Meter Installation and Testing Sample Clauses

Meter Installation and Testing. Seller shall cause the installation, maintenance, operation and replacement (as needed) of a meter to be used as the Electric Revenue Meter and back-up meters, in accordance with the Transmission Provider’s metering protocols, at the Electrical Delivery Point to determine the amount of the Energy produced by the Units and delivered to the Electrical Delivery Point, [and the Gas Meter and back-up meters, in accordance with the requirements of the interconnecting pipeline, at the Gas Delivery Point, to determine the amount of Gas delivered to the Gas Delivery Point, in each case] at its sole cost and expense. To the extent necessary to isolate data related to each Unit, Seller shall cause the installation, maintenance, operation and replacement (as needed) of electrical [and/or Gas] submeters, at its sole cost and expense; provided that each such submeter shall be of revenue quality and sufficient for the purposes of providing the data contemplated by this Agreement. Each [Gas Meter and] Electric Revenue Meter shall be locked or sealed only by, and the lock or seal shall be broken only by, the interconnecting utility or Transmission Provider, as applicable. All of the submeters will be locked or sealed by both Parties, which locks or seals will only be broken by both Parties for inspection, testing or adjustment. The meters shall meet all specifications of the Transmission Provider [or interconnecting Gas pipeline, as applicable], and all meters and submeters shall be tested annually by Seller, who shall provide Buyer with not less than 14 days prior Notice of such tests. Testing procedures and standards for submeters shall be the same as for a comparable utility-owned meter. Buyer will have the right to have a representative present during such tests. [For facilities other than Gas-fired facilities, omit the bracketed language].
Sample 1Sample 2Sample 3See All (11)
AutoNDA by SimpleDocs
Meter Installation and Testing. Every consumer shall provide a suitable and accessible place where a meter can be installed, and the city shall install and maintain same. If the consumer desires to have the meter tested for accuracy, the same shall be done by the city, and a fee of $1 charged to the customer if the meter registers 98% or more accurate. If the meter registers less than 98% accurate, it shall be replaced, and repaired before installation on another service.
Sample 1
Meter Installation and Testing. Seller shall, at its sole expense, cause the installation, maintenance, operation and replacement (as needed) of a meter to be used as the Electric Revenue Meter and back-up meters, in accordance with the Transmission Provider’s metering protocols, at the Electrical Delivery Point to measure the Delivered Discharge Energy, the Charging Energy, and, as applicable, Integral Station Use. Each Electric Revenue Meter shall be locked or sealed only by, and the lock or seal shall be broken only by, the interconnecting utility or Transmission Provider, as applicable. The meters shall meet all specifications of the Transmission Provider, as applicable, and all meters and submeters shall be tested annually by Seller, who shall provide Buyer with not less than fourteen (14) days prior Notice of any tests, inspection, or adjustment of a meter or submeter. Testing procedures and standards for submeters will be the same as for a comparable utility-owned meter. Buyer will have the right to have a representative present during such tests, inspections, or adjustments. Whether or not Buyer elects to observe such tests, inspections or adjustments, Seller will provide Buyer with details of the results, including an as-found and as-left calibration certificate.
Sample 1

Related to Meter Installation and Testing

  • Delivery & Installation a) Subject to the conditions of the contract, the delivery of the goods and completion of the related services shall be in accordance with the delivery and completion schedule specified in the bidding document. The details of supply/ shipping and other documents to be furnished by the successful/ selected bidder are specified in the bidding document and/ or contract.

  • Installation, Maintenance, Testing and Repair Unless otherwise agreed in writing by the Parties, to the extent required by Applicable Law, Interconnection provided by a Party shall be equal in quality to that provided by such Party to itself, any subsidiary, affiliates or third party. If either Party is unable to fulfill its obligations under this Section 14.2, it shall notify the other Party of its inability to do so and will negotiate alternative intervals in good faith. The Parties agree that to the extent required by Applicable Law, the standards to be used by a Party for isolating and clearing any disconnections and/or other outages or troubles shall be at parity with standards used by such Party with respect to itself, any subsidiary, affiliate or third party.

