Mowing and Trimming Sample Clauses

Mowing and Trimming. A. Limbs and debris shall be removed from the mowing area. Debris shall include any litter in the mowing area. Debris must be removed prior to mowing.
AutoNDA by SimpleDocs
Mowing and Trimming a.) Pickup and remove limbs, litter, and debris from mowing area prior to mowing. x
Mowing and Trimming. By the cycle. A cycle is defined as the satisfactory completion of grounds maintenance in all designated areas.
Mowing and Trimming. 3.1.2 Vegetation Control
Mowing and Trimming. The Contractor shall maintain vegetation to ensure a uniform height. The Contractor shall trim vegetation within and adjacent to objects located within the lawn or field area including, but not limited to fence lines, fence fabric, brick walls, signs, street lights, power poles, guy wires, etc. Grassed areas shall be cut at a uniform height of 3 inches. Vegetation is uniform in appearance. Vegetation is not less than the minimum and at or below the maximum acceptable height specified. The Contractor shall remove and dispose of all clippings and trimmings, excluding grass clippings, in a timely manner to promote a neat and healthy appearance. Trash and debris is removed and disposed of prior to mowing and trimming and presents an overall neat appearance. 1503050 – Grounds Maintenance and Landscaping Spec Item Title Performance Objective Related Information Performance Standard Historical Note: Frequency of mowing has been generally as a rule 10 times per year from May through October. Vegetation within and adjacent to objects is trimmed to match the height and appearance of surrounding vegetation.

Related to Mowing and Trimming

  • Parking and Transportation ‌ The Union agrees that during the life of this Agreement, the University may apply changes in transportation policy, including adjusting parking and U-Pass fees and criteria for assigning parking spots, to the bargaining unit without the obligation to bargain with the Union. The Union may raise issues and concerns about the University’s parking program at Joint Labor/Management Committee meetings or at ad hoc Labor Management Committee meetings. The Union shall have a standing seat on the University’s committee(s) that work on transportation and parking issues.

  • Skidding and Yarding Methods of skid- ding or yarding specified for particular areas, if any, are indicated on Sale Area Map. Outside Clearcutting Units and construction clearings, insofar as ground conditions permit, products shall not be skidded against reserve trees or groups of reproduction and tractors shall be equipped with a winch to facilitate skidding. B6.421 Rigging. Insofar as practicable, needed rigging shall be slung on stumps or trees desig- nated for cutting.

  • Local Control Center, Metering and Telemetry The NTO shall operate, pursuant to ISO Tariffs, ISO Procedures, Reliability Rules and all other applicable reliability rules, standards and criteria on a twenty-four (24) hour basis, a suitable local control center(s) with all equipment and facilities reasonably required for the ISO to exercise ISO Operational Control over NTO Transmission Facilities Under ISO Operational Control, and for the NTO to fulfill its responsibilities under this Agreement. Operation of the NYS Power System is a cooperative effort coordinated by the ISO control center in conjunction with local control centers and will require the exchange of all reasonably necessary information. The NTO shall provide the ISO with Supervisory Control and Data Acquisition (“SCADA”) information on facilities listed in Appendices A-1 and A-2 herein as well as on generation and merchant transmission resources interconnected to the NTO’s transmission facilities pursuant to the ISO OATT. The NTO shall provide metering data for its transmission facilities to the ISO, unless other parties are authorized by the appropriate regulatory authority to provide metering data. The NTO shall collect and submit to the ISO billing quality metering data and any other information for its transmission facilities required by the ISO for billing purposes. The NTO shall provide to the ISO the telemetry and other operating data from generation and merchant transmission resources interconnected to its transmission facilities that the ISO requires for the operation of the NYS Power System. The NTO will establish and maintain a strict code of conduct to prevent such information from reaching any unauthorized person or entity.

