Monitoring Parameters Sample Clauses

Monitoring Parameters. 2.1.1 The Project Specific EM&A Manual designated 4 air quality monitoring stations, 2 noise monitoring stations, 21 water monitoring stations (9 Impact Stations, 7 Sensitive Receiver Stations and 5 Control/Far Field Stations) to monitor environmental impacts on air quality, noise and water quality respectively. Pre-set and fixed transect line vessel based dolphin survey was required in two AFCD designated areas (Northeast and Northwest Lantau survey areas). The impact dolphin monitoring at each survey area should be conducted twice per month.
AutoNDA by SimpleDocs
Monitoring Parameters. Water chemistry sampling must conform with the minimum required monitoring parameters in Section 12.0 of Appendix L.
Monitoring Parameters. Project Proponents shall identify parameters that can be used to properly monitor each non-neutral Sustainable Development Indicator according to section T.2.4.3 and Annex I of the Toolkit. Project Proponents shall monitor these parameters over the crediting period and on a recurrent basis to measure the impact of their Gold Standard project activities on these
Monitoring Parameters. Table 3-2 provides the monitoring parameters and reporting limits for general and major ions, nutrients and metals required for the GNA.
Monitoring Parameters. In order to establish permanent operating and monitoring parameters for the Alternative HAP Treatment Technology, PCA shall propose, contemporaneous with the submission of the analytical results from the initial performance test, values (or value ranges) for those operating parameters that WDNR and Region 5 approved in connection with the test protocol. PCA’s proposed values must be justifiable under the data collected during the initial performance test, other data and engineering assessments generated as part of the treatability study and quarterly performance tests, or manufacturers’ recommendations.
Monitoring Parameters. Water samples for total phosphorus, total nitrogen, soluble reactive phosphorus and total soluble inorganic nitrogen are collected from the euphotic zone (2.5x Secchi depth). Nitrogen variables will be monitored to evaluate N:P ratios (see discussion, Pages 16-17.) If resources allow, it is recommended that soluble phosphorus and nitrogen also be analyzed to provide a more robust data set that may help with identification of nutrient sources. Samples will be taken using a 1000 xx Xxxxxxxx sampler, and depth integrated from the euphotic zone. Chlorophyll-a samples will be collected from the same two locations. Field parameters will also include Secchi depth measured at Hope, Granite and Bayview. Detailed sampling methods will be contained in a sampling and analysis plan currently being prepared by Land & Water and to be approved by Montana and Idaho. Table 3. Sample volumes, containers, preservation and holding times for lake nutrient samples Analyte Sample Volume Container Preservation Holding Time Total P and N 125 ml polyethylene add H2SO4 to pH<2, cool to <4°C 28 days Total Soluble inorganic N4 (NO2+NO3+NH4) 125 ml polyethylene filter, add H2SO4 to pH<2, cool to <4°C 28 days Soluble Reactive Phosphorus1 125 ml polyethylene filter, cool to <4°C 48 hours Chlorophyll-a 1000 ml amber polyethylene Filter, freeze 7 days Monitoring and Assessment Program Costs‌ Funding for the following monitoring program elements will need to be covered: • Monitoring for the above parameters at two stations (Hope and Granite); • Applicable data from the Council’s existing Xxxxx Fork-Pend Oreille monitoring program; • Trend analyses and reporting; and • Source loading analysis from Idaho
Monitoring Parameters. 2.2.1 During the reporting period, there was no night-time operation of 8-car train, except on 15 January 2017, and therefore no night-time monitoring was conducted for 8-car train between 16 January and 14 February 2017. However, due to adverse weather on 15 January 2017, night-time noise monitoring was cancelled.
AutoNDA by SimpleDocs

