Meeting A copy of the decision shall be sent to the grievant and to the UFF grievance representative if the grievant elected self-representation or representation by legal counsel.
Meeting of Committee In the event of either party wishing to call a meeting of the Committee, the meeting shall be held at a time and place fixed by mutual agreement, however, such meeting to be held not later than 14 days after request has been received unless varied by mutual agreement.
Meeting Agenda 6.1 The Co-chairpersons will prepare an agenda and forward a copy of the agenda to all Joint Committee members at least one week in advance of the meeting (sample attached).
Informal Meeting Before a formal hearing is conducted the University President or designee shall call a meeting with the charging party, the accused Bargaining Unit Faculty Member, and a representative of the AAUP-WSU. The purpose of this meeting shall be to attempt resolution of the matter through informal discussion. Additional meetings may occur provided the University President or designee and the Bargaining Unit Faculty Member being charged believe that further meetings will serve a useful purpose.
Final Meeting The goal of this subtask is to complete the closeout of this Agreement. The Recipient shall: • Meet with Energy Commission staff to present project findings, conclusions, and recommendations. The final meeting must be completed during the closeout of this Agreement. This meeting will be attended by the Recipient and CAM, at a minimum. The meeting may occur in person or by electronic conferencing (e.g., WebEx), with approval of the CAM. The technical and administrative aspects of Agreement closeout will be discussed at the meeting, which may be divided into two separate meetings at the CAM’s discretion. o The technical portion of the meeting will involve the presentation of findings, conclusions, and recommended next steps (if any) for the Agreement. The CAM will determine the appropriate meeting participants. o The administrative portion of the meeting will involve a discussion with the CAM and the CAO of the following Agreement closeout items: Disposition of any state-owned equipment. Need to file a Uniform Commercial Code Financing Statement (Form UCC-1) regarding the Energy Commission’s interest in patented technology. The Energy Commission’s request for specific “generated” data (not already provided in Agreement products). Need to document the Recipient’s disclosure of “subject inventions” developed under the Agreement. “Surviving” Agreement provisions such as repayment provisions and confidential products. Final invoicing and release of retention. • Prepare a Final Meeting Agreement Summary that documents any agreement made between the Recipient and Commission staff during the meeting.
Required Meetings or Hearings Whenever any employee is required to appear before the Superintendent or his designee, Board or any committee, member, representative or agent thereof concerning any matter which could adversely affect the continuation of that employee in his office, position, or employment or the salary of any increments pertaining thereto, then he shall be given prior written notice of the reasons for such meetings or interview and shall be entitled to have a representative of the Association present to advise him and represent him during such meetings or interview.
Review Meeting i. Either the BCTF or BCPSEA may request in writing a meeting to review the issues in a provincial matters grievance that has been referred to arbitration.
Informal Meetings The Engineer shall provide technical assistance, preparation of exhibits for, and minutes of informal meetings requested by the public to discuss the pending impacts to neighborhoods and businesses due to roadway shutdowns, detours and access restrictions or as deemed necessary. This is not to be confused with the formal public meetings held during the National Environmental Policy Act (NEPA) process during schematic approval for Public Involvement. It is not anticipated that the Engineer’s participation will be needed for the NEPA process. Assistance (exhibits, attendance, etc.) may be required for a formal public meeting/hearing associated with schematic approval work.
Meeting Attendance The Contractor shall attend such meetings of the Town relative to the Scope of Work set forth in Exhibit A as may be requested by the Town. Any requirement made by the named representatives of the Town shall be given with reasonable notice to the Contractor so that a representative may attend.
Professional Meetings Employees should be encouraged to and may, with the approval of the supervisor, attend professional meetings, conferences, and activities. Subject to the availability of funds, the employee's expenses in connection with such meetings, conferences, or activities shall be reimbursed in accordance with the applicable provisions of State law and university rules.