  • Felling and Bucking Felling shall be done to minimize breakage of Included Timber and dam- age to residual timber. Unless agreed otherwise, felling shall be done by saws or shears. Bucking shall be done to permit removal of all minimum pieces set forth in A2. Purchaser may buck out cull material when necessary to produce pieces meeting Utilization Standards. Such bucked out material shall contain a minimum amount of sound wood, not in excess of the net scale in percentage of gross scale, or based on the merchantability factor, whichever is stated in A2. If necessary to assess extent of defect, Purchaser shall make sample saw cuts or wedges. B6.411 Felling in Clearings. Insofar as ground conditions, tree lean, and shape of clearings per- mit, trees shall be felled so that their tops do not extend outside Clearcutting Units, construction clearings, and ar- eas of regeneration cutting. B6.000 Xxxxx Xxxxxxx. Stumps shall not exceed, on the side adjacent to the highest ground, the maximum heights set forth in A6, except that occasional stumps of greater heights are acceptable when Purchaser determines that they are necessary for safe and efficient conduct of logging. Unless otherwise agreed, Purchaser shall re-cut high stumps so they will not exceed heights specified in A6 and shall dispose of severed portions in the same manner as other logging debris. The xxxxx heights shown in A6 were selected with the objective of maximum reasonable utilization of the timber, unless Sale Area Map shows special areas where xxxxx heights are lower for aesthetic, land treatment, or silvicultural rea- sons.

  • Cutting and Patching The Contractor shall be responsible for cutting, fitting or patching required to complete the Work or to make its parts fit together properly.

  • Sealing and Marking of Tenders 2.17.1 The Tenderer shall seal the original and each copy of the tender in separate envelopes, duly marking the envelopes as “ORIGINAL” and “COPY.” The envelopes shall then be sealed in an outer envelope.

  • Secure Information Handling and Transfers 7.1 Physical and electronic handling, processing and transferring of DWP Data, including secure access to systems and the use of encryption where appropriate.

  • TRANSPORTATION AND TRAVEL TIME 12.01 The Employer will provide transportation to and from jobs from the Employer’s shop. If an employee’s car is used for such transportation, the owner shall be paid fifty cents (50¢) per kilometre for such use.

  • Archiving and Reuse Self-Archiving: The Publisher permits the Rights Holder to archive the Contribution in accordance with the Publisher's guidelines, the current version of which is set out in the Appendix "Author's Self-Archiving Guidelines".

  • Playground ~ The playground is primarily for the use of children under the age of twelve (12). Any child caught throwing rocks, vandalizing, or hitting or teasing other children will be asked to leave the playground. An adult or appropriate baby-sitter must accompany all children under the age of six (6) years old. Garbage ~ The storage, collection and disposal of refuse and garbage in the recreational camping areas shall be conducted as to create no health hazards, rodent harborage, insect breeding areas, accident or fire hazards, or air pollution. Bag all food garbage in plastic and tie shut before placing in the dumpster, to prevent odor and rodents which are drawn to the garbage area, such as skunks, raccoons etc. Dumpster is for normal daily household garbage, no large boxes, building supplies, carpets etc. Camper is to dispose of this type of garbage elsewhere. Garbage may be placed in dumpsters only. If a dumpster is full, do not place garbage on or around the dumpster, find an empty dumpster to place your garbage into. Bags of garbage may not be set outside your camper for any reason. Disposal or deposit of hazardous or toxic waste is prohibited. No gas, oil, batteries, or car fluids may be deposited into the dumpsters or around the dumpsters. Hazardous materials will not be disposed of by the garbage service. Disposal or deposit of furniture, barbeque grills, washer, dryers, and other large household items are NOT permitted on, in or around the dumpsters. Holding Tanks ~ There is no size restriction on holding tanks, however, they must be opaque XX xxxx/black water approved tanks. The on-site dump station may be used to empty tanks that hold 50 gallons or less. For tanks over 50 gallons Camper must contract with a pumping service to pump and remove tank contents from campground. No dumping of xxxx water onto the ground. Docks ~ Campground does NOT have a lifeguard on duty. The docks are privately owned. In order to be on someone's dock you must receive permission from the dock owner. An adult must accompany all children on the docks after dark. Life jackets are required for young children fishing off docks. Running, diving, and/or horseplay are not allowed on the docks. All debris and toys must be removed from the docks, beach and marina area. Inappropriate behavior, intoxication or shouting on docks is not allowed. Glass is not allowed on the beach area. Jet skies, wave runners, etc. are not permitted in the marina area. Tires cannot be left in the marina area under boats or tied onto docks. Fish House ~ Clean up fish cleaning facility when done with your fish cleaning and bag all fish remains. Fish cleaning house must be kept clean and all fish waste must be put into plastic bags and deposited into dumpster and cover on dumpster closed. No dumping of fish wastes into marina or dog waste stations! Swimming Pool ~ Campers are required to abide by all rules posted in and around the pool area.

Time is Money Join Law Insider Premium to draft better contracts faster.