Related to Monitoring Parameters

  • Monitoring Plan keep up with the objectives from the cadetship practice booklet; taking daily notes as well as learning new information every day; currently reporting to the supervisor. Evaluation plan: the final result should be in accordance with the traineeship’s aims and objectives, achieving an improvement of specialty knowledge and language skills. The level of language competence9 in English that the trainee already has or agrees to acquire by the start of the mobility period is: A1 ☐ A2 ☐ B1 ☐ B2 ☒ C1 ☐ C2 ☐ Native speaker ☐ Table B - Sending Institution Please use only one of the following three boxes: 10 The traineeship is embedded in the curriculum and upon satisfactory completion of the traineeship, the institution undertakes to:Award ……...…ECTS credits (or equivalent)11 Give a grade based on: Traineeship certificate ☒ Final report ☒ Interview ☐ Record the traineeship in the trainee's Transcript of Records and Diploma Supplement (or equivalent). Record the traineeship in the trainee's Europass Mobility Document: Yes ☒ No ☐ The traineeship is voluntary and, upon satisfactory completion of the traineeship, the institution undertakes to: Award ECTS credits (or equivalent): Yes ☐ No ☐ If yes, please indicate the number of credits: …. Give a grade: Yes ☐ No ☐ If yes, please indicate if this will be based on: Traineeship certificate ☐ Final report ☐ Interview ☐ Record the traineeship in the trainee's Transcript of Records: Yes ☐ No ☐ Record the traineeship in the trainee's Diploma Supplement (or equivalent). Record the traineeship in the trainee's Europass Mobility Document: Yes ☐ No ☐ The traineeship is carried out by a recent graduate and, upon satisfactory completion of the traineeship, the institution undertakes to: Award ECTS credits (or equivalent): Yes ☐ No ☐ If yes, please indicate the number of credits: …. Record the traineeship in the trainee's Europass Mobility Document (highly recommended): Yes ☐ No ☐ Accident insurance for the trainee The Sending Institution will provide an accident insurance to the trainee (if not provided by the Receiving Organisation/Enterprise): Yes ☐ No ☒ The accident insurance covers: - accidents during travels made for work purposes: Yes ☐ No ☒ - accidents on the way to work and back from work: Yes ☐ No ☒

  • Signaling Parameters All SS7 signaling parameters will be provided in conjunction with traffic exchange trunk groups, where and as available. These parameters include Automatic Number Identification ("ANI"), Calling Party Number ("CPN"), Privacy Indicator, calling party category information, originating line information, charge number, etc. Also included are all parameters relating to network signaling information, such as Carrier Information Parameter ("CIP"), wherever such information is needed for call routing or billing. GTE will provide SS7 via GR-394-SS7 and/or GR-317-SS7 format(s).

  • Configuration Management The Contractor shall maintain a configuration management program, which shall provide for the administrative and functional systems necessary for configuration identification, control, status accounting and reporting, to ensure configuration identity with the UCEU and associated cables produced by the Contractor. The Contractor shall maintain a Contractor approved Configuration Management Plan that complies with ANSI/EIA-649 2011. Notwithstanding ANSI/EIA-649 2011, the Contractor’s configuration management program shall comply with the VLS Configuration Management Plans, TL130-AD-PLN-010-VLS, and shall comply with the following:

  • Reporting of Metered Data and Parameters 7.2.1 The grid connected Solar PV power plants will install necessary equipment for regular monitoring of solar irradiance (including GHI, DHI and solar radiation in the module plane), ambient air temperature, wind speed and other weather parameters and simultaneously for monitoring of the electric power (both DC and AC) generated from the Project.

  • Monitoring Services IDT staff shall, using methods that include face-to-face and other contacts with the member, monitor the services a member receives. This monitoring shall ensure that:

  • Measuring DNS parameters Every minute, every DNS probe will make an UDP or TCP “DNS test” to each of the public-­‐DNS registered “IP addresses” of the name servers of the domain name being monitored. If a “DNS test” result is undefined/unanswered, the tested IP will be considered unavailable from that probe until it is time to make a new test.

