Office Conditions Grievances. Grievances regarding this article may only be initiated by a Union delegate or by a member of the Union’s Executive Committee.
Office Conditions Grievances Sample Clauses
Related to Office Conditions Grievances
Service Conditions Customer acknowledges that in the event of a service issue, Customer is responsible for on-site cooperative testing with LightEdge Technical Support to assist in the diagnosis of the trouble. Customer agrees to be bound to current terms of LightEdge Acceptable Use Policy. Terms of the Acceptable Use Policy are subject to change without notice. Current Acceptable Use Policy can be found here: xxxx://xxx.xxxxxxxxx.xxx/legal Customer agrees that any service complaints including concerns regarding level of support, products, service reliability, or any other concerns related to LightEdge or Services being provided by LIghtEdge will be communicated to LightEdge by sending an email to xx@xxxxxxxxx.xxx.
Safe Conditions Whenever an employee reports a condition which the employee feels represents a violation of safety or health rules and regulations or which is an unreasonable hazard to persons or property, such conditions shall be promptly investigated. The appropriate administrator shall reply to the concern, in writing, if the employee's concern is communicated in writing.
Unsafe Conditions In accordance with 29 CFR § 1977, occasions might arise when an employee is confronted with a choice between not performing assigned tasks or subjecting himself/herself to serious injury or death arising from a hazardous condition at the workplace. If the employee, with no reasonable alternative, refuses in good faith to expose himself/herself to the dangerous condition, he/she would be protected against subsequent discrimination. The condition causing the employee's apprehension of death or injury must be of such a nature that a reasonable person, under the circumstances then confronting the employee, would conclude that there is a real danger of death or serious injury and that there is insufficient time, due to the urgency of the situation, to eliminate the danger by resorting to regular statutory enforcement channels. In addition, in such circumstances, the employee, where possible, must also have sought from his Employer, and been unable to obtain, a correction of the dangerous condition.
MANAGEMENT GRIEVANCES 8.01 It is understood that the Management may at any time file a grievance with the staff representative of the Union and request a meeting with him to discuss any complaint with respect to the conduct of the Union, its officers or committee member, in its relationships with the Company or other employees or with respect to any complaint that there has been a violation of any contractual obligation undertaken by the Union, and that if such grievance by the Management is not settled to the mutual satisfaction of the conferring parties it may be referred to arbitration as set forth in Article VII above.
Technical Objections to Grievances It is the intent of both Parties of this Agreement that no grievance shall be defeated merely because of a technical error, other than time limitations in processing the grievance through the grievance procedure. To this end, an arbitration board shall have the power to allow all necessary amendments to the grievance and the power to waive formal procedural irregularities in the processing of a grievance, in order to determine the real matter in dispute and to render a decision according to equitable principles and the justice of the case.
Space Conditions All pipes passing through floors, walls, and ceilings shall be installed with sufficient space between them to permit installation of pipe insulation and floor, wall, and ceiling plates without cutting of insulation or plates. Roughed-in dimensions shall be prepared by the Contractor to accomplish this requirement. The Contractor shall locate all equipment that must be serviced, operated, or maintained in fully accessible positions. This provision includes but is not limited to valves, traps, cleanouts, motors, controllers, switchgear, drain points, filter, access doors, and fire dampers. If spaces, dimensions, or other design conditions do not permit compliance with the present article, the Contractor shall file a request in writing with the Design Professional for additional instructions, furnishing a copy to the Owner.
Code of Basic Working Conditions and Human Rights Xxxxx is committed to providing a safe and secure working environment and the protection and advancement of basic human rights in its worldwide operations. In furtherance of this commitment, Xxxxx has adopted a Code of Basic Working Conditions and Human Rights setting out in detail the measures it takes to ensure this commitment is fulfilled. This code may be downloaded at xxxxx://xxx.xxxxxx.xxx/principles/xxxxx-xxxxxx.xxxx. Xxxxx strongly encourages Seller to adopt and enforce concepts similar to those embodied in the Boeing Code, including conducting Seller’s operations in a manner that is fully compliant with all applicable laws and regulations pertaining to fair wages and treatment, freedom of association, personal privacy, collective bargaining, workplace safety and environmental protection. Seller shall include the substance of this clause, including this flowdown requirement, in all subcontracts awarded by Seller for work under this Contract.
Contract Conditions This section contains conditions which shall be complied with during the performance of this contract. The conditions come in two parts, general conditions and special contract requirements.
Training Conditions 3.1 The Trainee shall attend an approved training course or training program prescribed in the Training Agreement or as notified to the trainee by the relevant State or Territory Training Authority in accredited and relevant Traineeship Schemes.
INCLEMENT CONDITIONS Section 1.
