incorporated into, and made part of, this contract. PURCHASER's strict compliance with the Operations Plan, as approved by STATE, is a material condition and covenant of this contract. STATE has prepared the required Forest Practices Act (FPA) "Written Plan" for operations within 100 feet of Type F or Type D streams. Any changes to the plan must have STATE approval. PURCHASER shall comply with all provisions of the Written Plan. Seasonal Restrictions. PURCHASER shall adhere to the following restrictions, unless otherwise approved in writing by STATE:
Kickoff Meeting 6.3.1. The Contractor shall conduct a kickoff meeting with the Purchaser to further clarify PO expectations.
STOPWORK MEETINGS 30.1 Subject to subsections 30.2 to 30.5, the employer shall allow every employee covered by this Agreement to attend, on ordinary pay, at least two meetings (each of a maximum of two hours' duration) in each year (being the period beginning on the 1st day of January and ending on the following 31st day of December) with their representatives.
TAC Meetings The goal of this subtask is for the TAC to provide strategic guidance for the project by participating in regular meetings, which may be held via teleconference. The Recipient shall: • Discuss the TAC meeting schedule with the CAM at the Kick-off meeting. Determine the number and location of meetings (in-person and via teleconference) in consultation with the CAM. • Prepare a TAC Meeting Schedule that will be presented to the TAC members during recruiting. Revise the schedule after the first TAC meeting to incorporate meeting comments. • Prepare a TAC Meeting Agenda and TAC Meeting Back-up Materials for each TAC meeting. • Organize and lead TAC meetings in accordance with the TAC Meeting Schedule. Changes to the schedule must be pre-approved in writing by the CAM. • Prepare TAC Meeting Summaries that include any recommended resolutions of major TAC issues. The TAC shall: • Help set the project team's goals and contribute to the development and evaluation of its statement of proposed objectives as the project evolves. • Provide a credible and objective sounding board on the wide range of technical and financial barriers and opportunities. • Help identify key areas where the project has a competitive advantage, value proposition, or strength upon which to build. • Advocate on behalf of the project in its effort to build partnerships, governmental support and relationships with a national spectrum of influential leaders. • Ask probing questions that insure a long-term perspective on decision-making and progress toward the project’s strategic goals. • Review and provide comments to proposed project performance metrics. • Review and provide comments to proposed project Draft Technology Transfer Plan. Products: • TAC Meeting Schedule (draft and final) • TAC Meeting Agendas (draft and final) • TAC Meeting Back-up Materials • TAC Meeting Summaries