  • Installation and Use You may install and use the Software only for the number of licenses acquired by you. In order to exercise your rights to the Software under this Agreement, you must activate your copy of the Software in the manner described during the launch sequence.

  • Maintenance and Testing 54.5.1. Sprint is only responsible for maintaining the facilities that it owns.

  • Inspection and Testing Each Constructing Entity shall cause inspection and testing of the Interconnection Facilities that it constructs in accordance with the provisions of this section. The Construction Parties acknowledge and agree that inspection and testing of facilities may be undertaken as facilities are completed and need not await completion of all of the facilities that a Constructing Entity is building.

  • INSTALLATION AND REMOVAL Show Management reserves the right to fix the time for the installation of a booth prior to the Show opening and for its removal after the conclusion of the Show. Installation of all exhibits must be fully completed by the opening time of the exposition. Any space not claimed and occupied three hours prior to opening, may be resold or reassigned without refund. No exhibitor will be allowed to dismantle or repack any part of his exhibit until after the closing of the Show. 6.

  • Installation and Maintenance Except for the bi‐directional and production metering equipment owned by the City, all equipment on Customer’s side of the delivery point, including the required disconnect device, shall be provided and maintained in satisfactory operating condition by Customer and shall remain the property and responsibility of the Customer. The City will bear no responsibility for the installation or maintenance of Customer’s equipment or for any damage to property as a result of any failure or malfunction thereof. The City shall not be liable, directly or indirectly for permitting or continuing to allow the interconnection of the Facility or for the acts or omissions of Customer or the failure or malfunction of any equipment of Customer that causes loss or injury, including death, to any party.

  • Installation, Inspection, and Maintenance The Contractor is responsible for installation and maintenance of the BMPs as a part of its Bid. The Design Professional shall obtain the services of a qualified testing laboratory to inspect the BMPs in accordance with the permits, the costs of such inspections to be borne by the Owner. In the event of Abnormal Weather Conditions or force majeure, the Contractor shall be compensated for re-installation of BMPs at established Unit Prices.

  • Installation Waiver Company will waive the one-time installation charges associated with the implementation of Services within the 48 contiguous States of the U.S. provided under this Agreement except for the following services: (i) eDSL, (ii) VPN, (iii) Internet Dedicated OC3, OC12, OC48, Gig-E, (iv) PTT / third party services (including International Access and Company International), (v) Data Center, (vi) Paging, (vii) Managed Services, (viii) CPE, (ix) Enhanced Call Routing, (x) Local Disaster Recovery, (xi) Audio, Video and Net Conferencing, (xii) Voice over IP Services, (xiii) Security Services, (xiv) Non-Listing/Non-Published Service, (xv) Telecommunications Service Priority, and (xvi) Services provided by Company incumbent local exchange carriers (“ILECs”) or by Cellco Partnership and its affiliates d/b/a Company Wireless. Usage charges, monthly recurring charges, expedite charges, change charges, surcharges, charges for an unlisted or non-published number, any charges imposed by third parties (including access, egress, jack, or wiring charges), taxes or tax-like surcharges, or other Governmental Charges will not be waived.

  • Maintenance, Alteration and Repair (a) Resident is responsible for and agrees to take good care of the premises, fixtures and all common areas. Resident may not remove any of Owner’s property and will not perform any repairs, upgrades, painting, wallpapering, electric changes or other alterations of the premises without prior written consent from Owner. Resident will be responsible for damage from waste stoppages caused by foreign or improper objects or improper use in lines serving bathrooms, damage to fixtures, appliances, doors, windows, screens, damage from water faucets left on or from doors left open, and repairs or replacements to alarm devices necessitated by misuse or damage by Resident and/or guests. Extraordinary appliances or furnishings such as satellite dishes, hot tubs, pool tables, water beds or high utility-consuming devices may not be installed or placed on the premises or anywhere at the Property without Owner’s prior written consent, in its sole discretion. SAMPLE

Time is Money Join Law Insider Premium to draft better contracts faster.