  • Vehicle Base Specifications Note: The actual vehicle awarded may exceed the minimum specifications stated below. The Authorized User may elect to add additional Options, delete Options, or substitute a vehicle feature that is an Option with another Option. See Contract Section III.6

  • Quality Management System Supplier hereby undertakes, warrants and confirms, and will ensue same for its subcontractors, to remain certified in accordance with ISO 9001 standard or equivalent. At any time during the term of this Agreement, the Supplier shall, if so instructed by ISR, provide evidence of such certifications. In any event, Supplier must notify ISR, in writing, in the event said certification is suspended and/or canceled and/or not continued.

  • Parameters In calculating the MtM Exposure for each Transaction, the following parameters are set on the Transaction Date: ▪ On-Peak Initial Xxxx Xxxxx ▪ Off-Peak/On-Peak Price Ratio ▪ Off-Peak Initial Xxxx Xxxxx ▪ MW-Measure: initial Capacity PLC Per Tranche ▪ On-Peak Estimated Energy Quantity Per MW-Measure for each of the twelve calendar months ▪ Off-Peak Estimated Energy Quantity Per MW-Measure for each of the twelve calendar months ▪ Number of awarded Tranches In calculating the MtM Exposure for each Transaction, the following parameters are set each Trading Day subsequent to the Transaction Date: ▪ On-Peak Forward Price ▪ Off-Peak Forward Price ▪ Current Capacity PLC Per Tranche ▪ On-Peak Estimated Energy Quantity ▪ Off-Peak Estimated Energy Quantity Process to Update the On-Peak Initial Mark Prices and Off-Peak Initial Mark Prices on a Daily Basis On each Trading Day subsequent to the Transaction Date, the Pricing Agent will contact four Reference Market-Makers to obtain price quotes for on-peak and off-peak energy for PJM Western Hub. The Pricing Agent may not rely upon quotes from Seller or any Affiliate of Seller. The updated mark for a month will be equal to the average mark for that month over all sources from which a quote is available. If a monthly quote is available from any source, only the monthly quote or monthly quotes shall be used. Where quotes provide a bid and ask, the average shall be used. Where a quote for an individual month is unavailable, but the month is quoted as part of a “packaged” quote (e.g., January 2011 is only available in the form of a January/February 2011 “packaged” quote or an annual quote): ▪ If the other month/months of the package quote is/are also unavailable, then the marks for all months of the package will be calculated by multiplying the packaged quote by the ratio of the corresponding month to the corresponding calculated package quote from the previous day. Example: There are no On-Peak quotes available on day X during the contract for July 2011 or August 2011. However, there is an On-Peak July/August 2011 packaged quote of $73.00/MWh available. The On-Peak marks from day X-1 for July 2011 and August 2011 were $73.50/MWh and $76.50/MWh respectively. The day X On-Peak mark for July 2011 is set at 73.00 * [73.50] / [( (73.50 * 352) + (76.50 * 336) ) / (352+336) ] = 73 * (73.50/ 74.97) = $71.57/MWh. The day X On-Peak mark for August 2011 is set at 73.00 * [76.50] / [( (73.50 * 352) + (76.50*336) ) / (352+336) ] = 73 * (76.50 / 74.97) = $74.49/MWh. ▪ If the other month/months of the package quote is/are available, then the mark for the month will be set such that the average of the month and the other month(s) (weighted for either the On-Peak Hours or Off-Peak Hours as applicable) equals the packaged quote (see calculation example below).

  • Configuration The configuration for the Purchase Right Aircraft will be the Detail Specification for Model 767-3S2F aircraft at the revision level in effect at the time of the Supplemental Agreement. Such Detail Specification will be revised to include (i) changes required to obtain required regulatory certificates and (ii) other changes as mutually agreed upon by Boeing and Customer.

Time is Money Join Law Insider Premium to draft better contracts faster.