Metering and Measurement. Customer and APG&E accept the quantity, quality, and measurement determined by Utility providing delivery service to Service Location, for purposes of accounting for electricity supplied under this Agreement, in accordance with the terms of the applicable tariff for retail delivery service.
Metering and Measurement. Customer and IHPS accept the quantity, quality, and measurement determined by Utility providing delivery service to Service Location, for purposes of accounting for electricity supplied under this Agreement, in accordance with the terms of the applicable tariff for retail delivery service.
Metering and Measurement. (a) The Suppliers shall establish and maintain adequate and reliable metering and measuring facilities necessary to monitor the Suppliers’ compliance with their Power and Energy storage, generation and transmission obligations pursuant to this Agreement. Such metering and measuring facilities, including, without limitation, the choice of technical devices and their final set-up and installation, shall be acceptable to all Suppliers.
Metering and Measurement. Company will meter the electrical power (demand and energy) delivered to Customer at the point of delivery. In addition, the parties agree to the following testing and corrective procedures:
Metering and Measurement. Developer shall install and maintain the equipment necessary to measure the MMbtu value and flow of Landfill Gas made available by Republic to Developer at the Delivery Point and the MMbtu value and flow of Biomethane generated from the Developer Facility. The delivery of Landfill Gas and the production of Biomethane shall be measured in MMbtus utilizing the following main components provided and maintained at the sole cost and expense of Developer, with the specific metering devices being subject to the reasonable approval of Republic: [***]. Such equipment must be installed and operated, and gas measurement computations must be made, in accordance with current industry standards and good engineering practices, and shall be located as close to the Delivery Point of the Landfill Gas and the Sales Point of the Biomethane as reasonably practicable. Republic may, at its option and expense, install and operate meters, instruments, and other equipment to verify the accuracy of Developer’s measuring equipment, but such equipment must not interfere materially with the operation of Developer’s measuring equipment or the Developer Facility. The check equipment installed by Republic, if any, is subject at all reasonable times to inspection or examination by Developer, but the calibration and adjustment thereof may be performed only by employees or agents of Republic. Notwithstanding Republic’s right to install its own check equipment, the measurement of Landfill Gas and/or Biomethane for the purposes of this Agreement will be performed only by Developer’s measuring equipment. Developer, at its sole cost and expense, shall keep the metering equipment of Developer accurate and in repair, making a minimum of one (1) test each six (6) months during the term of this Agreement. Each party shall have the right to have its representatives and agents present at any installing, reading, cleaning, changing, repairing, inspecting, testing, calibrating, or adjusting done in connection with the metering equipment used for measuring Landfill Gas and Biomethane hereunder. Developer shall give Republic at least three (3) business days advance notice of any such activities so that Republic may have its representative(s) present; provided, however, that if Developer gives such notice and a representative of Republic is not present at the time specified, Developer may proceed. Tests to verify the accuracy of measuring equipment shall be performed by the manufacturer of the equipment, o...
Metering and Measurement. Buyer shall install and maintain the equipment necessary to measure the volume of the Landfill Gas delivered by Seller to Buyer at the Delivery Point, as well as any other information with respect to the Landfill Gas that Seller is required by Applicable Law to capture, monitor or report.
Metering and Measurement. The Gas received at the Delivery Point will be metered and measured by Transporter. The volume and heating value of the Gas delivered hereunder shall be determined by Transporter in accordance with its established practices and procedures and all payments hereunder shall be based thereon.
Metering and Measurement. (A) Power and energy shall be metered by the Authority at, or as if at, each Delivery Point.
Metering and Measurement. Matters relating to metering and measurement of Gas received into Gatherer’s Systems shall be governed by the applicable terms of the Gathering Agreement and the applicable provisions of any Third Person Gathering Contracts. Matters relating to metering and measurement of Gas delivered from Gatherer’s Systems into the Downstream Pipelines shall be governed by the applicable terms of the Gathering Agreement and the interconnect agreements between GMX (or any of its Affiliates) and the Downstream Pipelines (the “Interconnect Agreements”). Operator agrees to exercise commercially reasonable efforts to ensure that the provisions of the Interconnect Agreements relating to Gas metering and measurement are properly applied and enforced.
Metering and Measurement. 10.01 The unit of measurement of the gas shall be one dekatherm of gas. The gas delivered hereunder shall be measured and metered by the initial Transporter at Seller's sources of gas in accordance with the provisions, specifications and standards set forth in said Transporter's tariff. Each party shall preserve or cause to be preserved for at least one (1) year all test data, charts, allocation statements and other similar records available to it, unless a longer period is prescribed by applicable regulation.
